Engineering Fitness Total Gym POWERTOWER Total Gym User Manual
Engineering Fitness International Corporation dba Total Gym Total Gym Users Manual
Users Manual
TotalGym.com | 800 541 4900
© 2011 Total Gym Global Corp
ACCESSORIES | INCLINE BODYWEIGHT TRAINING
Wireless Control Handle (Set of 2)
/ XXXXX
REPLACING OR USING ADDITIONAL
WIRELESS CONTROL HANDLES
If you must replace a lost or damaged handle or if you purchase a second set of
Wireless Control Handles for your PowerTower®, you will need to reprogram the
tower to accept the new handle code. The code in each set of Wireless Control
Handles is unique and is permanently set at the factory. The PowerTower must be
reprogrammed to accept the code of each handle set before it will accept wireless
control commands.
STEPS TO REPROGRAM
YOUR POWERTOWER
TO ACCEPT THE NEW
HANDLE CODE
1
Power Switch
STEP 1. Turn the red power switch to
the “Off” position on the back base of
the PowerTower unit.
2
STEP 2. Then turn the power switch
back to the “On” position. Within 10
seconds, insert a paper clip or similar
object into the hole in the top of the
tower and gently press into the hole as
shown. The LED will light up.
3
Safety KeyLED
Rocker Switch
STEP 3. Press and hold down either
button on the Wireless Control Handle
that you are programming.
If you are programming two
Wireless Control Handles:
• Press and hold one button on
the first handle. The LED light
will flash, then become steady.
• Within 3 more seconds, press
and hold one button on the
other handle. The light will flash
again and then become steady.
When the LED light turns off,
programming is complete and your
PowerTower will immediately respond
when the handle buttons are pressed.
NOTE: The Rocker Switch on the
top of the tower will always operate
the PowerTower, whether a Wireless
Control Handle is programmed or not.
FCC RULES
The PowerTower Wireless Control
Handle is a wireless transmitter that
complies with FCC Rules, Part 15.
Operation is subject to the following
two conditions:
1. this device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause
undesired operation.
RSS RULES
This device complies with Industry
Canada license-exempt RSS
standard(s). Operation is subject to the
following two conditions:
1. this device may not cause
interference, and
2. this device must accept any
interference, including interference
that may cause undesired operation
of the device.
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables
aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes:
1. l’appareil ne doit pas produire de
brouillage, et
2. l’utilisateur de l’appareil
doit accepter tout brouillage
radioélectrique subi, même si le
brouillage est susceptible d’en
compromettre le fonctionnement.
Lowers
incline level
Raises
incline level
FCC RULES
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user authority to operate the equipment.
The PowerTower Wireless Control Handle is a wireless transmitter
that complies with FCC Rules, Part 15. Operation is subject to the
following two conditions:
“This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.”