Emerson 752I Users Manual Katana752i User’s Manual, #10006024 04

2015-01-05

• Regulatory Agency Warnings & Notices
• Contents
  • Figures
  • Tables
  • Registers
• Overview
  • Components and Features
  • Functional Overview
  • Additional Information
    • Product Certification
    • RoHS Compliance
    • Terminology and Notation
    • Technical References
• Setup
  • Electrostatic Discharge
  • Katana®752i Circuit Board
    • Identification Numbers
    • Connectors
    • Fuses
    • LEDs
  • Katana®752i Setup
    • Power Requirements
    • Environmental Requirements
  • Troubleshooting
    • Technical Support
    • Product Repair
• Reset Logic
  • General Overview
  • Reset Sources
    • CompactPCI Reset Enable
    • Power Monitor
    • 750GL Processor Reset
• Processor
  • Processor Overview
    • Features
    • Physical Memory Map
  • Processor Reset
  • Processor Initialization
    • Hardware Implementation Dependent 0 Register
    • Hardware Implementation Dependent 1 Register
    • Hardware Implementation Dependent 2 Register
  • Exception Handling
  • Exception Processing
  • Cache Memory
    • L1 Cache
    • L2 Cache
  • JTAG/COP Headers
• System Controller
  • Overview
  • CPU Interface
  • SDRAM Controller
  • Device Controller Interface
  • Internal (IDMA) Controller
  • Timer/Counters
  • PCI Interface
    • PCI Configuration Space
    • PCI Identification
    • PCI Read/Write
    • PCI Interface Registers
  • Doorbell Registers
    • Outbound Doorbells
    • Inbound Doorbells
  • Watchdog Timer
  • Reset
  • On-Card Memory
    • User Flash
    • SDRAM
    • EEPROMs
  • I2C Interface
  • GPIO Signal Definitions
  • Console Serial Port
• Device Bus PLD
  • Reset Registers
  • Interrupt Registers
  • Product Identification
  • PCI Enumeration
  • Revision Registers
  • Board Configuration Registers
  • Other Registers
• Real-Time Clock
  • Block Diagram
  • Operation
  • Clock Operation
• Local PCI Bus
  • PCI Enumeration
  • PCI ID Select and Interrupts
  • Geographical Addressing
  • PCI Bus Control Signals
• PTMC Interface
  • PTMC Installation
  • PTMC Connector Pinouts
• Ethernet Interfaces
  • Ethernet Address
  • Ethernet Ports
  • Front Panel Ethernet Connector Pinouts
  • Optional RMII PHY Devices
• IPMI Controller
  • SMB/IPMI Overview
  • I/O Interface
  • I2C Interfaces
  • IPMI Message Protocol
    • IPMI Network Function Codes
    • IPMI Completion Codes
    • Zircon PM IPMI Commands
    • Get Sensor Reading (Sensor/Event)
    • Master Write-Read I2C (Application)
    • Write Setting (OEM)
    • Read Setting (OEM)
    • Set Heartbeat (OEM)
    • Get Heartbeat (OEM)
    • IPMI FRU Information
    • IPMI Device SDR Repository
    • IPMI Event Messages
• Hot Swap
  • Hot Swap Logic (HSL) PLD
  • cPCI Functionality
  • Hot Swap LED and Ejector Switch Control
    • cPCI Hot Swap
    • Non-cPCI Hot Swap
  • Timing Considerations
  • HEALTHY* Signal
• CT Bus Interface
  • PICMG 2.15 Configuration 2
  • Katana®752i CT Bus Options
  • Clocking
  • Signal Control
  • CT Bus Routing Without the T8110 (option 1)
  • CT Bus Routing With the T8110 Installed (option 2)
    • Local CT Bus Operation
    • H.110 CT Bus Operation
• Backplane Signals
  • Overview
  • Pinouts
• Monitor
  • Command-Line Features
  • Basic Operation
    • Power-Up/Reset Sequence
    • Power-Up Timing
    • POST Diagnostic Results
    • Monitor SDRAM Usage
  • Monitor Recovery and Updates
    • Recovering the Monitor
    • Updating the Monitor via TFTP
    • Resetting Environment Variables
  • Monitor Command Reference
    • Command Syntax
    • Command Help
    • Typographic Conventions
  • Boot Commands
    • bootbus
    • bootcrc
    • bootd
    • bootelf
    • bootm
    • bootp
    • bootv
    • bootvx
    • rarpboot
    • tftpboot
  • JFFS2 File Systems
    • ls
    • fsinfo
    • fsload
    • chpart
  • Memory Commands
    • cmp
    • cp
    • find
    • md
    • mm
    • nm
    • mw
  • Flash Commands
    • cp
    • erase
    • flinfo
    • protect
  • EEPROM / I2C Commands
    • eeprom
    • icrc32
    • iloop
    • imd
    • ipmifirmload
    • imm
    • imw
    • inm
    • iprobe
  • Ethernet Controller EEPROM Commands
    • initeth4rom
    • filleth4rom
    • showeth4rom
  • Environment Parameter Commands
    • envinit
    • printenv
    • saveenv
    • setenv
  • Test Commands
    • diags
    • mtest
    • um
  • Other Commands
    • autoscr
    • base
    • bdinfo
    • coninfo
    • crc16
    • crc32
    • echo
    • enumpci
    • fpledoff
    • fruget
    • frugetuser
    • frusetuser
    • gethvr
    • getmonver
    • getpcimemsize
    • getpcimode
    • getphysloc
    • getspr
    • go
    • help
    • iminfo
    • isdram
    • loop
    • memmap
    • moninit
    • pci
    • reset
    • run
    • setpcimemsize
    • setpcimode
    • setspr
    • script
    • showmac
    • showpci
    • showtemp
    • sleep
    • vdhcp
    • version
  • Environment Variables
  • Troubleshooting
  • Download Formats
    • Binary
    • Motorola S-Record
• Acronyms
• Index
  • A
  • B
  • C
  • E
  • F
  • G
  • H
  • I
  • J
  • L
  • M
  • N
  • O
  • P
  • R
  • S
  • T
  • U
  • W
  • Z