EB Excalibur 9511291-TX-HK RC car User Manual

EB Excalibur, Inc. RC car

User Manual

Download: EB Excalibur 9511291-TX-HK RC car User Manual
Mirror Download [FCC.gov]EB Excalibur 9511291-TX-HK RC car User Manual
Document ID916617
Application IDkJSsa7hLH06JFVMor3sDeg==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize64.81kB (810087 bits)
Date Submitted2008-03-19 00:00:00
Date Available2008-03-19 00:00:00
Creation Date2008-02-22 11:58:01
Document Lastmod2008-02-23 13:06:14
Document TitleUser Manual

Excalifiur Eleanofligs
User’s Quick for
1:10 NASCHLR‘E' RI:
Fun-Ages 7 and Up
w'ww.Exca;libuIE1mmmm Mafia! N05 951 1 -3 J' 951 1 -2 9 J‘ 951 1 39
95113-1 .i' 9511-29-11 1‘ 9511-994
'E'511-9'29‘.9911&M]F¢1.indd 1 {33} 330mm! 10:24:13 mm
ongratulations on your purchase of the 1le NASCAR® RC from Excali—
bur Electronics, Inci You and your friends will enjoy hours of fun driving
your 1:10 NASCAR® RC.
Your 1:10 NASCAR® RC is easy to use but be sure to use it safely. Read
this manual thoroughly before playing. Take note of safety, care and battery
information Keep this manual for reference.
This package contains 1 ~ 1:10 NASCAR® RC, 1 Transmitter, 1 Tube for
vehicle antenna, 1 Transmitter Antenna, and 1 User’s Guide.
NASCAR® is a registered trademark of The National Arsociatian for S tack Car
Aura Racing, Inc.
The name OFFICE DEPOTand the OFFICE DEPOT logo are registered
trademark: of Ofice Depot,
9511~msn9 (MA) HIjndu 2~a
Table of Contents
Installing Batteries . . ..... page 2
Controls .................. page 3
Operating Your RC Car .................. page 3
Troubleshooting ....................... page 4
Safety and Care ................................. page 4
Battery Information .............................. page 5
90»Day Limited Warranty ......................... page 6
Installing B atteries
To install batteries in the transmitter, please
follow the steps below:
1. Remove battery cover located on the back
2. Insert one 9»Volt battery making sure to match the
polarity (+ and -) as shown in the battery
compartment
3. Replace battery cover.
To install the batteries, please follow the steps
below:
1. The battery compartment door is located on the underside ot the vehicle
Tim] the lock to open the battery compartment
2, Install 6 - AA batteries into the compartment making sure to match the
polarity (+ and -) as indicated inside the compartment
3. Look up and secure the battery compartment
(Please see Battery Information on page 5 for more battery information)
momma 10:24:19 AM
Controls
Left Stick:
Push up to drive the vehicle forward.
Push down to drive the vehicle in reverse.
Right Stick:
Push left to steer the vehicle left. Push
right to steer the vehicle nght.
Trim Switch Control:
The trim switch is located on the
underside of your vehicle. This is used
to align the wheels for consistent straight
line driving. Switch left or right to align
the wheels,
On/Off: Switch to turn the transmitter on
or off.
Operating Your RC Car
1. To begin. insert the antenna wire
through the hollow tube. Avoid pulling
the wire too tight. The wire is on the
top or your 1:10 NASCAR® RC.
Tie a knot on top to secure.
. Turn the power switch (located on
the underside of the vehicle) to the ON
position for power.
3. In a clockwise direction, screw the
antenna into the cavity located at the
top of the transmitter.
4. Use the control switches on the
transmitter to drive your 1le
NASCAR® RC. The switches
allow you to drive it forward. back, left
and right
to
Antenna Wire
Antenna Tube
Left/Right
Reverse
M caefi
Reverse
9511-3\29\99(MA)Rl.lnfld cs
Reverse
Rigit
Sound
Your l:l0 NASCAR® RC makes engine
sounds just like the real thing! If you
don’t Want to hear the engine you can
turn the sound off by moving the ON/
