Dongguan Siyoto Electronics BW07 BW BT OVER-EAR ANC HP User Manual BWA18AA007
Dongguan Siyoto Electronics Co., Ltd. BW BT OVER-EAR ANC HP BWA18AA007
User manual
Blackweb Manual Package Contents Charging Time
Blackweb Manual
RRRR
03h:30m
RRLL
Product Information
1)Product Name: BW BT OVER-EAR ANC HP;
2)Model: BWA18AA007;
3)Rated Power Input: 20mW (0.8V);
4)Maximum Input Power: 30mW (0.97V);
5)Loudspeaker Diameter: Ø40;
6)Speaker Impedance: 32±15%Ω ;
7)Sensitivity: 95±3dB with IEC 60711 ;
8)Charging Cable: 0.5M;
9)Audio Cable: 1.3M .
Answering, Switch to
Handset Audio
Press & Hold
Answer
X1 Tap X1 Tap
Music Gesture Controls Phone Gesture Controls
Hangup
Play/Pause
X1 Tap
Siri/Google Assitant
Press & Hold
Incoming call,
Do Not Answer
Press & Hold
Increase Volume
Swipe Up
Increase Volume
Swipe Up
Decrease Volume
Swipe Down
Decrease Volume
Swipe Down
On/O
,
Active Noise Cancelling
,
Bluetooth
&
Charging
Active Noise
Cancellation Switch Includes Micro-USB
charging cable
Wired Listening
Charging Port
OnOFF
3s3s
3s3s
3s3s
On/O/Bluetooth Pairing
On/O Connect to
Mobile Phone
Press & Hold Press & Hold
2s2s 5s5s
RRRR
Next Track
Swipe Forward
Previous Track
Swipe Backward
Includes audio cable
with control box for wired
listening while Battery low
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.Changes
or modications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
X3 Press X2 PressX1 Press
Previous Track Next Track
X1 Press
Increase Volume
X1 Press
Decrease Volume
Play/Pause
NOISE CANCEL
POWER
IC STATEMENT
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.