Ecolink Intelligent Technology WST222 Wireless Sensor User Manual WST 222 manual

Ecolink Intelligent Technology, Inc. Wireless Sensor WST 222 manual

Contents

User Manual

WST-222 Wireless Recessed Contact Specifications Frequency: 345MHz Operating Temperature: 32°-120°F (0°-49°C) Battery: One 3Vdc CR-2 Operating Humidity: 5-95% RH non condensing Battery life: 5 years Compatible with Honeywell and 2GIG receivers Magnet gap: 1 inch max Supervisory signal interval: 60 min(approx.) Enrolling To enroll the sensor, set your panel into program mode, refer to your specific alarm panel manual for details on these menus. When prompted by the panel, trigger the sensor by moving the magnet in and out of range of the sensor. The panel will beep when you have successfully learned in a sensor. Note: On 2GIG panels this sensor should be configured as a “5816” type, using loop 2 Mounting The recessed sensor and magnet are designed to fit snuggly in a ¾ inch hole and a small flange on the outer rim ensures the case cannot be pushed too far into a hole. Choose a suitable location for the sensor, drill a ¾ inch by 2.5 inch hole in the door for the sensor. Mark the location for the magnet in the frame directly in line with the sensor and drill a ¾ inch by ½ inch hole for the magnet. Installing /Replacing the Battery When the battery is low a signal will be sent to the control panel. To install/replace the battery: 1. Remove the cap on the transmitter. 2. Take note of how the circuit board fits into groves on the side of the case. 3. Carefully slide out the circuit board. 4. Inspect the battery holder to determine which side the battery is inserted/removed. 5. Install /replace with a CR-2 battery ensuring the + side of the battery faces towards the circuit board. 6. Re-insert the circuit board so that the board slides within groves in the plastics. 7. Once in, replace the cap. Note: Removing the cover will trigger a zone tamper signal to the control panel

Navigation menu