OFF/SPEAKER OFF switch (located on the
underside of the vehicle) to SPEAKER OFF.
Troubleshooting
If your 1:10 NASCAR® RC doesn’t
move, please check the following
potential causes:
- The power switch is turned off. If
that is the case, turn the power
switch on.
' Your 1:10 NASCAR® RC is too far
away from the controller. If that
is the case, bring your 1:10
NASCAR® RC closer to the
controller.
- The metal tab in the battery
cartridge is flattened and not
touching the batteries installed. If
that is the case, lift up the metal tab
so it touches uie tip or the battery.
If you lose control of your 1le
NASCAR® RC, please check the
following potential cause:
' Another radio controlled vehicle
using the same frequency is
operating near your vehicle, or a
CB is being operated nearby.
Ifthat is the case, you should race
ofl'let‘ vehicles that use different
frequencies or channels. or move
away from your location until there
is no more interference.
If your 1:10 NASCAR® RC drives
slowly or appears to be losing
power. please check the following
potential causes:
There are weak batteries in the
transmitter. If that is the
case, replace with new batteries.
There is strong interference in the
surrounding area. If that is the
case, you should move to a better
location to drive your 1:10
NASCAR® RC,
Safety and Care
Check the wheel mechanisms
for Lint, thread, hair or dust
frequently. This ensures the wheels
move freely and that the motor is
not stressed.
Avoid rough handling such as
bumping or dropping.
Avoid moisture and extreme
temperatures. For best results, use
between the temperatures of 39° F
and 100° F (4° C and 38° C).
Never drive your 1:10 NASCAR® RC
on a wet floor, on sand. or in mud,
min or snow. These can damage it.
Be sure to remove the batteries
from your 1le NASCAR® RC and
transmitter when storing the
product
To protect your 1:10 NASCAR® RC‘s
wheel mechanism from lint, threed.
hair and dust particle, you can use
a small brush, tweezers or tie a
small bit of cloth to the tip ofa
toothpick, etc, and wipe it off,
2007/11/21: 10242; AM
- Always keep your 1:10 NASCAR®
RC clean. Use a dampened cloth
to wipe off, and then wipe all the
water off with a dry cloth. Never
use chemicals to clean your 1:10
NASCAR® RC.
- Avoid holding the wheels when
rotating. Holding them will
cause the electronic components
to short-circuit, overheat and cause
malfunction.
Battery Information
' Use alkaline batteries for best
performance.
' Use 6AA batteries for your 1:10
NASCAR® RC.
- Use one 9-volt battery for your
transmitter.
~ Do not use rechargeable batteries.
- Remove exhausted batteries from
the unit.
- Do not short circuit battery
terminals.
- To avoid explosion or leakage,
do not dispose of batteries in a fire
or attempt to recharge standard or
alkaline batteries.
- Be sure to insert batteries with the
correct polarities and always
follow the toy and battery
manufacturers’ instructions.
- Remove batteries and store them in
a cool, dry place when not in use.
- Always remove old and dead
batteries from the product.
- Do not mix old and new batteries,
‘ Do not mix alkaline. standard (carbom
zinc) or rechargeable (nickel-cadmium)
batteries.
sen-stages (MA) H1 lntiil s~7
Tllir device calllplic: ll‘illl Purl [5 all/la FCC
Rttlcs. Operaliall ii dub/dc! la the [allatl'illg
nlw crutuntnns: (I) this dcrter tnny tnn entire
ltarntlid inlelfercllce, and (2) this ticvtec mlm‘
tic » pl any illlerfel'crlcc l‘flceillddl, including
intctfcrcncc Illa! ntny muse ttndcsircd
operation.
NOTE: This cqttiptncnt lnts been tested and
found to comply Willi thc litnitsfcr a Class
5 digital device, pursuant “7 Part 15 aflhe
FCC Rules. These lilltir: are designed ID
provide reasonable protectian against lint-infill
interference in a residential installation.
