Dongguan Xing Yue Electronic XO-9452 Bond Outdoor Waterproof TWS Speakers User Manual
Dongguan Xing Yue Electronic co., Ltd Bond Outdoor Waterproof TWS Speakers
User manual
Bond Outdoor Waterproof TWS Speakers
Instruction Manual
• PowerButton
• Micro-USB ChargingPort
• LED Indicator
• Mic (speakerbase)
What’sincluded:
2 x Speaker
1 x Silicon band
1 x USB to Micro-USB chargingcable
1x audio cable
1 x Instruction Manual
Tech Specifications
• Input: DC5V/500mA
• Paring name : Bond
• Bluetooth version:4.2+EDR
• Battery type:Li-Polymer
• BatteryCapacity:500MAH
•
Instructions:
Pairing the speaker:
Make sure two speakers closed .Put the OPEN/OFF button for 3 seconds , the
blue led is flashed slowly, the two speaker will pair each automatically, onedu
will sound once the 2 speaker paired successfully.
Then Select " Bond " on your device with computer or mobile to pair
Charging thespeaker:
a. Using a regulated USB adapter. Connect a USB cable to a USB adapter.
Usingthe Micro-USB connector, connect the other end of the USB cable to the
charging port onthe speaker. Plug the USB adapter into theoutlet to begin
charging. The LED will light up inred while in charging, turns off when fully
charged.
b. Using your computer. Connect a USB cable to a USB outlet on your computer.
Using the Micro-USB connector, connect the other end of the USB cable to an
charging port on the speaker. Make sure the computer is on to begin charging
the speaker.
Using the speaker:
When receiving a phone call, the speaker will pause the
current audio. Press the Play/Answer button to answer the
call, press this button again to end the call.
Short press : power on/off button
Short press : play/pause the audio
Short press : next track
Long press : volume increase
Short press : previous track
Long press : volume decrease
Press :answer a call
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.