Dynabook UPA3362WL 802.11 b/g Mini-PCI Card. User Manual Attachment

Toshiba Corporation 802.11 b/g Mini-PCI Card. Attachment

Contents

User Manual Attachment

Download: Dynabook UPA3362WL 802.11 b/g Mini-PCI Card. User Manual Attachment
Mirror Download [FCC.gov]Dynabook UPA3362WL 802.11 b/g Mini-PCI Card. User Manual Attachment
Document ID387158
Application IDC+/9OYaurA0AhK7m2HYwbg==
Document DescriptionUser Manual Attachment
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize2.69kB (33685 bits)
Date Submitted2004-01-07 00:00:00
Date Available2004-01-06 00:00:00
Creation Date2003-12-04 16:29:11
Producing SoftwareAcrobat Distiller 5.0 (Windows)
Document Lastmod2003-12-04 16:29:11
Document TitleUser Manual Attachment

Information sheet
Wireless Interoperability
The Intel(R) PRO/Wireless 2200BG Network Connection products are designed to be interoperable with any
wireless LAN product that is based on Direct Sequence Spread Spectrum (DSSS)/Orthogonal Frequency
Division Multiplexing(OFDM) radio technology, and is compliant to:
■ The IEEE 802.11 Standard on Wireless LANs(Revision B/G), as defined and approved by the Institute of
Electrical and Electronics Engineers.
■ The Wireless Fidelity(Wi-Fi) certification as defined by the Wi-Fi Alliance. The “Wi-Fi CERTIFIED” logo is
a certification mark of the Wi-Fi Alliance.
CAUTION
Bluetooth™ and WirelessLAN devices operate within the same radio frequency range and may interfere with
one another. If you use Bluetooth™ and WirelessLAN devices simultaneously, you may occasionally
experience a less than optimal network performance or even lose your network connection.
If you should experience any such problem, immediately turn off either one of your Bluetooth™ or
WirelessLAN.
Please contact Toshiba PC product support on web site
http://www.toshiba-europe.com/computers/tnt/bluetooth.htm in Europe or
http://www.pc.support.global.toshiba.com in the United States for more information.
Wireless LAN and your Health
Wireless LAN products, like other radio devices, emit radio frequency electromagnetic energy. The level of
energy emitted by Wireless LAN devices however is far much less than the electromagnetic energy emitted by
wireless devices like for example mobile phones.
Because Wireless LAN products operate within the guidelines found in radio frequency safety standards and
recommendations, TOSHIBA believes Wireless LAN is safe for use by consumers. These standards and
recommendations reflect the consensus of the scientific community and result from deliberations of panels and
committees of scientists who continually review and interpret the extensive research literature.
In some situations or environments, the use of Wireless LAN may be restricted by the proprietor of the building
or responsible representatives of the organization. These situations may for example include:
■ Using the Wireless LAN equipment on board of airplanes, or
■ In any other environment where the risk of interference to other devices or services is perceived or
identified as harmful.
If you are uncertain of the policy that applies on the use of wireless devices in a specific organization or
environment (e.g. airports), you are encouraged to ask for authorization to use the Wireless LAN device prior to
turning on the equipment.
Regulatory Information
The Intel(R) PRO/Wireless 2200BG Network Connection must be installed and used in strict accordance with
the manufacturer’s instructions as described in the user documentation that comes with the product. This
device complies with the following radio frequency and safety standards.
Canada – Industry Canada (IC)
This device complies with RSS 210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of this device.”
L ‘ utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l’ utilisateur du dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu, même si
ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
The term "IC" before the equipment certification number only signifies that the Industry Canada technical
specifications were met.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
To prevent radio interference to the licensed service, this device is intended to be operated indoors and away
from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is
subject to licensing.
Pour empecher que cet appareil cause du brouillage au service faisant l'objet d'une licence, il doit etre utilize a
l'interieur et devrait etre place loin des fenetres afin de Fournier un ecram de blindage maximal. Si le matriel
(ou son antenne d'emission) est installe a l'exterieur, il doit faire l'objet d'une licence.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC with essential test
suites as per standards:
België/
Belgique:
Deutschland:
France:
Italia:
Nederland
For outdoor usage only channel 10 (2457 MHz) and 11 (2462 MHz) is allowed.
For private usage outside buildings across public grounds over less than 300m no special
registration with IBPT/BIPT is required. Registration to IBPT/BIPT is required for private
usage outside buildings across public grounds over more than 300m. An IBPT/BIPT license is
required for public usage outside building.
For registration and license please contact IBPT/BIPT.
Gebruik buiten gebouw alleen op kanalen 10 (2457 MHz) en 11 (2462 MHz). Voor privégebruik buiten gebouw over publieke groud over afstand kleiner dan 300m geen registratie bij
BIPT/IBPT nodig; voor gebruik over afstand groter dan 300m is wel registratie bij BIPT/IBPT
nodig. Voor publiek gebruik buiten gebouwen is licentie van BIPT/IBPT verplicht. Voor
registratie of licentie kunt u contact opnemen met BIPT.
L’utilisation en extérieur est autorisé sur le canal 10 (2457 MHz) et 11 (2462 MHz).
Dans le cas d’une utilisation privée, à l’extérieur d’un bâtiment, au-dessus d’un espace public,
aucun enregistrement n’est nécessaire pour une distance de moins de 300m. Pour une distance
supérieure à 300m un enregistrement auprès de I’IBPT est requise. Pour une utilisation
publique à I’extérieur de bâtiments, une licence de I’IBPT est requise. Pour les
enregistrements et licences, veuillez contacter I’IBPT.
License required for outdoor installations. Check with reseller for procedure to follow
Anmeldung im Outdoor-Bereich notwendig, aber nicht genehmigungspflichtig.Bitte mit
Händler die Vorgehensweise abstimmen.
