ENERGY MANAGEMENT SYSTEM TCRF-PTI4 TAINET Transceiver Module User Manual TCRF PT14 433MHz Module Manual

Download:
Mirror Download [FCC.gov]
Document ID	3758025
Application ID	es7QRy0EXuGyzDhZk0QWxg==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	92.85kB (1160574 bits)
Date Submitted	2018-02-22 00:00:00
Date Available	2018-02-26 00:00:00
Creation Date	2018-02-12 21:08:37
Producing Software	3-Heights(TM) PDF Security Shell 4.8.25.2 (http://www.pdf-tools.com)
Document Lastmod	2018-02-22 13:14:50
Document Title	TCRF-PT14 433MHz Module Manual.pdf
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Chun

SPECIFICATION
Single Chip High Performance low Power
RF Transceiver
Model I TAINET Transceiver Module
Pan N0 2 TCRF—PTI4‘
Version : V1_0
Date : 2018.2.5
T RF-PTM
I Function Description
The TCRF—PT14 is a fully integrated single-chip radio lsansceives dcsizn for high performance at verv low Dower
and low voltage over-anon in cost efl'ective wireless svstem.
The circuit is mainly inlended for the ISM and SRD frequency band at i432-436MHZ
I Applications
'Low power, high performance, wireless systems ' Wireless sensor networks
with up to 1250 Kbit/s data rate 'AMFl— uiomatic Meter Reading
' “Home and building automation
Operating at 432-436 M HZ ' Wireless MBUS, all modes
“Wireless alarm and security systems 'Wireless healthcare application
'lnduslrifll monitoring and control
I Selection Guide
Denomination 1 TAINET Transceiver Module
ParlNfl- 1 TCRF—PTI4
Note: Antenna Design is should be considered and based on the mechanism design.
We can be your consultant and we also provide customize antenna solution.
fififififlafifififlfi hlip'llwwwmmnjw
EMS Management System
Co. LTd.
CRF PTl
I Absolute Maximum Ratings
Under no circumstances must flu: absolute maximum mings given in Table 1 be violated. Sms exceeding one or more of the limiting wines may
cause permanent damage m the device
Cilmorrl ESD unsure nevus
A ,, was when 3mm:
7! ¢ may We, to mm. Wane",
Parameter Min Max Units Condition
Supply voltage 41.3 3.9 v All supply pins must have the same voltage
VDD e
Voltage on any dlgltel pin —0.3 0.3, V
max 3,9
Voltageonlhe pins | 413 2.0 v
Input RF level | +10 dBm
slomge temperature range | 40 125 °c
I Operating Conditions
Parameter Mln Max Unlts condllion
Operetlng temperature 40 85 0
Operating supply voltage | 20 33 V All supply pins must have the same voltage
I General Characteristics
Parameter Min Typ Max Unils Condition/Note
Frequency Bands 432 .436l MHz
Frequency Resolution 15 MHZ In 432-436 MHZ Band
0 1250 Kbps Packet Mode
Dela Rate
0 625 Kbps Transparent Mode
Efifh‘fiflafflfififlfij 3 "npv’lwwmm"
EMS Management System
Co. LTd.
CRF PTW
I Electrical Specifications
0 Current Consumption
TA= 25°C. VDD = 3.0 V if nothing else stated.
Parameter Min | T“) Max Units Condition
| 0.3 1 uA
Power Down with Retention
| | 05 14A Low-Power RC oscillator mnning
XOFF Mode 180 uA Crystal Oscillator/TCXO disable
Idle Mode 1.5 mA Clock mnning. Syslcm waiting with no radio activity
Transition mode for 434 MHz Bands
TA= 25°C. VDD = 3.0 V if naming else stated.
Parameter Min T¥p Max Units Condition
TX Current Consumption
014 dBm 45 "1"
Tx Current Consumption
¢10dBm 35 mA
anaemia/an 4 myfimmmw
EMS Management System
Co. LTd.
CRF PTW
0 RF Receive Section
General Receive ParameteflHigh Performance mode)
TA = 25°C, VDD = 3.0 V if nothing else s'ated.
Parameter Min Typ "la U2“ Condition/Note
Saturation 10 dElm
IIP3 -14 dElm A! maximum gain
Optimum Source Impedance
ass/9151920 MHz bands so+iso / amigo ohm (Differential 1 Single Ended RX emfigurefien)
434 MHz bands 100+le7/50+j30 ohm
169 MHZ bands 140+j4D / 70+j20 Ohm
Efifi—tfifleffifififlfi 5 "“"""“"“’""”"'““*
EMS Management System
Co. LTd.
CRF PTl
RX Performance in 43-0Mllz
TA = 25°C, VDD = 3.0 V W nothing else s'ated.
Parameter Min Typ Max Units Condi “on/Note
1.1 k Z-FSK, DEV=4 kHz
Receiver sensiliviiy -122 dBm CHFZfi km
33.4 kbps z-GFSK, DEszo kHz
41° dB’" Cilrsloa kHz
Blocking and Seledivity 60 dB +/~ 12.5KHz (ijBEml channel)
