Eastern Times Technology DS-2118 Wireless Optical Mouse User Manual 511916

Eastern Times Technology Co., Ltd Wireless Optical Mouse 511916

Users Manual

Systems Compatibility
IBM PC and Win 95/98/Me/2000/XP, No need driver
Build-in mini receiver
As bellow, press the receiver-out button, and then the receiver
can spring out automatically, at this time, mouse begin to
work. If you push the receiver back to the transmitter, power
will be cut down automatically.
T
he Steps of Install Battery
1. Please prepare for two PCS new AA alkaline batteries
2. Press the button of the mouse upper cover and pull the
battery cover rearward (Please see the reference picture)
3. Please insert the batteries correctly according to the
polarity marks of the battery grooves.
4. Pull the battery covers forward, when you hear “crack”
sound which shows the battery cover is locked
successfully.
D
Setup
1. Please move the mouse near to the receiver
2. Press the ID button of the mouse bottom with some hard
and acuate object within 10 seconds, the receiver light will
flash very fast, a few seconds later it will be on which
shows it is successfully to finish the digital transmission
between the mouse and the receiver. You may start to use
it.
3. 3. Working distance: within 0.6-1.5 m.
Attention Please
1. Please don’t make the mouse far away from the receiver in
order to work more smoothly.
2. You’d better use the mouse on the white desk, in this way the
batteries can be used longer time. Please remove the batteries if
the mouse will not be used for a long time.
3. This mouse with save power sleeping functions, please press any
key or scroll the wheel to wake up the mouse when it is sleeping.
4. If you want to take off the mouse power, please continue to
press the ID switch of the mouse bottom over 3 seconds. If
you want to take on the power, please click the ID switch
once again.
5. The optical mouse will not work freely on a smoot
h
desk ,glass, any reflecting surface, 3D mouse pad.
6. when you are moving the mouse, if the low-
p
ower indicatio
n
light flickers, it shows that the batteries are using up, pleas
e
change another two new right batteries.
7. No need to check the digital connection within 10 second
when change the batteries, if more than that please accordin
g
to the above way to re-operate.
8. if you put the receiver into transmitter, power are cut dow
n
automatically, and you can take them away.
Caution
Any changes or modifications not expressly approved by the part
y
responsible for compliance could void the user's authority t
o
operate the equipment.
Note
Note: This equipment has been tested and found to comply with th
e
limits for a Class B digital device, pursuant to part 15 of the FC
C
Rules. These limits are designed to provide reasonable protectio
n
against harmful interference in a residential installation. Thi
s
equipment generates, uses and can radiate radio frequency energ
y
and, if not installed and used in accordance with the instruction
may cause harmful interference to radio communications. Howeve
r
there is no guarantee that interference will not occur in a particul
a
installation. If this equipment does cause harmful interference t
o
radio or television reception, which can be determined by turnin
g
the equipment off and on, the user is encouraged to try to correct th
e
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.

Navigation menu