Eques Technology VEIU Smart Video Doorbell User Manual VEIU R26F manual Outline 4 6
Eques Technology Co., Limited Smart Video Doorbell VEIU R26F manual Outline 4 6
user manual
/VE.u Smart Video Doorbell Smart and Safe / User Manual aeoues 01 I Package Contents 5-0 o ‘ ° :6 ‘0 Bracket Outdoor Camera Indoor LCD Screen 1 piece 1 piece 1 piece fl Charger USB Cable Bolts 1 piece 1 piece 3 pairs ( 6 peices) 02 I Component Diagram Outdoor Camera Indoor LCD Screen PIR Motion :Jeoues Detector Camera Doorbell Button 5” Touch Screen Under the Power key, there is a system reset key which default status is "ON". If system is crashed, turn the key to the position of "OFF" with a needle object then turn it back to "ON”. Preview Key Power 03 I Installation Diagram Screen Self—adhesive Strips Peephole LCD Screen Preview Key Bolts Install Device with 1 screwdriver within 5 minutes Tips: 1. When fastening the outdoor camera, attach bolts into its poles first 2. When fastening the LCD Screen, align it to the notch of the bracket, its magnet will attach to the bracket automatically. 04 | Installation 1. Select the bolts depending 2. Peel Off the protective film on the door thickness, then off the adhesive strips. screw them to the outdoor camera. [- 3. Pass the ribbon cable 4. Tighten the outdoor camera. through the door hole. Tip: It will be easier to wrap the ribbon cable in a paper tube first then pass through. 5. Pass the cable through the 6. Attach the bolts through bracket indoor. the bracket after lightly Notes: don’t twist the ribbon tugglng up the ribbon cable. cable. 7. Align and screw the bolts 8. You may use a rubber band to the bracket and fasten. as pictured to secure the ribbon cable. 9. Pass the ribbon cable 10. Slightly press the cable through the rubber band as head into the port as pictured. pictured, then plug it onto the back of the LCD monitor. 11. Suspend the LCD monitor 12. Press the Power key for 5 on the bracket from top to seconds to turn on/of‘f your bottom, its magnet will be doorbell. attached automatically. 05 I Register and Add Your Device 5.1 | Download App Scan QR code to download the app, or seach "Eques" on App store/Google play. 5.2 | Start App After installing the app, click @ to start it. Eques 5.3 | Register, Login and Add Devices Fill the information as pictured In the "Device Manager" panel, then click " Sign up ". After click "+" to add a new device. completed, use this account to Choose the device above as login. Make sure you remember pictured. your login info. 5.4 | Input WiFi Information, Scan QR Code Note: Only 2.4a frequency band supported SGX 240v EQUEsiUniFi Input WiFi name and password as per Ul prompt then click "Start Binding". (Notes: the UI will prompt to enter the menu of searching QR code. ) EIEEEI SAMPLE EIHEE Scan the QR code by the camera of door viewer,when it gets the app successfullygo to next Click "Prepare Scan" on the previous step then generate a QR code, use the outdoor camera to scan this code. If you don’t know how to scan, you can click "Have a problem scanning QR Code?" on the previous step. 5.5 | Bind Device and Preview 0- r AT&T ’5‘ 16:39 52%. w After binding your door viewer with the app, use the play button on your smartphone enjoy the device. 00:00:08 Hold to talk You can swipe around the screen for more details when viewing your real-time video or you can hold your smartphone in landscape orientation for a full view. 06 I Applicable Door Thickness Outdoor Indoor Side angle Applicable door thickness: 1.4in — 4.3in (35mm ~ 110 mm) Applicable peephole: 0.6in - 2.0in (14mm ~ 50mm) When choosing bolts to install the outdoor camera, you must know your door’s thickness. Notes: For the door thickness between 1.4in - 2.6in (35mm ~ 65mm), choose 1.4in (35mm) short bolts; For the door thickness between 2.6in - 3.7in (65mm ~ 95mm), choose 2.6in (65mm) long bolts; For the door thickness above 3.7in (95mm), use your own M3 bolts around 3.2in (80mm). 