FXT 5000 Series Field Service Guide 2018 04

• Introduction
  • Precaution Statements Used in this Document
• Precautions for Product Service and Use
  • Unpacking and Handling FXT Equipment
  • Restricted Access
  • Preventing Condensation
  • Electrical Considerations
    • Electrical Code Compliance
    • Earth Grounding
    • AC Mains Disconnect
    • Power Supply Replacement
    • Hazardous Energy Levels
  • Racked FXT 5000 Series Nodes
  • General Precautions
    • Service Area Clearance
    • California Perchlorate Warning
    • Two-Person Lift
    • CMOS Battery Replacement
  • Laser Radiation
  • Thermal Considerations
  • Electrostatic Discharge (ESD) Precautions
• FXT 5000 Series Edge Filer Overview
  • Field-Replaceable Units
  • Attaching a Console to an FXT 5000 Series Node
  • FXT 5000 Series Front and Rear Illustrations
    • FXT 5200 Front Illustration
    • FXT 5400 Front Illustration
    • FXT 5600 Front Illustration
    • Rear View of the FXT 5000 Series Models
  • Controls and LED Status Lights
    • Control Panel Buttons
    • FXT 5000 Series Front Panel LEDs
    • FXT 5000 Series Rear Panel LEDs
• Replacing Power Supply Units
  • Detecting a Failed Power Supply Unit
  • Replacing a Failed Power Supply Unit
• Replacing Failed Drives
  • Identifying a Failed Data or System Drive
  • Replacing A Failed Data Drive
    • Automatic Drive Failover
    • Data Drive Removal and Replacement
    • Reformatting the Node To Use the New Drive
  • Replacing A Failed System Drive
    • Replacing a Single System Drive
    • Replacing Both System Drives
• Replacing SFP+ Modules
  • Accessing SFP+ Modules
  • Removing an SFP+ Module
  • Installing an SFP+ Module
• Replacing a Complete FXT 5000 Series Node
  • About Replacement Nodes
  • Removing a Failed Node
  • Installing a Replacement Node
• Racking and Unracking an FXT 5000 Series Node
  • Precautions
    • FXT 5000 Series Differences from other Avere FXT Nodes
  • Removing the Node from the Cluster Configuration
    • Removing the Node from the Cluster
    • Adding the Node to the Cluster
  • Removing an FXT 5000 Series Node from a Rack
    • Extending the FXT 5000 Series Node
    • Removing the Node from the Rails
  • Installing an FXT 5000 Series Node in a Rack
    • Placing the Node in the Rack
  • Installing and Removing the Front Bezel
• Contacting Avere Global Services
• Copyright and Trademark Information
  • Copyright Information
  • Trademark Information
  • Revision History