Restricted frequency band: only channels 10 and 11 (2457 MHz and 2462 MHz respectively)
may be used in France. License required for every installation, indoor and outdoor
installations. Please contact ART for procedure to follow.
Bande de fréquence restreinte : seuls les canaux 10 à 11 (2457 et 2462 MHz respectivement)
doivent être utilisés en France.
Toute utilisation, qu’elle soit intérieure ou extérieure, est soumise à autorisation. Vous pouvez
contacter I’Autorité de Régulation des Télécommuniations (http://www.art-telecom.fr) pour la
procédure à suivre.
License required for indoor use. Use with outdoor installations not allowed
E’necessaria la concessione ministeriale anche per l’uso interno.
Verificare con i rivenditori la procedura da seguire. L’uso per installazione in esterni non e’
permessa.
License required for outdoor installations. Check with reseller for procedure to follow
Licentie verplicht voor gebruik met buitenantennes. Neem contact op met verkoper voor juiste
procedure
USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
tuning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
TOSHIBA is not responsible for any radio or television interference caused by unauthorized modification of the
devices included with this Intel(R) PRO/Wireless 2200BG Network Connection, or the substitution or
attachment of connecting cables and equipment other than specified by TOSHIBA.
The correction of interference caused by such unauthorized modification, substitution or attachment will be the
responsibility of the user.
Caution: Exposure to Radio Frequency Radiation.
The radiated output power of the Intel(R) PRO/Wireless 2200BG Network Connection is far below the FCC
radio frequency exposure limits. Nevertheless, the Intel(R) PRO/Wireless 2200BG Network Connection shall be
used in such a manner that the potential for human contact during normal operation is minimized. The
antenna(s) used in this device are located at the upper edge of the LCD screen, and this device has been tested
as portable device as defined in Section 2.1093 of FCC rules when the LCD screen is rotated 180 degree and
covered the keyboard area. In addition, Wireless LAN has been tested with Bluetooth transceiver for colocation requirements. This device and its antenna(s) must not be co-located or operating in conjunction with
any other antenna or transmitter. Refer to the Regulatory Statements as identified in the documentation that
comes with those products for additional information.
The installer of this radio equipment must ensure that the antenna is located or pointed such that
it does not emit RF field in excess of Health Canada limits for the general population; consult
Safety Code 6, obtainable from Health Canada’s website www.hc-sc.gc.ca/rpb.
Taiwan
Article 14
Article 17
Unless approved, for any model accredited low power radio frequency electric machinery, any
company, trader or user shall not change the frequency, increase the power or change the features
and functions of the original design.
Any use of low power radio frequency electric machinery shall not affect the aviation safety and
interfere with legal communications. In event that any interference is found, the use of such
electric machinery shall be stopped immediately, and reusing of such products can be resumed
until no interference occurs after improvement.
The legal communications mentioned in the above item refer to radio communications operated in
accordance with telecommunication laws and regulations.
Low power radio frequency electric machinery shall resist against interference from legal
communications or from industrial, scientific and medical radio emission electric machinery.
Using this equipment in Japan
In Japan, the frequency bandwidth of 2,400∼2,483.5MHz for second generation low-power data communication
systems such as this equipment overlaps that of mobile object identification systems (premises radio station
and specified low-power radio station).
1. Sticker
Please put the following sticker on devices incorporating this product.
In the frequency bandwidth of this equipment, industrial device,
scientific device, medical device like microwave oven, licensed
premises radio station and non-licensed specified low-power radio
station for mobile object identification system (RF-ID) that is used in
product line of factories,(Other Radio Stations)are used.
1 Please make sure before using this equipment that no Other Radio
Stations are used in the neighborhood.
2 In case that RF interference occurs to Other Radio Stations from this
equipment, please change promptly the frequency for use, place to
use, or stop emitting Radio.
3 Please contact TOSHIBA Direct PC if you have a problem, such as
interference from this equipment to Other Radio Stations
2. Indication
The indication shown below appears on this equipment.
(1)
(2) (3)
2.4DSOF4
(4)
(1) 2.4:this equipment uses a frequency of 2.4GHz.
(2) DS:This equipment uses DS-SS modulation
OF:This equipment uses OFDM modulation
(3)
4:The interference range of this equipment is less than 40m.
(4)
: This equipment uses a frequency bandwidth from 2,400MHz to 2,483.5MHz.
possible to avoid the band of mobile object identification systems.
3. TOSHIBA Direct PC
Monday – Friday
Toll Free Tel
Direct Dial
Fax
It is
: 10:00 – 17:00
: 0120-13-1100
: 03-3457-5916
: 03-5444-9450
Device Authorization
This device obtains the Technical Regulation Conformity Certification and it belongs to the device class of radio
equipment of low-power data communication system radio station stipulated in the Radio Law of Japan.
The Name of the radio equipment: ********
TELECOM ENGINEERING CENTER
Approval Number : **********, **********
The following restrictions apply:
Do not disassemble or modify the device.
Do not install the embedded wireless module into other device.
Trademark
Bluetooth is a trademark owned by its proprietor and used by TOSHIBA under license.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2003:12:04 16:29:11+09:00
Modify Date                     : 2003:12:04 16:29:11+09:00
Page Count                      : 4
Creation Date                   : 2003:12:04 07:29:11Z
Mod Date                        : 2003:12:04 07:29:11Z
Producer                        : Acrobat Distiller 5.0 (Windows)
Metadata Date                   : 2003:12:04 07:29:11Z
EXIF Metadata provided by EXIF.tools
FCC ID Filing: CJ6UPA3362WL

Navigation menu