Eastern Times Technology DS-2440 2.4G Wireless Optical Mouse User Manual

Eastern Times Technology Co., Ltd. 2.4G Wireless Optical Mouse

User Manual

DS-2440 2.4G Wireless Optical Mouse Manual Features: Universal 2.4G Wireless project Avago high-end mainstream optical chip Up to 2000CPI and three resolution for conversion Ergonomic design Built-in Nano Receiver How to install 1. Get the mouse and receiver out of the package 2. Insert the receiver into computer’s USB port 3. Insert 1pc AA Alkaline dry battery into the mouse 4. Press any button to use the device Advanced Functions: 1: CPI adjustable function Three CPI for conversion: 1000/1500/2000. Default is 1000CPI. Press the CPI button to switch the speed. During switch progress, LED light flashes one time, it means 1000CPI , LED light flashes twice, it means 1500CPI, LED light flashes three times, it means 2000CPI 2: Low battery reminder function The power gets lower during use. Please insert new battery once the LED shines red light after low voltage Attention: Only AA Alkaline dry cell 3: Auto saving function The mouse will be sleeping if the mouse out of use after 8 minutes. Press any button to reuse. Please turn the mouse off during outing Warning: Do take the battery out if disuse long time 4: Built in Nano receiver: No influence for Nano receiver to be inserted into the USB port for a long time. It is convenient to put the Nano receiver inside the mouse.
Reconnection There is one identification code of the mouse. High temperature, high magnetic field and vibration will influence the code and need to be reconnected 1: Unpin the receiver and reinsert 2: Press The scroll wheel and the right button simultaneously for a few seconds and then loose , the device can be used again. Attention: 1:This mouse adopts optics for shift detection subject to the relevant safety regulations. 2:2.4G wireless radio wave for transmission and up to 10 meters.The transmission distance will be shorten by barrier 3: The Uneven desktop or reflective light desktop will influence proper use FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu