Domo Tactical Communications NETNODE-5R Mesh NETNode (Rugged)-COFDM Robust IP Mesh Node (Phase5) 2x2W MIMO User Manual Exhibit 08A NETNode IP Mesh Radio Phase 5 Infrastructure Tube

Cobham Surveillance Segensworth Mesh NETNode (Rugged)-COFDM Robust IP Mesh Node (Phase5) 2x2W MIMO Exhibit 08A NETNode IP Mesh Radio Phase 5 Infrastructure Tube

Contents

Exhibit 08A - NETNode IP Mesh Radio Phase 5 Infrastructure (Tube)

www.cobham.com/tcs
Cobham NETNode IP mesh radios are the latest innovations
in the expanding range of Cobham Tactical Communications
and Surveillance solutions.
The Multiple Input/Multiple Output (MIMO) node is the
latest breakthrough in mesh technology from Cobham,
offering multiple transmit and receive antennas,
transmitting extra data on the same frequency by
overlaying two signals in the space of one. This technique
almost doubles the IP throughput and provides twice as
much output power increasing range.
NETNode IP radios can be combined in a fluid self forming,
self healing mesh containing up to sixteen radios. The
NETNode radios within the mesh exchange data on a single
frequency, simplifying frequency management. The Phase
5 unit builds on Cobham’s latest technology development
and algorithmic improvements contained within the unit
resulting in a further reduced noise floor and improved
spectral efficiency. The Phase 5 unit also includes Power
over Ethernet (POE*) and IP control on all units, enabling
the unit to be powered and configured from just one cable.
The unit can also be configured to have the 2x2dBi or
2x4dBi antenna directly mounted, making it ideal for instant
deployment where high data rates are required.
The entire mesh can operate in a selectable bandwidth of
between 2.5 and 10MHz. The NETNode radios employ the
unique Cobham COFDM modulation scheme and therefore
offer excellent RF penetration and performance in the
presence of multipath.
The NETNode mesh radios can provide greater than 25Mb/s
of IP data (data rate depends on mode, number of nodes
and range between nodes). This available bit-rate can be
used to exchange IP data traffic between nodes.
The highly flexible mesh topology means that data can be
exchanged between nodes in a point-to-point or multi-point
fashion; range can be extended by using nodes as
repeaters. The self-forming, self-healing mesh architecture
makes the NETNode product ideal for use in mobile
surveillance applications, command and control applications,
or advanced robotics.
The NETNode can be connected to third party cameras
using the SDI/ HD SDI connectors. AVI options are available
for composite or Pal camera options.
Security of the entire mesh network can be ensured by the
use of the optional AES128 or AES256 encryption.
Control of the deployed mesh is achieved using the inbuilt
web browser or comprehensive Mission Commander PC
application. This software suite, based around a mapping
display, is used to configure and monitor the mesh and
wider Cobham Surveillance systems, and to control its
nodes and cameras. Video can be viewed on the PC device
using the Mission Commander software and recorded using
Milestone Compatible recorders.
NETNode IP Mesh Radio Phase 5
COFDM – Video, Audio Telemetry and IP Products
October 2015 Data Sheet
The most important thing we build is trust
www.cobham.com/tcs
NETNode IP Mesh Radio Phase 5
COFDM – Video, Audio Telemetry and IP Products
October 2015 Data Sheet
Specification:
Interfaces
RF Interfaces
(Antennas 1-4) N-Types (2x TX/RX, 2x RX)
12-18V DC Input 6 – Way Amphenol
18-48V DC Input 3 – Way Amphenol
Ethernet 1 RJ45 Amphenol
Ethernet 2 RJ45 Amphenol
SDI/HD-SDI input 1 75R BNC
SDI/HD-SDI input 2 75R BNC
Config & Data 22 – Way Amphenol
Typical range
DraftXXX Ground – Air Link 65km
RF Interfaces
Antenna A Receive only antenna
Antenna B Switched transmit / Receive antenna
Antenna C Receive only antenna
Antenna D Switched transmit / Receive antenna
RF and modulation
Output frequency 2.00 to 2.50GHz,
Tuning step size 125kHz step
Output power +33dBm per channel in 0.25dB step (4W
total)
Bandwidth 2.5, 3.0, 3.5, 5.0, 6.0, 7.0, 8.0, 10.0MHz
Mesh capacity Up to 25Mb/s (MIMO)
Modulation COFDM 360 carrier modulation
Carrier Modulation BPSK/QPSK/16QAM (adaptive)
FEC rate FEC1/2, FEC2/3 (adaptive)
Receive diversity Maximum Ratio Combining
Receive sensitivity -98dBm (BW 2.5MHz / BPSK ½)
IP interface
Primary and secondary
ethernet electrical 100BaseT Ethernet (with optional POE)
IP address allocation DHCP dynamic IP addressing/Static IP
Streaming
Format UDP Multicast/Unicast
RTSP/RTP/UDP Multicast/Unicast
ONVIF profile S
MJPEG TCP/HTTP
Video
Video Input 2 video streams
Max total throughput of 1920x1080p30
2 HD streams at half resolution or frame rate
Input Format 1920x1080i 60/59.94/50Hz
1920x1080p 30/29.97/25/24/23.97Hz
