Dogtra IW-500 StarWalk User Manual 140514 StarWalk manual usa

Dogtra Co., Ltd. StarWalk 140514 StarWalk manual usa

User manual

PairingChargingUse the USB charging cable to charge the StarWalk from a USB power source. The StarWalk will flash green when charging is complete. The StarWalk will flash red when it needs to be charged and while it is plugged into the charger.On: To turn on the StarWalk, hold down the MultiButton for 3 seconds until the StarLight flashes in white. Off: To turn off the StarWalk, hold down the Multibutton for 3 seconds until the StarLight flashes in red.On/OffiQ StarWalk 1iQ StarWalk 2iQ StarWalk 3iQ StarWalk 4iQ StarWalk 51. Turn the StarWalk off.2. Log into the StarWalk smart phone application and complete your dog profile. 3. Click Device > Pairing the StarWalk > Search, in the app.4. Hold down the MultiButton on the StarWalk until you see the completed message on the app.2) Search + Push3) Pairing OK3) Retry1) StarWalk OffParts and AccessoriesStarLightStepLight MultiButtonUSB Charging PortOPERATIONCONTENTSUSB Charging CableAttachment BeltAttachment BracketAttentionCharge the StarWalk fully before your first use. A full charge takes about 2 hours. The StarWalk will need to be re-synchronized after charging from a state of full discharge. The connection range between the StarWalk and your smart phone is 10 meters.The StarWalk is waterproof up to IPX7, but for maximum reliability, dry thoroughly after contact with water or if fully submerged. Close the USB charging port cover securely over the charging port while the StarWalk is in use.Rinse the StarWalk lightly with fresh water if the device comes in contact with saltwater.To pair the StarWalk with your smart phone, start with the StarWalk device turned off.
by Dogtra Company Copyright ⓒ 2014 Dogtra Company All Rights Reserved. (1)22912 Lockness Avenue, Torrance, CA 90501 U.S.A.Tel: 310-534-0101 / Fax: 310-534-9111Toll free: 888-811-9111 / Email: info@iqpetcollar.comWebsite: www.iqpetcollar.comiQ StarWalk 7iQ StarWalk 8iQ StarWalk 9Warranty and repair informationThe StarWalk comes with a 1-YEAR WARRANTY. The warranty begins from the date of purchase. For the first year, coverage is for Parts, Labor, and Accessories. After the first year, the cost of Parts, Accessories, Labor fees, and Shipping fees incurred are the customers’ responsibility. Labor fees will be variable depending on the extent of the work required.FCC (Federal Communications Commission)This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technical for help. Using the MultiButton ModeGoal ProgressNight WalkIdlenessEvent AlertPress the MultiButton once when the StarWalk is turned on to check your dog’s goal progress. The StepLights will flash for 1 minute with each StepLight representing 20% of your dog’s daily goal. Press the MultiButton again while in Goal Progress to turn on the Night Walk feature. The StarLight will continue to flash to increase the visibility of your dog while walking at night. Press the MultiButton again to turn off the Night Walk feature. Night Walk can also be turned on through the App.When your dog has been idle for 30 minutes, the StepLights will flash rapidly for 1 minute (idle alerts are are turned off during sleep mode, between 12 AM - 6 AM).When a user set event alert goes off, the StarLight will flash red rapidly together with the StepLights for 1 minute. OperationThe StarWalk application is compatible with Android 4.3 and up, and iOS 7.0 and up. For a detailed list of compatible devices, please visit www.iqpetcollar.com/starwalk.WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. This device complies with Part 15 of the FCC`s Rules. Operation is subject to the following two Conditions: 1. This device may not cause harmful interference, and 2. This device must accept ant interference received, including interference that may cause undesirable operation. iQ StarWalk 6Attaching the Belt Bracket1. Align the guideline on the belt as shown and insert it into the attachment bracket.2. Slide the StarWalk into the attachment bracket until you hear a soft click.3. Wrap the bracket belt around your dog’s collar as shown.Owner’s manual

Navigation menu