Dynabook UPA3374WL Mini PCI 802.11a/b/g transceiver User Manual Palao WLAG 1106 03

Toshiba Corporation Mini PCI 802.11a/b/g transceiver Palao WLAG 1106 03

Contents

User Manual 2

1TOSHIBA Wireless LAN CardInstallationThis sheet provides information on installing the Wireless LAN card in the PORTÉGÉM200.CAUTION: This sheet is for information only. The Wireless LAN card mustbe installed by dealers of TOSHIBA or TOSHIBA OEM products.NOTE: The Wireless LAN card is a wireless network card that complieswith the IEEE 802.11 standard for Wireless LANs (Revision B.)Installing the Wireless LAN card1. Discharge static electricity from your body by touching a metal object, beforeyou handle the card.2. Turn off the power and disconnect the AC adaptor.3. Lay the computer upside down.4. Remove the battery pack from the computer. For instructions on removing thebattery pack, refer to Chapter 6 in the online manual.
25. Remove twenty screws securing computer’s under cover. (One screw is situatedunder the battery pack.)NOTE: Use a point size 0 Phillips screwdriver.Figure 1 Removing twenty screws6. Loosen one screw securing the memory module cover and lift off the cover.Remove the memory module. Refer to Chapter 8 in the online manual for details.7. Loosen one screw securing the HDD cover and lift off the cover.Figure 2 Removing the memory module cover and HDD cover
38. Slide the HDD and remove it.Figure 3 Removing the HDD9. Disconnect the VGA fan cable under the memory module.Figure 4 Removing the VGA fan cable
410. Remove the computer’s under cover.Figure 5 Removing the computer’s under cover11. Remove flat-head two screws and the metal cover.Figure 6 Removing two screws and the metal cover
512. Connect the antenna cables to the proper connectors on the Wireless LAN card.The cables are color coded white and black. Refer to figure 7 to see for whichcolor to goes to which connector.CAUTION: Be careful not to apply pressure to the ICs on the Wireless LANcard.13. Hold the card at about a 45 degree angle, fit it into the computer’s connector andpress carefully to ensure firm contact.14. Gently, push the card down until latches on either side engage the card to hold itin place.Figure 7 Installing the Wireless LAN card15. Route the cable as shown below and secure it with tape.Figure 8 Routing the Wireless LAN cableBLACK WHITE
616. Seat the metal cover on the Wireless LAN card and secure it with flat-head twoscrews.17. Seat the computer’s under cover.18. Connect the VGA fan cable under the memory module.19. Seat the memory module. Refer to Chapter 8 in the online manual for details.20. Seat the memory module cover and secure it with one screw.21. Install the HDD.22. Seat the HDD cover and secure it with one screw.23. Secure twenty screws.24. Turn the computer upside down.Applying labelsThe figure below shows the locations of labels . The letters A, B, C and D correspondto labels identified in later illustrations. The applied labels will vary according to yourcomputer’s configuration.Figure 9 Label positionsBCDA
8 5. Apply the following Singapore Regulatory label to position D. If your computeralready has the Singapore Regulatory label, you do not need to apply a new label.Figure 13 Singapore Regulatory label

Navigation menu