E TECH EM100 FM Transceiver User Manual EM SERIES 1
E-TECH Co., Ltd. FM Transceiver EM SERIES 1
E TECH >
Contents
- 1. User Manual - 1
- 2. User Manual - 2
- 3. User Manual - 3
User Manual - 3
@E-TECH Channel Selector Rotate to select a channel. Turn clockwise to increase the channel and counterclockwise to decrease the channel. Press to select a group if the group is set. Press and hold over 2 seconds to enter into the menu. Microphone Jack Insert the microphone plug into this jack. 5 Key Press the key to activate its programmable lunction The default setting is RF power/Selcall A Key Press the key to activate its programmable lunction The detault setting is Key tone/Menu. 8 Key Press the key to activate its programmable lunaion The default setting is TX inhibit/Scan. A Key Press the key to activate its programmable lunction The delault setting is Monitor. When in the Menu, a key press will step back one step. Also used as an exit key. TXlBusy LED TX LED lights red while transmitting. P'I'I' Switch To send a voice transmission, press and hold the switch, and then speak into the microphone. Release PTT to receive. www etech2004 co kr 4.1 Programmable Key Functions Keys can be programmed with the lunctions listed below. Each key has the ability for two lunctions to be programmed, and are activated With a short press or long press. Please contact your dealer for funher details on these lunctions. Channel Up Talk Around ONIOFF DTMF Butler Clear Channel Down Fast Channel Mode Scan Add/Remove Monitor ON/OFF TOT ON/OFF Status Send Key lock ON/OFF BCL ON/OFF Staus Receive Check Scan Mode Scramble ON/OFF DTMF One fime Send Selcall Mode Compander ONIOFF Voting Mode TX Power Change TX Inhibit ON/OFF Squelch Change Emergency Key Tone ON/OFF Group Charge DTMF ON/OFF TX Alert ON/OFF Horn Alert ONIOFF 'GPS ON/OFF Public Address ON/OFF Menu 'The function can be selected only when GPS is installed. 4.2 Operations Power ON [OFF Press and hold the volume knob to turn the radio on. It the radio is protected With a password, "PASSWORD INPUT" will appear on the display when power is on. To unlock the radio, enter the correct password. 1. Choose a number by rotating the channel selector. 2. Press the selector to input the number. 3. Repeat steps l and 2 to enter the whole password. ll no key is pressed within it} seconds, the radio Will return to the password protect state. 4. Press the selector lor more than 1 second to complete the entry. Press and hold the volume lor approximately 2 seconds to turn the radio ol'l.l‘urther details on these lunctions. Volume Adjustment Rotate the volume knob clockwise to increase the volume and counterclockWise to decrease the volume. Maximum increment is 16 levels. @E-TECH www etech2004 co kr D-SUB 15 Pin Connector Microphone Jack pin No pin Name Descfip‘ion spew-mafia" yo Remark Pin No Pin Name Description Specification IIO Remark 1 RX Signai Siiengii DC Power Output o.s~1.4v o i MEL Backlighl of Microphone - O PowerON ITSV Aher 2 DC+13.6V DC Power Output 13.6t5% 0 IGN Ignition Signai Input Power OFF : J, 8V | PCB Version 3 GND Ground Ground , i 2 R79 is Elem” XM1'R5 4 Pi'i/Txoo P'l'F/PC Seriai Daia 3 3v 'l'l'i. | ’ LSP Low Speed Data R12 is selection XMZ-RS 3 EX‘LSPK Loudspeaker Output 41214WaIl o XM4-R7 5 ME MG am" we 6mm 7 , 4 ABOUT Audio Output SOOmV o s M'C ""0 S‘gna' mm" 6009 ' a 5 EX‘LMIC Ammo mm 5k a I 7 Hoownxoo HOOK/PC Seriai Data 3 3v 'I'I'L | 6 TXD/FCNi TX Serial Data 3.3V TTL 0 5 DM MIC Data Detection High Impedance I/O 7 RXD/FCNZ RX Seiial Data :2ng PW OFF I Speaker Jack (3.5mm Phone Jack) 4Watt/4 .Q 8 EXU’W Emma‘ PW 0V(L) : PTI' 0N ”0 Pin No Pin Name Description Specification IIO Remark 9 FiAUDIO IF ic Output 10an o 1 SPO Externai Speaker Output 4Watt/412 o 10 con/cos Squelch Output 2% 32‘; 911620, o 2 GND 6mm 6mm 0 1i EXT/iNPUT Programmabie High Impedance l/O DC Input Power Connector 12 DC+5V DC PW” 5”” DC+5V M” 100'“ 0 Pin No Pin Name Description Specification i/o Remark 1: HM Hom Alert Signal Ouiput Max M 0 Red DCH 3.6V DC Power ompm 13.6t5% i ~n 14 HR2 Horn Alen signal Output Max 3A 0 mack GND Ground Ground I iq‘LJ 15 GND Ground Ground Antenna Connector Pin No Pin Name Description Specification IIO Remark PL-259 Impedance is 50 24 25 @E-TECH 7. EM-100/ EM-4OO General Frequency Range Frequency Stability Programmable Channels Channel Spacing Dimensions Weight Power Source Current Drain (Maximum) Receiver Sensitivity Squelch Sensitivity Selectivity Spurious and Hammic Rejection FM Hum and Noise Audio Output Power Audio Distortion Audio Response IF Frequencies Input Impedance Transmitter RF Power Output Spurious and Harmonic FM Hum and Noise Audio Distortion Audio Frequency Response Output Impedance 26 EMriOOVHF : 100~ 174 MHZ EM400 UHF : 400 ~ 470 MHZ :1 SPPM (-30:12 +60'C) 512 Channel/32 Group Dual Channel Spacing 12.5/25 kHz (12 5kHz USA) 103mm (H) x 52mm (W) x 32mm (D) 1 1 Kg DC +13 6 Receive Mode, Rated Audio Out - 1A(Audio Max) Transmit Mode - 11A Standby Mode - SOOmA 0.25uV 12 dB SINAD 0.22uV10dE SINAD 65dB (12.5kHz), 70dB (25mm 75dB 40dB (12.5kH2). 