Endress and Hauser Flowtec A30910AA Wireless Display Module User Manual Display modules A309 A310 for Proline 300 500
Endress&Hauser; Flowtec AG Wireless Display Module Display modules A309 A310 for Proline 300 500
User Manual
Products Solutions Services
Special Documentation
Display modules A309/A310
for Proline 300/500
Radio approvals for WLAN interface
SD01793D/06/EN/01.16
71331803
Radio approvals Display modules A309/A310 for Proline 300/500
2 Endress+Hauser
1 Radio approvals
1.1 Europe
This device meets the requirements of the Telecommunications Directive RED 2014/53/EU:
• ETSI EN 300 328 V1.9.1
• ETSI EN 301 489-1 V1.9.2
• ETSI EN 301 489-17 V2.2.1
• EN 62311: 2008
1.2 USA and Canada
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications made to this equipment not expressly approved by
Endress+Hauser Flowtec AG may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Display modules A309/A310 for Proline 300/500 Supplementary documentation
Endress+Hauser 3
Le présent appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio
exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
• L'appareil ne doit pas produire de brouillage, et
• L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Les changements ou modifications apportées à cet appareil non expressément approuvée
par Endress+Hauser Flowtec AG peut annuler l'autorisation FCC d'utiliser cet appareil.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour
un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un
minimum de 20 cm de distance entre la source de rayonnement et votre corps.
Ce transmetteur ne doit pas être placé au même endroit ou utilisé simultanément avec
un autre transmetteur ou antenne.
1.3 Japan
Japanese Radio Law and Japanese Telecommunications Business Law Compliance.
This device is granted pursuant to the Japanese Radio Law (電波法) and the Japanese
Telecommunications Business Law (電気通信事業法).
This device should not be modified (otherwise the granted designation number will become
invalid).
1.4 Additional countries
Additional national approvals on request.
2 Supplementary documentation
For an overview of the scope of the associated Technical Documentation, refer to the
W@M Device Viewer:
Enter the serial number from the nameplate of the measuring device to which the A309/
A310 is connected (www.endress.com/deviceviewer).
www.addresses.endress.com