Ug195 Brd4502a User Guide

• Table of Contents
• 1. Introduction
  • 1.1 Radio Boards
  • 1.2 Ordering Information
  • 1.3 Getting Started
• 2. Hardware Overview
  • 2.1 Hardware Layout
  • 2.2 Block Diagram
• 3. Connectors
  • 3.1 J-Link USB Connector
  • 3.2 Ethernet Connector
  • 3.3 Breakout Pads
  • 3.4 Expansion Header
    • 3.4.1 Expansion Header Pin-out
  • 3.5 Debug Connector
  • 3.6 Simplicity Connector
  • 3.7 Debug Adapter
• 4. Power Supply and Reset
  • 4.1 Radio Board Power Selection
  • 4.2 Board Controller Power
  • 4.3 EZR32 Reset
• 5. Peripherals
  • 5.1 USB Micro-B Connector
  • 5.2 Push Buttons and LEDs
  • 5.3 Memory LCD-TFT Display
  • 5.4 Si7021 Relative Humidity and Temperature Sensor
  • 5.5 Virtual COM Port
    • 5.5.1 Host Interfaces
    • 5.5.2 Serial Configuration
    • 5.5.3 Hardware Handshake
• 6. Board Controller
  • 6.1 Admin Console
    • 6.1.1 Connecting
    • 6.1.2 Built-in Help
    • 6.1.3 Command Examples
  • 6.2 Virtual UART
• 7. Advanced Energy Monitor
  • 7.1 Introduction
  • 7.2 Theory of Operation
  • 7.3 AEM Accuracy and Performance
  • 7.4 Usage
• 8. On-Board Debugger
  • 8.1 Host Interfaces
    • 8.1.1 USB Interface
    • 8.1.2 Ethernet Interface
    • 8.1.3 Serial Number Identification
  • 8.2 Debug Modes
  • 8.3 Debugging During Battery Operation
• 9. Kit Configuration and Upgrades
  • 9.1 Firmware Upgrades
• 10. Schematics, Assembly Drawings, and BOM
• 11. Kit Revision History
  • 11.1 SLWRB4502A Revision History
  • 11.2 SLWSTK6200A Revision History
• 12. Document Revision History