SCR1 SDK. Terasic DE10 Lite Edition. Quick Start Guide De10lite En

• SCR1 SDK. Terasic DE10-Lite Edition. Quick Start Guide
• Table of Contents
• Revision History
• 1. Setup equipment
• 2. SDK HW assembly
  • 2.1. Connecting serial console
  • 2.2. Pins assignment
    • 2.2.1. UART pins (TTL-232R-3V3)
    • 2.2.2. JTAG pins (Olimex ARM-USB-OCD-H)
• 3. DE10-Lite flash image update
  • 3.1. Required equpment
  • 3.2. Update procedure steps
• 4. Resetting the board:
• 5. UART connection settings
• 6. Using UART terminal
  • 6.1. Load binary images to the Memory address
  • 6.2. Example: Dhrystone run from TCM memory
• 7. Using OpenOCD
  • 7.1. Starting the OpenOCD
  • 7.2. OpenOCD: loading and running BIN and ELF images
• 8. Building SDK FPGA-project for the DE10-Lite board
  • 8.1. General structure of the SDK project
  • 8.2. Additional requirements for compilation
  • 8.3. Building SDK FPGA project
    • 8.3.1. FPGA firmware generation (pof-format)
    • 8.3.2. SDK-specific pins assignment in FPGA-project
  • 8.4. SCR1 SDK FPGA-project functional description
    • 8.4.1. Common project structure
    • 8.4.2. Qsys SoC module structure
    • 8.4.3. Description of the blocks used in the SDK project
      • 8.4.3.1. SCR1-core
      • 8.4.3.2. AHB-Avalon bridge
      • 8.4.3.3. Opencores UART 16550 IP
    • 8.4.4. Description of the IP-components of the module Qsys SOC
      • 8.4.4.1. BUILD ID
      • 8.4.4.2. Onchip RAM
      • 8.4.4.3. PIO HEX
      • 8.4.4.4. PIO LED
      • 8.4.4.5. PIO SW
      • 8.4.4.6. SDRAM
      • 8.4.4.7. UART Bridge
      • 8.4.4.8. Qsys Default slave
• 9. Appendix A. SDK Memory Map
• 10. Appendix B. SDK IRQs
• 11. Appendix C. Software build instructions
  • 11.1. SCR bootloader
    • 11.1.1. Getting the sources
    • 11.1.2. Building SCR bootloader
  • 11.2. Zephyr OS
    • 11.2.1. Getting the sources
    • 11.2.2. Building Zephyr OS
  • 11.3. SCR1 OpenOCD
    • 11.3.1. Getting the latest release
    • 11.3.2. Getting the sources
    • 11.3.3. Building and using OpenOCD
    • 11.3.4. Windows - USB JTAG Cable drivers installation