Eastern Times Technology DS-2613 SHARK WIRELESS GAMING MOUSE User Manual

Eastern Times Technology Co., Ltd. SHARK WIRELESS GAMING MOUSE

User Manual

 User Manual SHARK WIRELESS GAMING MOUSE M688 Before use: 1. Find the wireless mouse and Nano receiver in package 2. Plug Nano receiver to USB port on PC   3. 2PCS AA battery into Mouse body Properly 4. LED indicator will keep flash for few seconds, the Mouse is ready to work.  Advanced function 1. CPI adjustable function With  6  adjustable  CPI  500/1000/2000/3000/4000/7200, factory setting  is 1000CPI. Press the switch button on top of Mouse can easy to adjust CPI. LED indicator will flash one time while it converting to 500CPI, LED will flash twice while it converting to 1000CPI, LED will flash three times while it converting to 2000CPI. 2. Saving power mode and power switch off  If mouse is stay out of work for 8 minutes, it will turn to power saving mode, press any button to restart it.  If you turn off PC or take out Nano receiver from USB port, press any button or move the mouse to enter the power saving mode,  3, Nano receiver  A very small size design for Nano receiver, it can be plug and stay on USB port of PC/Notebook without interference. Portable design for travel, Nano receiver can be plug in the slot on bottom of mouse  4. IT have 3 report rate. With the 500 repoart rate is default.  Reconnection  Both of mouse and Nano receiver has a built-in code, It can be setting one mouse to one receiver, or few of mouse to one receiver. Mouse and receiver need to reconnect under the condition of High temperature, high magnetic, strong vibrate. 1. Plug off nano receiver from USB port, and plug it on 2. Press M key and R key at the same time. 3. You can use it by reconnection Remark Design by approval IR motion detect technology  Data transfer by 2.4G wireless connection in 10 meters operating range, working range will less than 10 meters if there is physics bothered.  Caution   Any amendment unauthorized is not allowing.
  FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna.  -- Increase the separation between the equipment and receiver.  -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  -- Consult the dealer or an experienced radio/TV technician for help  This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation

Navigation menu