Echo Toys 6002797T 49 MHz Radio Transmitter User Manual 60 2797

Download:
Mirror Download [FCC.gov]
Document ID	321384
Application ID	GAZLVFee/6m5YkpvmOUEEg==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	21.29kB (266183 bits)
Date Submitted	2003-04-28 00:00:00
Date Available	2003-04-28 00:00:00
Creation Date	2003-02-25 19:04:20
Producing Software	Adobe PDF library 4.800
Document Lastmod	2003-02-25 20:29:31
Document Title	60 2797.pdf
Document Creator	Adobe Illustrator 9.0

Brum
Sequence
wƒ—“‹“‰
Dispose of old batteries and the
battery pack promptly and
properly; do not burn or bury them.
60-2797
OWENER'S MAUNAL
important
If an icon appears at the end of a
paragraph, go to the box on that
page with the corresponding icon
for pertinent information.
wƒ—“‹“‰
i’•”—™ƒ“™
h‹“™
cƒš™‹”“
n”™‡
Please read before using this equipment.
Your RadioShack Brum is built to built to 1/4 scale, it can reach speeds of
up to 160 feet per minute.
INSTALLING BATTERIES
You need four AA batteries to power your Brum, and one 9-volt battery
for its transmitter.
Installing your Brum's Batteries
You need four AA batteries (not supplied) to
power your Brum. We recommend the use of
RadioShack alkaline batteries.
caution
sound
expression
duration
Side rock
hello
3 sec
Starter handle
spin
Starter
hander
Starter
handle
3 sec
Headlamp turn
left and right
Same as
standby mode
looking
3 sec
1. Side rock/starter
handle spin
Side looking
Wheel alignment control
1. Slide ON/OFF on the bottom of
your Brum to OFF.
2. Turn the battery compartment cover's
latch counterclockwise until it stops,
then grasp the ribs on the cover and
lift the cover up to remove it.
3. Install the batteries in the
ON/OFF
compartment as indicated by the
polarity symbols (+and-) marked inside.
4. Replace the cover, and then turn the
latch clockwise until it stops to secure it.
Use only fresh batteries of the
required size and recommended
type.
Do not mix old and new batteries,
different types of batteries
(standard, alkaline, or
rechargeable), or rechargeable
batteries of different capacities.
Never leave dead or weak
batteries in your Brum or the
transmitter. Where they can
corrode and damage the units.
Action
Side rock/starter
handle spin
cƒš™‹”“
Do not play with your Brum in
the street.
Rocking pression
Hello pression
2. Starter handle spin
If your Brum moves slowly or not at all, replace your Brum's batteries.
Note: If you do not plan to use your Brum for several days, remove the
batteries. Batteries can leak chemicals that can damage electronic parts.
Installing the Transmitter's Battery
The transmitter requires one 9-volt battery (not supplied).
1. Press and slide the battery compartment
cover off the transmitter.
2. Place a 9V battery in the compartment
according to the polarity symbols
(+and-) marked inside.
3. Replese the cover. Be sure it
snaps shut.
n”™‡
All batteries and chargers required
for your Brum are available at your
local RadioShack store.
3. Headlamp turn
left and right
Headlamps turn
left and right side
When the transmitter's range
decreases, replace its battery.
Operation Driving your Brum
1. Slide ON/OFF on the bottom of your Brum to ON
When the car is on, there are two modes: Expression mode and
Driving mode. If you leave the car on and not moving it, you will
hear engine tick-over sound then the Brum has entered into a
5 second standby mode. After 5 seconds, you will see and hear
the following sound and actions ("expression") in sequence.
Looking expression
After performing the above expressions, Brum will enter into a 10 sec
standby mode (engine tick-over sound) and will start all over again from
sequence one.
© 2003 InterTAN Inc. All Rights Reserved
RadioShack is a Registered trademark licensed to
ITA and used with the permission of TRS Quality Inc.
Use the transmitter's control levers to control the movement and
direction of the Brum.
LEFT CONTROL
LEVER
Pull forward
source.
Wipe your Brum and transmitter with a damp cloth occasionally to
keep them looking new. Do not use harsh chemicals to clean them.
Do not drive your Brum through puddles or mud, on a wet floor, or in
sand, rain, or snow. These can damage it.
Do not leave your Brum or its transmitter outside overnight. Night
dampness can damage their electronic circuits.
To protect your Brum's mechanisms from lint and hair, do not drive
your Brum on carpet.
ACTION SOUND
Move
forward
Start with Horn sound and then
Past and Away Sound and stop with
Tire Squeal Sound
Pull backward
Move
Move with Slow Revs Sound
backward
Release
Stop
Modifying or tampering with your Brum's or the transmitter's components
