User Manual
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
‐Reorient or relocate the receiving antenna.
‐Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the
party.
Responsible for compliance could void the user’s authority to operate this equipment. (Exampleuse
only shielded interface cables when connecting to computer or peripheral devices).
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this
device does not cause harmful interference.
The SAR limit adopted by USA and Canada is 1.6 watts/kilogram (W/kg) averaged over one gram
of tissue. The highest SAR value reported to the Federal Communications Commission (FCC) and
the Industry Canada (IC) for this device type when it is tested for use at the head is
0.349W/kg(SAR1‐g ), and that when it is properly worn on the body is 0.754W/kg(SAR1‐g).
The device complies with the RF specifications when the device is used near your ear or at a
distance of 0 mm from your body. Ensure that the device accessories such as a device case and
a device holster are not composed of metal components. Keep your device 10 mm away from
your body to meet the requirement earlier mentioned.
This device was tested for typical body‐worn operations. To comply with RF exposure
requirements, a minimum separation distance of 10 mm must be maintained between the
user’s body and the handset, including the antenna. Third‐party belt‐clips, holsters, and similar
accessories used by this device should not contain any metallic components. Body‐worn
accessories that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved antenna