Manual
User Manual:
Open the PDF directly: View PDF
Page Count: 103 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Einleitung
- Installation
- Erste Schritte
- Experimente
- Lampen-Zeitschaltung
- Not-Aus
- Pulsweitenmodulation
- Schrittmotoransteuerung
- Servomotoransteuerung
- Die Eingänge des ftDuino
- Temperaturmessung
- Ausgänge an, aus oder nichts davon?
- Aktive Motorbremse
- USB-Tastatur
- USB-GamePad
- Entprellen
- Nutzung des I2C-Bus
- WS2812B-Vollfarb-Leuchtdioden
- Musik aus dem ftDuino
- Der ftDuino als MIDI-Instrument
- Modelle
- Community-Projekte
- Bibliotheken
- FtduinoSimple
- Ftduino
- Die Eingänge I1 bis I8
- void input_set_mode(uint8_t ch, uint8_t mode)
- uint16_t input_get(uint8_t ch)
- Die Ausgänge O1 bis O8 und M1 bis M4
- void output_set(uint8_t port, uint8_t mode, uint8_t pwm)
- void motor_set(uint8_t port, uint8_t mode, uint8_t pwm)
- void motor_counter(uint8_t port, uint8_t mode, uint8_t pwm, uint16_t counter)
- bool motor_counter_active(uint8_t port)
- void motor_counter_set_brake(uint8_t port, bool on)
- Die Zählereingänge C1 bis C4
- void counter_set_mode(uint8_t ch, uint8_t mode)
- uint16_t counter_get(uint8_t ch)
- void counter_clear(uint8_t ch)
- bool counter_get_state(uint8_t ch)
- void ultrasonic_enable(bool ena)
- int16_t ultrasonic_get()
- Selbstbau
- Schaltplan
- Platinenlayout
- Bestückungsplan
- Maße
- Gehäuse