Electronics Line 3000 EL2620 Security Keypad User Manual EL 2620

Download:
Mirror Download [FCC.gov]
Document ID	408546
Application ID	Sn254KMBNoz1sFz7JwxvdQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.26kB (140777 bits)
Date Submitted	2004-03-25 00:00:00
Date Available	2004-03-25 00:00:00
Creation Date	2003-11-30 08:54:10
Producing Software	Acrobat Distiller 5.0.5 (Windows)
Document Lastmod	2003-11-30 11:03:29
Document Title	Microsoft Word - EL-2620.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	steve

EL-2620
The EL-2620 is a wireless keypad for use with the infiniti control
panel. This keypad is primarily designed as an additional arming
station, including three arming keys that enable Full, Part or
Perimeter arming modes. Pressing the Full and Perimeter buttons
simultaneously generates an SOS panic alarm. Additionally, the
keypad may be used to control Home Automation modules.
The Cancel key, , clears the keypad in the event that a key is
pressed by mistake while entering a code, for example. This key
causes the keypad to disregard what was previously entered
enabling the user to start again.
A slide-out reference card on the rear of the keypad can be used for
writing down essential information such as Home Automation module
allocation. Note: Do not write user codes on the reference card!
Figure 1: EL-2620 (front view)
Registration
To register the EL-2620 to the receiver:
1.
2.
3.
Set the receiver to Registration mode.
Press a button on the keypad making sure that one of the Battery LEDs lights up when the button is pressed.
Wait for five seconds and press the same button again.
Wall Mounting
After registration, test the EL-2620 from the required
mounting location before permanently mounting to the wall.
To mount the EL-2620 to the wall:
1. Remove the back cover by inserting a small
screwdriver into the pry-off slots at the bottom of the
unit and twisting.
2. Secure the back cover to the wall using four screws.
Battery Replacement
Every time a key is pressed, one of the battery status
LEDs is lit. When the battery needs to be replaced, the
red Low Battery LED is lit.
To replace the battery:
1.
2.
3.
Transmitter
Battery
Tamper
Switch
Buzzer
Remove the back cover as explained above.
Observing correct polarity, replace the battery (9V alkaline).
Replace the back cover making sure that the two covers click shut.
Figure 2: EL-2620 (back cover off)
Technical Specifications
Antenna: Built-in whip
Frequency: 418MHz FM
Current Consumption: 26mA (transmission), 2µA (standby)
Power: 9V Alkaline Battery (Eveready 522)
RFI Immunity: 40V/m
Operating Temperature: 32-140°F (0 to 60°C)
Dimensions: 4.3”H X 5.1”W X 1.1”D (130 x 110 x 28mm)
FCC ID: RIYEL2620
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna, 2. Increase the separation between the equipment and the receiver, 3. Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected, 4. Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this equipment not expressly approved by the party responsible for compliance (Electronics Line 3000 Ltd.) could void the
user’s authority to operate the equipment.
Electronics Line 3000 Ltd.: 2 Granit Street, Kiryat Arieh, POB 3253, Petah Tikvah 49130 Israel. Tel: (972-3) 918-1333, Fax: (972-3) 922-0831
USA: 5637 Arapahoe Avenue, Boulder, Colorado 80303. Tel: (800) 683-6835, Fax: (303) 938-8062
UK: Unit 7, Leviss Trading Estate, Station Road, Stechford, Birmingham B33 9AE. Tel: (44-121) 789-8111, Fax: (44-121) 789-8055
France: ZI-61, rue du Marché Rollay, 94500 Champigny-Sur-Marne. Tel: (33-1) 45.16.19.20, Fax: (33-1) 45.16.19.29
All data is subject to change without prior notice. In no event shall Electronics Line 3000 Ltd. (EL3K) be liable for an amount in excess of EL3K.’s original selling price of
this product, for any loss or damage whether direct, indirect, incidental, consequential or otherwise arising out of any failure of the product.
ZI0312A (11/03)

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Copy, Annotate, Fill forms, Extract, Assemble, Print high-res
Create Date                     : 2003:11:30 08:54:10Z
Modify Date                     : 2003:11:30 11:03:29+02:00
Page Count                      : 1
Creation Date                   : 2003:11:30 08:54:10Z
Mod Date                        : 2003:11:30 11:03:29+02:00
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Author                          : steve
Metadata Date                   : 2003:11:30 11:03:29+02:00
Creator                         : steve
Title                           : Microsoft Word - EL-2620.doc

EXIF Metadata provided by EXIF.tools