1920x1080psf 30/29.97/25/24/23.97Hz
1280x720p 60/59.94/50Hz
720x576i 50Hz or 720x480i 59.94Hz
H.264 Compression AVC / H.264 / MPEG-4 Part 10
High profile level 4.0
Coding Options Horizontal scaling of 3/4, 2/3, 1/2, 1/4
Vertical scaling of 1/2, 1/4
Sub-frame rate of 1/2, 1/4, 1/8, 1/24
Encoder Delay 1s to 10ms (mode dependant)
Encoder Bitrates 0.25Mbps to 32Mbps
Audio
Analogue Audio Input High gain microphone stereo pair
Digital Audio Input SD/HD-SDI 2 digital stereo pairs
Sample Rate 16kHz-48kHz
Coding Modes 4 channels stereo or mono
MPEG Audio Layer 1 64-448kbps
MPEG Audio Layer 2 32-384kbps
MPEG Audio Layer 3 8-256kbps
Store and Forward options*
Storage format SD card interface (Secure Digital card)
Record options Continuous or triggered (Milestone)
Files download From web browser interface/RTSP
Video and audio clip size 30 seconds
Encryption
Type AES128 or AES256 (both optional)
Open Audio comms channel (shared voice channel)
Multi-user audio
comms channel Interface microphone level/headphone o/p
Compression G726 32kbit audio 8KHz sampling and mute
Encryption
Type AES128 or AES256 (both optional)
GPS
Dedicated GPS interface RS232/RS485
Data interface
RS232/RS485 data input 1K2 to 115K2 baud switchable
(shared with user camera With UDP and TCP routing protocol
control)
PTZ camera interface (with AVI fitted)
User camera type PAL or NTSC
User camera control From Mesh Commander PC application using
VISCA, PELCOD or PELCOP
From any user supplied desk controller
Requires RS232/RS485 interface
Triggers*
Trigger source Third party equipment remote trigger (e.g. PIR
etc)
User pre-set time trigger
Video motion detection (NETAV option)*
Audio level*
Trigger action Start to transmit (silence mode)
Activate video stream (NETAV option)
Activate audio stream (NETAV option)
Move camera to preset position
Activate local store feature
Control
Local control LEDs power and mesh status
Remote control Mission Commander PC application
Full control of all parameters in a map based
application
Web Browser control
Physical
Sealing IP66 Minimum
Dimensions H 125mm, W 125mm, D 205 (245) mm
(including connectors)
Mounting options base unit Tripod mount and captive hole screws
Weight 3.46kg
Power
DC input (12V) 8-16V
DC input (48V) 20 – 48V
PoE x 2 50V(nominal) adapter dependant.
Power consumed (non-MIMO) 12W approx
Power consumed (MIMO) 25W (40W pk) approx.
Environment
Temperature range -10 to 50 deg C
Product Code:
Pinouts:
12V DC Input Pin 1 = 12V
38999 6-Way
Pin 2 = 12V
The information contained in this document is the property of Cobham Tactical Communications and Surveillance. This document and the information contained
herein is provided for evaluation purposes only and is subject to change without notice. Cobham Tactical Communications and Surveillance assumes no
responsibility for errors that might appear in this document and gives no representations or warranties as to the accuracy of the information contained herein,
including but not limited to the suitability and performances of the product or its intended application. © Copyright Cobham TCS limited 2012, All Rights Reserved
Singapore Sales Office
21 Media Circle
Infinite Studios #06-04
Singapore 138562
Singapore
T: +65 6515 8806
Brazil Sales Office
Av. das Nações Unidas
12551- 17ºandar - Sala 1725
04578-903
São Paulo
T: +55 11 3443 7545
Cobham Tactical Communications
and Surveillance International
Fusion 2,1100 Parkway
Whiteley, Hampshire
PO15 7AB, UK
T: +44 1489 566 750
www.cobham.com/tcs
NETNode IP Mesh Radio Phase 5
COFDM – Video, Audio Telemetry and IP Products
October 2015 Data Sheet
Pin 3 = 12V
Pin 4 = GND
Pin 5 = GND
Pin 6 = GND
48V DC Input Pin 1 = 48V
38999 3-Way
Pin 2 =
Pin 3 = GND
Ethernet 1 – RJ45 Pin 1 = MDIP0
Pin 2 = MDIN0
Pin 3 = MDIP1
Pin 4 = MDIP2
Pin 5 = MDIN2
Pin 6 = MDIN1
Pin 7 = MDIP3
Pin 8 = MDIN3
Ethernet 2 – RJ45 Pin 1 = MDIP0
Pin 2 = MDIN0
Pin 3 = MDIP1
Pin 4 = MDIP2
Pin 5 = MDIN2
Pin 6 = MDIN1
Pin 7 = MDIP3
Pin 8 = MDIN3
SDI/HD-SDI Video 1 75R BNC
SDI/HD-SDI Video 2 75R BNC
Configuration & Data Pin 1 = 12V SW Out
Pin 2 = GND
Pin 3 = RS232 RX CTRL
Pin 4 = RS232 TX CTRL
Pin 5 = RS485 TX+
Pin 6 = RS485 TX-
Pin 7 = GND
Pin 8 = RS485 RX+
Pin 9 = RS485 RX-
Pin 10 =
Pin 11 =
Pin 12 =
Pin 13 =
Pin 14 =
Pin 15 =
Pin 16 =
Pin 17 = AUD_IN R
Pin 18 = AUD_IN L
Pin 19 = GND
Pin 20 = AUD_OUT R
Pin 21 = AUD_OUT L
Pin 22 = GND
Licensing Options:
AES128NN 128bit AES Encryption
AES256NN 256bit AES Encryption
Note:
AES may be subject to export control
Photographs:
Unit with 2 x 2dbi directly coupled
Products are available to security users in licensed frequency bands.
Encryption licences are subject to export control. These products are not
approved for use by unlicensed users. Commercial products are available if
used in appropriate licensed frequency bands.

Navigation menu