ENTERMEDIA ET30KH-BT Karaoke device User Manual PRINTS ET30KH QUICK GUIDE ENGLISH VER 100

ENTERMEDIA CO., LTD. Karaoke device PRINTS ET30KH QUICK GUIDE ENGLISH VER 100

User Manual

FCC compliance Information FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected. • Consult the dealer or an experienced radio/TV technician for help.Caution Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Compliance Information : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation (7.+%7This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna,2) OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). IMPORTANT NOTE: In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. Maximum antenna gain allowed for use with this device is  dBi End Product Labeling To satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the end product : Contains Transmitter Module FCC ID : 3%1(7.+%7Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual. <Antenna Notice>This Module should be used only supplied antenna. (17(50(',$&2/7' will not be held responsible forthe problem caused when using a different antenna. <RF Exposure> This module is used LQDIL[HGORFDWLRQ. Therefore, It isn't necessary for the SAR testing. <MPE Evaluation> ※ This device operates at separate distance above 20cm.

Navigation menu