1.2 kbps 2-FSK, 12.5 kHz _
mnnel “DEMO". 4 kHz 61 dB +/ zsxllzulmnm channel)
deviation, 11 kHz
channel filter 82 dB +/- ZMHz
35 dB +/- lOMHz
Blocking and Seleaivily 49 dB +/- lOOKHz (adjacem channel)
35.4 kbps 2—GFSK. 100 _
kHz channel swam.“ 48 115 +/ ZOOKHztallcmale channel)
20 kHz deviation, 104 kHz
channel finer 66 as +/- 2MHz
74 dB +/- lOMHz
6 ,
Efifififlafflfififlfij hnpllwwwmmnlw
EMS Management System
Co. LTd.
CRF PTl
I TCleO-PTIx-N RF Module Pin Configuration
vcc
sl
SCLK
so
600}
soon
c SI
Gill)
RE sEr
Pln at Pln name Pln type Description
1 vcc Power (DigitaIL Power supply 3.3v
2 SI Digital input Serial configuration intertacs dala input
3 SCLK Digital input Serial configuration interraca clock input
4 so D'g'fl' output Serial configuration interface. data output.
Optional general outwit pin when CSN is high
5 GDOZ Digi'a' OW Digital output pin for general use:
- Test signals
- FIFO status signals
~ Clear Channel Indicator
~ Clock output, down-divided from XOSC
~ Serial output Rx data
6 600° D'g'm IIO Digihl output pln lor general we:
- Test signals
' FlFO Status Slgnals
~ Clear Channel Indlcalur
~ Clock culpul, down-divided from xosc
~ Senal output RX data
~ Senal input TX dala
Also used as analog test I/O tor prototype/production testing
7 CsN Digital Input Serial configuration interface chip select
5 GND Ground Ground
9 RESET Digital input Asynchronous. active-low digital reset
10 ANT RF signal 50 otlm impedance I RX configuration
Efifififleffifififlfi 8 W’WMM‘“
EMS Management System
Co. LTd.
TCRFVPTH
I Recommended PCB layout for Module
°.
mmmmmm
Efifififlaffififlfiflfi
EMS Management System
C0. LTd4
TCRFVPTM
I Skin packing Information
J ‘ Ci i _
J |
[—* m
, if
r~—.—v ~
‘ 31 Li]
“7 22.8(Cm)
thin-fl”; i
I Skin packing box Information
m—m Lenswcm) mm
———mmm
10 v
Efifififlafflfififlfi mew-WWW...“
EMS Management System
Co. LTd.
I Document History
Revision Dale Description/Changes
l.l ZOIl/l I/Il First Release
[2 zen/mu Change skin package box information
afimmmfima “ hipvfimmm
EMS Management System
Co. LTd.
This usermanual pertains toTAINETTransceiver
Module. The Main board can be assembled in the EleotronicWater
Meter, listed as below;
FCC Statement:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device
could void the usefs authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
enemas/ea 12 mvmwmmxw
EMS Management System
Co. LTd.
RF exposure warning
The equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment. The equipment must not be co-Iocated or operating in conjunction with
any other antenna or transmitter.
End Product Labeling :
The final end product must be labeled in a visible area with the following: "Contains
FCC ID: 2AOQRTCRF-PTI4
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied
to an OEM or integrator, but should not be distributed to the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document for other restrictions.
Efifififlelflfiflaflfi 13 hwy/wwwummlw
EMS Management System
Co. LTd.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
Linearized                      : No
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Modify, Annotate, Fill forms, Extract, Assemble, Print high-res
Author                          : Chun
Create Date                     : 2018:02:12 21:08:37+08:00
Modify Date                     : 2018:02:22 13:14:50+08:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Creator Tool                    : PScript5.dll Version 5.2.2
Metadata Date                   : 2018:02:21 20:11:42+08:00
Format                          : application/pdf
Title                           : TCRF-PT14 433MHz Module Manual.pdf
Creator                         : Chun
Document ID                     : uuid:3ea4b5b4-2a27-4d63-8b9d-ed0b55806168
Instance ID                     : uuid:1d91e505-8e1a-4fe7-b6ac-cd4e5f3ecca3
Producer                        : 3-Heights(TM) PDF Security Shell 4.8.25.2 (http://www.pdf-tools.com)
PDF Version                     : 1.4
Page Count                      : 12

EXIF Metadata provided by EXIF.tools