07 I Safety Guideline Try to avoid placing the device in high-temperature, high humidity, dusty or other harsh environments as this may reduce its lifespan. Don't forcibly squeeze the camera lens and the black ball on the top of the outdoor subcomponent; otherwise it can cause hardware damage. Treat the ribbon cable with care during installation, don't forcibly drag, scrape or cut the ribbon cable. (The device will be out of warranty if it is damaged by inappropriate installation.) Make sure you use the charger that is included in the package. Unqualified chargers might cause damage to the device. | CONTACT PAGE CUSTOMER SERVICE EMAIL: cs@equeshome.com ADDRESS: 2100 Geng Road, Suite 210, Palo Alto, CA 94303, USA WEBSITE: www.equeshome.com Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. »- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. NOTE: This device and its antenna(s) must not be eo—located or operation in conjunction with any othcr antenna or transmitter RF Exposure Statement To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20cm the radiator your body. This device and is antenna(s) must not be co—loeated or operation in conjunction with any other antenna or transmitter
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Format : application/pdf Title : VEIU R26F manual-Outline 4_6 Creator : lenovo Metadata Date : 2017:05:19 16:02:59+08:00 Modify Date : 2017:05:19 16:04:43+08:00 Create Date : 2017:05:19 16:04:43+08:00 Creator Tool : Adobe Illustrator CC 2015 (Windows) Thumbnail Width : 256 Thumbnail Height : 112 Thumbnail Format : JPEG Thumbnail Image : (Binary data 13979 bytes, use -b option to extract) Instance ID : uuid:8da06c32-62eb-4cfd-bbe5-ae202f7e949a Document ID : xmp.did:e2f526a2-b141-fd4f-a622-bda138ab8a8c Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:b32a7939-aaba-48a8-b261-edb637647017 Derived From Document ID : xmp.did:E9E3E823B12068118083A02805A68E81 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:4E19FB36CD1FE611A61CF696FFF7E0D1, xmp.iid:e2f526a2-b141-fd4f-a622-bda138ab8a8c History When : 2016:05:22 11:43:09+08:00, 2017:04:06 13:51:40+08:00 History Software Agent : Adobe Illustrator CS6 (Windows), Adobe Illustrator CC 2015 (Windows) History Changed : /, / Manifest Link Form : EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference Manifest Reference File Path : J:\移康EQUES\E\2014马年\叮咚miniR19-R23-R26\R26使用说明书\叮咚图标.png, Andriod.PNG, IOS.PNG, C:\Users\Thinkpad\Desktop\待办事项\李景玉的图片\李景玉的图片\device-2017-03-04-164415.png, unnamed.jpg, unnamed-4.jpg, unnamed-3.jpg, unnamed-2.jpg, unnamed-7.jpg, unnamed-6.jpg Manifest Reference Document ID : 0 Manifest Reference Instance ID : 0 Ingredients File Path : J:\移康EQUES\E\2014马年\叮咚miniR19-R23-R26\R26使用说明书\叮咚图标.png, Andriod.PNG, IOS.PNG, C:\Users\Thinkpad\Desktop\待办事项\李景玉的图片\李景玉的图片\device-2017-03-04-164415.png, unnamed.jpg, unnamed-4.jpg, unnamed-3.jpg, unnamed-2.jpg, unnamed-7.jpg, unnamed-6.jpg Ingredients Document ID : 0 Ingredients Instance ID : 0 Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : True N Pages : 1 Max Page Size W : 2.952773 Max Page Size H : 4.330696 Max Page Size Unit : Inches Plate Names : Cyan, Magenta, Yellow, Black, 咖啡专 Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : 灰色 Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=0 M=0 Y=0 K=100 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 0.000000 Swatch Groups Colorants Magenta : 0.000000 Swatch Groups Colorants Yellow : 0.000000 Swatch Groups Colorants Black : 100.000000 Producer : Acrobat Distiller 11.0 (Windows) Page Count : 15 Author : lenovoEXIF Metadata provided by EXIF.tools