Electronic Systems Technology ESTEEM195EG-1 ESTEEM 195Eg User Manual

Electronic Systems Technology ESTEEM 195Eg Chapter 0 Front Cover 195Eg

a href="https://usermanual.wiki/Electronic-Systems-Technology" itemprop="url"> Electronic Systems Technology >

user manual ch 8

CHAPTER 8 ANTENNA SETUPS Revised: 2 Jul 08 8-1 EST P/N AA107G ANTENNA AND CABLE CONFIGURATIONS (POLE MOUNT) EST offers different types of antennas for both indoor and outdoor configurations. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. Warning: Only the tested cable lengths and antennas provided by EST meet the FCC maximum peak output power requirements. Any other combination of antennas or coax cables is not authorized. This device has been designed to operate in a pole mount configuration with the antennas listed below, and having a maximum gain of 6 dB in a multi-point system or 19dB in a point to point network. Antennas not included in this list or having a gain greater 6 dB in a multi-point system or 19dB in a point to point network are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. Part Number: AA01S •••• Omni-directional, rubber duck, direct mount, unity gain antenna. •••• Indoors and short range outdoor applications. •••• There must be a minimum separation distance of 20 cm. from the antenna to the user. See Warnings. Part Number: AA20DMEg •••• Omni-directional direct mount antenna, 5 dBi gain. •••• Indoor and outdoor applications. •••• There must be a minimum separation distance of 20 cm. from the antenna to the user. See Warnings. Part Number: AA20Eg •••• Omni-directional external pole mount antenna, 6 dBi gain with 3-ft. integral feedline and connector. •••• Outdoor applications. •••• Antenna port B is not used in this configuration. •••• There must be a minimum separation distance of 20 cm. from the antenna to the user. See Warnings. Part Number: AA203Eg •••• Directional pole mount antenna, 6 dBi gain with 3-ft. integral feedline and connector. •••• Point to point and point to multi-point outdoor applications. •••• Antenna port B is not used in this configuration. •••• There must be a minimum separation distance of 20 cm. from the antenna to the user. See Warnings. Part Number: AA204Eg •••• Directional pole mount antenna, 19 dBi gain with 3-ft. integral feedline and connector. •••• Point to point applications only. •••• Maximum Output Power of 250mWatts (Power Level = Low Power) •••• Antenna port B is not used in this configuration. •••• There must be a minimum separation distance of 50 cm. from the antenna to the user. See Warnings. Transmit/Receive Antenna Port Receive Only Antenna Port Notes: Antenna Port A is a transmit and receive port for use in all applications. Antenna Port B is a receive only port and is used for dual diversity antennas applications only. This port is not used for point to point applications. Warnings: Only pre-made coax cables from the factory used in conjunction with either the AA20Eg omni-directional and AA203Eg or AA204Eg directional antennas meet all FCC Section 15.247(b) EIRP maximum power requirements. Use of the AA204Eg, directional antenna is limited to fixed point to point applications only. In accordance FCC Section 15.247(b)iii, this antenna must be professionally installed. The installer must ensure the system is used exclusively for fixed, point-to-point applications and the ESTeem Model 195Eg is set for 0.25 Watts output power (Power Level = Min).
Download:
Mirror Download [FCC.gov]
Document ID977685
Application IDOGhtaVzXtIaJaelHM2PGXA==
Document Descriptionuser manual ch 8
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize146.73kB (1834176 bits)
Date Submitted2008-07-29 00:00:00
Date Available2008-08-01 00:00:00
Creation Date2008-07-23 10:46:53
Producing SoftwareGPL Ghostscript 8.54
Document Lastmod2008-07-23 10:46:53
Document Title195Eg Chapter 8 - Antenna Setup
Document CreatorPDFCreator Version 0.9.3
Document Author: Dan Tolley
FCC ID Filing: ENPESTEEM195EG-1

Navigation menu