45dB (25kHZ) 4 Watt Across an 4-ohm Load Less than 5% at Rated Output +1, (3 dB trom MB per Octave De-Emphasis Characteristic from 300 ~ SOOOHZ EMVIOO VHF : 21 .4MHZ and 455kHz EM-4OU UHF : 45 SMHZ and 455kHZ 50 ohms EM7100 VHF : 50/25/10/5Watt EM7400 UHF : 40/25/10/5Watl 70dB 40dB (12.5kHZ), 45dB (25kHZ) 3% Maximum with 1kH2 Modulation +1, 611B from MB per Octave Pre-Emphasis Characterisn‘c from 300 ~ SOOOHZ 500th www etech2004 co kr 27 @E-TECH E—TECH 60., LTD offers to the original end user a: One (1) Year Limited Warranty on EM series. E-TECH warrants each new radio product manulactured or suppiied by it to be tree lrom detects in material and workmanship under normal use and service lorthe time period stated, provided that the user has complied With the requirements stated herein. The warranty period begins on the date at purchase from an Authorized EVTECH Dealer. This warranty is not assignable or translerable. This warranty is void ii the product serial number is altered. delaoed or removed EVTECH is not responsible for any equipment that is attached to or used in conjunction with the products During the warranty period, it the product laiis to function under normai use, because at manulacturing delects or workmanship, it should be returned to the Authorized E-TECH lrom which it was purchased The Authorized E-TECH will repair the product or returm the product tor repairto E-TECH or its Authorized Repair Depot. The user is responsible iorthe removal ol the product lrom a vehicle or any equipment attached to it. or other site of its use, transportation ol the producr to the Authorized EVTECH. for the return of the repaired or replacement product to the site ol its use and tor the reinstaliation ol the product. E-TECH shali have no obiigation to make repairs or repiacement ot product which results lrom norma wear and tear, or is necessitated by catastrophe. lauit, or negligence ol the user, improper or unauthorized alterations or repairs to the product incorrect Wiring, use lorwhich it was not designed or by causes external to the product. EVTECH's sole obligation shall be to replace or repairthe product covered by warranty. Replacement is done at EVTECH‘s discretion and may consist at a similar or higher leatured product. Repair may include the replacement of parts with lunationaily equivaierit new or reconditioned parts Ail replaced pans and aoessories are warranted torthe baiance ol the original time period. Ali pans and accessories that are replaced become the property or E-TECH. 28 www etech2004 oo kr THE EXPRESS WARRANTIES CONTAINED HEREIN ARE IN LIEU OF ALL OTHER WARRANTIES. EITHER EXPRESSED OR IMPLIED OR STATUTORY, INCLUDING, WITHOUT LIMITATION. ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. FOR ANY PRODUCTTHAT DOES NOT COMPLY WITH THE WARRANTY SPECIFIED, THE SOLE REMEDY WILL BE REPAIR OR REPLACEMENT IN NO EVENT WILL EVTECH BE LIABLE FOR ANY DAMAGES. INCLUDING ANY SPECIAL. INCIDENTAL. INDIRECTOR OR CONSEQUENTIAL DAMAGES. OR THE LOSS OF PROFIT REVENUE OR DATAARISING OUT OF THE USE OR THE INABILITY TO USE THE PRODUCT. 29
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : Yes XMP Toolkit : Adobe XMP Core 4.0-c321 44.398116, Tue Aug 04 2009 14:24:39 Modify Date : 2014:07:09 17:11:51-07:00 Create Date : 2014:07:09 17:11:45-07:00 Metadata Date : 2014:07:09 17:11:51-07:00 Creator Tool : Adobe Illustrator CS3 Format : application/pdf Title : EM_SERIES_1 Document ID : uuid:c821763e-0c60-4111-9f4b-4a0f7d1dcf58 Instance ID : uuid:aac9140d-7c83-45d2-9c1b-4c3790e0cfb7 Producer : Adobe PDF library 8.00 Has XFA : No Page Count : 4 Creator : Adobe Illustrator(R) 13.0 For : shkim, Bounding Box : -9 -9 831 576 Creator Version : 13 Container Version : 11EXIF Metadata provided by EXIF.tools