Eastern Times Technology DS-2141 Wireless Mouse User Manual 649864

Download:
Mirror Download [FCC.gov]
Document ID	649864
Application ID	02MaArGB+djjpwYULQBY2g==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Microsoft Word - pdf
Filesize	15.48kB (193537 bits)
Date Submitted	2006-04-21 00:00:00
Date Available	2006-04-19 00:00:00
Creation Date	2006-04-22 08:41:36
Producing Software	Acrobat Distiller 5.0.5 (Windows)
Document Lastmod	2006-04-22 08:41:36
Document Title	Microsoft Word - 649864.DOC
Document Creator	PScript5.dll Version 5.2
Document Author:	Administrator

acuate object within 10 seconds, the receiver light will flash very fast,
operate the equipment.
a few seconds later it will be on which shows it is successfully to
3.
Note
finish the digital transmission between the mouse and the receiver.
Note: This equipment has been tested and found to comply with
You may start to use it.
the limits for a Class B digital device, pursuant to part 15 of the
Working distance: within 0.6-1.5 m
Attention Please
1. Please don’t make the mouse far away from the receiver in order to
work more smoothly.
Charge Function
Battery
When using mouse, if the red led of the low battery beside the wheel
re for 1 PCS new AAA alkaline batteries
flashes, please change batteries or charge them .The mouse can use
on of the mouse upper cover and pull the battery cover
USB line to charge, connect one side of USB line to the connector of the
e see the reference picture)
board, and the other side to USB connector before the mouse, thus it can
the batteries correctly according to the polarity marks
successfully charge the battery. It can charge while you use the mouse. It
ooves.
is full within about 8-10 hours, and then unplug the connector to stop the
ry covers forward, when you hear “crack” sound which
charge. Please note that the time of charge may vary when the degree of
ry cover is locked successfully.
discharge is different.
2. You’d better use the mouse on the white desk, in this way the
batteries can be used longer time. Please remove the batteries if
the mouse will not be used for a long time or if you travel outside.
3. This mouse with save power sleeping functions, please press any
key or scroll the wheel to wake up the mouse when it is sleeping.
4. If you want to take off the mouse power,please continue to press
the ID switch of the mouse bottom over 3 secons.If you want to take
on the power,please click the ID switch once again.
5. The optical mouse will not work freely on a smooth desk ,glass, any
reflecting surface, 3D mouse pad.
ended cable, and put the receiver and transmitter on
6. When you move the mouse, if the light of the battery before the
this way, you may have higher working efficiency.
2 connector, please use the USB to PS/2 adaptor and
receiver flashes, which shows that the power is nearly finished.
e connector before your computer start-up.
Please change the proper-sized new battery or charge it
ou may connect the receiver directly with the USB
immediately.
the mouse near to the receiver
button of the mouse bottom with some hard and
Recharge connector
7. You can place the receiver in the mouse when you want to carry the
mouse on business, and press the switch of ID for a long time so as
to switch off the power.
Caution
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interfer- ence to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
Create Date                     : 2006:04:22 08:41:36-04:00
Modify Date                     : 2006:04:22 08:41:36-04:00
Page Count                      : 1
Creation Date                   : 2006:04:22 12:41:36Z
Mod Date                        : 2006:04:22 12:41:36Z
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Author                          : Administrator
Metadata Date                   : 2006:04:22 12:41:36Z
Creator                         : Administrator
Title                           : Microsoft Word - 649864.DOC

EXIF Metadata provided by EXIF.tools