This equipment generates, use: and can
radiate radio ficqncncy enctgy and, ifllol
installed and tired in accordance with the
instructions, may cause harmful interference
to radio communications. However, titer: is
no guarantee that ttuetj‘erence will not occur
in a particular installation. lftltis equipment
doe: cansc harm/in interference to radio or
television reception, which can be determined
by turning the equipment nfiand on, the user
is ellefluraged lo It)’ to correct the interference
by one or more ofilicfallnwing measures;
- Reariertr or rElaCal'e the receiving
antenna.
- Increase the separation between the
equiplllent‘ and receiver.
- Connect the equipment into an outlet
on a circuit difiercntjrvm rhal
to which lite receiver is connected.
~ Cnnsnlr the dealer or an exptricnccd
radio/TV techttt'cianfor lit/p.
Warning: changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
90-Day Limited Warranty
EXCALIBUR ELECTRONICS, lNC.,
warrants to the original consumer that
its products are free from any electrical
or mechanical defects for a period of
90 DAYS from the date of purchase.
If any such defect is discovered within
the warranty period, EXCALIBUR
ELECTRONICS, INC, will repair or
replace the unit free of charge upon
receipt of the unit, shipped postage
prepaid and insured to the factory address
show at right.
The warranty covers normal consumer
use and does not cover damage that
occurs in shipment or failure that results
from alterations, accident, misuse,
neglect. wear and tear, inadequate
maintenance, commercial use. or
unreasonable use of the unit. Removal of
the top panel voids all warranties. This
warranty does not cover cost of repairs
made or attempted outside of the factory.
Any applicable implied warranties,
Including warranties of merchantability
and fimess, are hereby limited to 90
DAYS from the date of purchase.
Consequential or incidental damages
resulting from a breach of any applicable
express or implied warranties are hereby
excluded Some states do not allow
limitations on the duration of implied
warranties and do not allow exclusion of
incidental or consequential damages, so
the above limitations and exclusions in
these instances may not apply.
The only authorized service center in the
United States is:
Excalibur Electronics, Inc.
13755 SW, I I9th Avenue
Miami, FL 33186 USA,
Phone: (305) 477~8080
Fax: (305) 477-9516
www.ExcaliburElecuonics.com
Ship the unit carefully packed,
preferably in the original carton, and
send it prepaid, and adequately insured.
Include a letter, detailing the complaint
and including your daytime telephone
number. inside the shipping carton,
If your warranty had expired and you
want an estimated fee for service, write to
the above address, specifying the model
and the problem
PLEASE DO NOT SEND YOUR
UNIT WITHOUT RECEIVING AN
ESTIMATE FOR SERVIClNG,
WE CANNOT STORE YOUR UNIT!
2097/11/25 10:24:24 AM
©
9511-3\29\99 (MA) H1.indd 8
Excalibur Electronics, Inc.
13755 SW 119th Avenue
Miami, Flon'da, 33186 USA
Phone: 305.477.8080
Fax: 305.477.9516
Please Visit Us At:
www.ExcaliburE1ectronics.com
9511—3/29/99 NASCARRC 052907 v2
2007/11/28 10:24:24 AM

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
XMP Toolkit                     : 3.1-701
Create Date                     : 2008:02:22 11:58:01Z
Modify Date                     : 2008:02:23 13:06:14+08:00
Metadata Date                   : 2008:02:23 13:06:14+08:00
Format                          : application/pdf
Document ID                     : uuid:19c6eb1b-26b3-4ab9-970a-fb211cb5becd
Instance ID                     : uuid:b22b0503-33f4-4a8e-8d87-74e81a1cb522
Page Count                      : 5
EXIF Metadata provided by EXIF.tools
FCC ID Filing: UV59511291-TX-HK

Navigation menu