Dongguan Xing Yue Electronic XO-9561 Light up Bluetooth Speaker User Manual

Dongguan Xing Yue Electronic co., Ltd Light up Bluetooth Speaker Users Manual

Users Manual

Light up Bluetooth Speaker
Instruction Manual
Power Button
Micro-USB Charging Port
LED Indicator
Mic (speaker base)
What’s included:
1 xSpeaker
1 x USB to Micro-USB charging cable
1 x Instruction Manual
Tech Specifications
Input: DC 5V/400mA
Paring name : mini SPEAKER
Bluetooth version: 4.2
Battery type: Li-Polymer
Battery Capacity:400MAH
Instructions:
Charging the speaker:
a Using a regulated USB adapter.Connect a USB cable to a USB
adapter.Using the Micro-USB connector, connect the other end of the
USB cable to the charging port on the speaker. Plug the USB adapter
into the outlet to begin charging. The LED will light up in red while in
charging, turns off when fully charged.
b. Using your computer. Connect a USB cable to a USB outlet on your
computer. Using the Micro-USB connector, connect the other end of the
USB cable to an charging port on the speaker. Make sure the computer is
on to begin charging the speaker.
Connecting a Media Device:
One slide button turn speaker ON/OFF.
The Blue LED Indicator will flash to indicate pairing mode.
Select Light Up on your media device.
Single, short press the power button to answer an incoming call.
Single press again to hang up.
Use the mic located on the speaker base during a call.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

Navigation menu