can cause a malfunction and might invalidate the car's warranty and void
your FCC authorization to operate them. If your Brum does not work
properly, as it should, take it to your local RadioShack store for
assistance.
Engine Tick-over Sound
Remarks: When your Brum is moving forward, it carries short bursts of
expression (Hello, Starter Handle or Looking) each of 1 second, in intervals
of 10 seconds between them.
RIGHT CONTROL
LEVER
ACTION
Push left
Turn left
Tire squeal sound
Pull backward
Turn right
Tire squeal sound
Release
Go straight
Same as that of the movement
THE FCC WANTS YOU TO KNOW
Your Brum or its transmitter might cause TV or radio interference even
when it is operating properly. To determine whether your Brum or
transmitter is causing the interference, release the transmitter's control
button and turn off your Brum. If the interference goes away, your Brum
or transmitter is causing it. Try to eliminate the interference by: Moving
your Brum away from the TV or radio Contacting your local RadioShack
store for help . If you cannot eliminate the interference, the FCC requires
that you stop using your Brum and transmitter.
SOUND
USER-REPLACEABLE PARTS
You can order these parts through your local RadioShack store.
Limited Ninety-Day Warranty
LEFT CONTROL
LEVER
Forward
RIGHT CONTROL
LEVER
Left
Righ
Backward
Remarks: the body will also lean to same direction on the turning side
3. When you finish driving your Brum, slide ON/OFF to OFF.
WHEEL ALIGNMENT
If your Brum does not drive in a straight line when you release the right
control lever, adjust the wheel alignment control on the bottom of your
Brum. Rotate the control to the left if your Brum is pulling to the right or
to the right if your Brum is pulling to the left.
CARE AND MAINTENANCE
The following suggestions will help you care for your RadioShack
Brum so you can enjoy it for years.
Do not expose your Brum or its transmitter to temperature
extremes, and do not store them in direct sunlight or near a heat
RadioShack warrants this product against manufacturing defects in material and workmanship under normal use for ninety (90) days
from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS
PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE
WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR
DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY
BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS
OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of incidental or consequential damages,
so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date
to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair without
charge for parts and labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price. All replaced
parts and products, and products, on which a refund is made, become the property of RadioShack. New or reconditioned parts and
products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder
of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty
period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or
abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess
voltage or current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation, setup service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights, which vary, from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
helpful@hints
These hints can help you get the
most enjoyment from your Brum.
Running your truck continuously
for long periods generates high
heat levels. Heat causes wear and
tear on the motor. To help keep
heat levels down, when your
truck's battery power dies, let
the truck cool at least 10 minutes
before installing new batteries.
If your Brum's motor runs but
your Brum does not respond to
the transmitter, move the
transmitter closer to your Brum
and try again.
If someone uses a CB nearby, it
might interfere with control of
your Brum. If this happens, move
your Brum away from the CB.
You cannot operate your Brum
near devices with transmitters
that use the same frequency
(27 MHz).
We Service What We Sell
RSU #
NP Part: 60-2797
03/00
Printed in China

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2003:02:25 19:04:20
Creator                         : Adobe Illustrator 9.0
Producer                        : Adobe PDF library 4.800
Title                           : 60 2797.pdf
Modify Date                     : 2003:02:25 20:29:31
Creator Version                 : 9
Container Version               : 9
For                             : MD-Chen 4 chenjiannong, JIANNONG LTD., CO.
Bounding Box                    : -116 -201 728 992
Page Count                      : 1

EXIF Metadata provided by EXIF.tools