ECHO TECHNOLOGIES ASIA 79867F49 Max Rumbler (49MHz) User Manual 79867 12w7 25h8d V1 8 2F CS5

ECHO TECHNOLOGIES ASIA LTD Max Rumbler (49MHz) 79867 12w7 25h8d V1 8 2F CS5

User manual_2ACRG-79867F49

STUNTSAWESOMEAWESOME 8 8STANDFLIP360º SPINVERTICAL SPINHYPER SPINSOMERSAULTSIDE FLIPWHEEL STANDRCRADIO CONTROLLED STUNT VEHICLE 8 AWESOME STUNTS! 8 AWESOME STUNTS!STANDFLIP360º SPINVERTICAL SPINHYPER SPINSOMERSAULTSIDE FLIPWHEEL STANDRADIO CONTROLLED STUNT VEHICLERCSTANDTo make the Max Rumbler stand, push both joysticks up to drive forward and gain speed about 2-3 seconds. At full speed, hold both joysticks down for stand.FLIPTo flip the Max Rumbler, push both joysticks up to drive forward about half a second. Release both joysticks and the momentum of the Max Rumbler will flip itself. The same can be done with both joysticks down.WHEEL STANDTo do this stunt, push both joysticks up to drive forward about 3-4 seconds. At slow speed, push the right joystick down and then release the left joystick.360º SPINFor 360º spin, just push the left joystick up and the right joystick down at the same time. To spin in the opposite direction, push the left joystick down and the right joystick up at the same time. VERTICAL SPINTo do this stunt, simply push the left joystick down. To spin in the opposite direction, push the right joystick down.HYPER SPINTo perform this amazing stunt, push the left joystick down and simultaneously push the right joystick up. Hold to gain speed and then push both joysticks up for Hyper Spin. SOMERSAULTTo do this stunt, hold the left joystick down to perform a Vertical Spin. Then, tap the right joystick downwards repeatedly to advance to a Somersault stunt. SIDE FLIPPush both joysticks up to drive forward and accelerate about 4-5 seconds. Then push the right joystick down while holding the left joystick to flip to the right. To flip to the left, push the left joystick down while holding the right joystick up.Long Press. Short Press. Release.Battery InstallationNote: When replacing RC Max Rumbler battery: Use alkaline battery only.The Max Rumbler requires 5 “AA” 1.5V (not included) alkaline batteries for the vehicle and one 9V battery for the transmitter (not included).SOLVENTWATERMINERALSPIRITSDo not use chemicals or water to clean.Gently brush areas where dirt is trapped.Wipe down body with soft cloth.Switch OFF Transmitter and Vehicle when not in use.Avoid running on thick carpeting.Avoid water puddles,wet grass or rain.DO NOT pick up while in motion.Not for Children under 8 years old.UNDER 8 YEARS OLDUNDER 8 YEARS OLDKeep fingers, hair and loose clothing away from the tires and the wheel hubs while the Vehicle is switched “ON”.Do not leave in direct sunlight for long periodsas damage may occur.Avoid Sand, Salt and Mud. Avoid collisions with hard surfaces.Store in cool dry place and away from direct heat sources.Handle carefully, DO NOT drop it.Precautions and CareFCC StatementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The manufacture is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.Cautions:Important! Only adults should replace batteries.- Alkaline batteries are recommended.- Do not use rechargeable batteries.- Non-rechargeable batteries are not to be recharged.- Do not mix old and new batteries.- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.- Only batteries of the same or equivalent type as recommended are to be used.- Batteries are to be inserted with the correct polarity.- Exhausted batteries are to be removed from the toy.- The supply terminals are not to be short-circuited.- Please keep this information for future reference.- Remove batteries from the product before extended storage.- Do not dispose of battery in fire, battery may explode or leak.CONTENTS AND SPECIFICATIONS MAY VARY FROM THOSE ILLUSTRATED. PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE.CONTENTS AND SPECIFICATIONS MAY VARY FROM THOSE ILLUSTRATED.PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE.79867PUTOU INDUSTRIAL AREA,HUZHEN TOWN, BOLUO,HUIZHOU, CHINAALL RIGHTS RESERVEDTrademark licensed from Focus Brandwww.echo-technologies.comRADIO CONTROLLED STUNT VEHICLE 8 AWESOME STUNTS! 8 AWESOME STUNTS!RCSTUNTSAWESOMEAWESOME 8 88+AGESRADIO CONTROLLED STUNT VEHICLE 8 AWESOME STUNTS! 8 AWESOME STUNTS!RCHYPER SPIN!HYPER SPIN!FLIPS!FLIPS!SPINS!SPINS!STANDSTAND FLIPFLIP 360º SPIN 360º SPINSOMERSAULTSOMERSAULTHYPER SPINHYPER SPINVERTICAL SPINVERTICAL SPINWHEEL STANDWHEEL STANDSIDE FLIPSIDE FLIPWINDOW 7986712w7.25h8dDUAL FREQUENCY2FOR MULTI-RACER ACTIONDUAL FREQUENCY2FOR MULTI-RACER ACTIONDUAL FREQUENCY2FOR MULTI-RACER ACTION DUAL FREQUENCY2FOR MULTI-RACER ACTIONAntennaPowerindicatorON/OFFSwitchLeft Stick Controls Forward And Reverse Of Left WheelRight Stick Controls Forward And Reverse Of Right Wheel49 MHz27 MHzFrequency Channel: fig.4 fig.5 fig.6fig.1 fig.2 fig.3Transmitter1. Turn “ON/OFF” switch to the OFF position for the transmitter.2. Open the battery compartment cover by loosening the screw (g.4) and put a 9V battery inside following the correct polarities (g.5).3. Replace the battery compartment cover and tighten the screw. (g.6).Vehicle1. Turn “ON/OFF” switch to the OFF position for the Max Rumbler.2. Open the battery compartment cover (g.1) by loosening the screw and insert AA batteries following the correct polarities (g.2). 3. Replace the battery compartment cover and tighten the screw (g.3).

Navigation menu