EFLY HOBBY TECH 1361889MSP190 2.4 GHz RC Helicopter User Manual
SHENZHEN EFLY HOBBY TECH CO., LTD 2.4 GHz RC Helicopter
Manual
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
mSP190
Heli
mDX188-189-189B
1014
Linkage set (4)
190
1038
1037
Hp1863025
5 in 1 controller(1)
Hp1 630248
Servo (2)
Hp1 630188
Motor-A (1) Motor-B (1)
Hp1 630198
Hp1 610298
Inner Shaft Main Gear (1)
Hp1 620128
Out Shaft & Main Gear (1)
Hp1 610358
Out Shaft Bearing 3 x 6 x 2mm (2)
Hp1 610168
Swashplate (1)
Hp1 610138
Lower Rotor Head (1)
Hp1 610208
Out Shaft Retaining Collar (1)
Hp1 620218
Servo Pushrod control Link (2)
Hp1 620038
Stabilizer Flybar (1)
Hp1 610178
Main Blade (4)
Hp1 620048
Upper Rotor Head &
stabilizer Flybar Hub/Holder
Hp1 610318
Landing Skid and battery
Mount (1)
Hp1 610238
Main Frame (1)
Hp1 610368
O-Ring (4)
Hp1 620088
Screw sets (20)
Hp1 530338
1s 3.7V 150mAh Li-Po Battery
Hp1 610388
Tail frame set (1)
Hp1 510418
Heli Body Shell (1)
Hp1 610288
Canopy (1)
Heli
mDX185-186
FCC ID
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,there is no
guarantee that interference will not occur in a particular installation.If this equipment does cause
harmful interference to radio or television reception,which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
FCC RF warning statement: The device has been evaluated to meet general RF exposure
requirement.
The device can be used in portable exposure condition without restriction.
Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.