Euro Communication EquipementS TW1 TW1 User Manual POWER ON

Download:
Mirror Download [FCC.gov]
Document ID	3795245
Application ID	MkRLglCyUbe60orwWqFKWg==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	20.92kB (261477 bits)
Date Submitted	2018-03-26 00:00:00
Date Available	2018-03-27 00:00:00
Creation Date	2018-03-16 14:38:55
Producing Software	LibreOffice 6.0
Document Lastmod	2018-03-16 15:26:29
Document Title	POWER ON:
Document Creator	Writer
Document Author:	Nova

USER MANUAL
TW-1
CHARGE:
1. Put the earpiece in the charging case.
(Note: Each earpiece should be placed in its respective slots; Left earpiece on left side marked “L” &
Right earpiece on right side marked “R”)
2. Close the charging case.
3. Connect a micro-USB cable into the device socket of the Charging case.
Note: the charging case has an internal battery and can charge the TW1 even without
USB cable connected.
TW1 LED INDICATOR:
The LED will turn red while charging.
The LED will turn OFF once the battery is fully charged.
CHARGING CASE LED INDICATOR:
GREEN: Battery Full
RED:
Battery Low or charging
TURNING ON / OFF:
TW1 is in its charging case:
POWER ON:
Just Pick up the Earpiece from the charging case to turn ON automatically, Led turns
blinking GREEN within 3sec…
POWER OFF:
Put the Earpiece into the charging case and close to turn OFF automatically, Led
turns RED.
TW1 set alone:
POWER ON:
Long Press MFB for 2 seconds until LED is blinking GREEN and ascending tone can
be heard. Do the same on the second unit.
NOTE: Turn ON the second unit; it will automatically reconnect to the paired earpiece.
POWER OFF:
Long Press MFB button until Led turns RED and descending beep will be heard.
Note: Turn OFF any of the 2 paired units will also turn OFF the other paired unit.
PAIRING TW1 TO A BLUETOOTH MOBILE PHONE:
(Pairing must be done first time only)
1. Remove the two earpieces from the charging case.
2. On your Phone:
- Turn ON the Bluetooth function then search for devices.
3. Select TW-1 on the list of devices to have the phone connected.
(Enter pincode “0000” if requested)
The led will be blinking once TW-1 successfully paired to the phone and ready to use.
Notes:
- please disconnect or turn Off the Bluetooth of any previously paired phone
- The unit will automatically OFF if no phone connected for more than 5minutes.
USING TW-1 WITH A BLUETOOTH MOBILE PHONE:
A2DP MUSIC STREAMING
PLAY/PAUSE A2DP:
Short Press MFB button to Play/Pause Music.
GO TO NEXT SONG:
Double Press MFB button to go to the next song.
PHONE CALL (Left only):
Answer Call:
Short Press MFB to accept incoming call.
End Call:
Short Press MFB to end ongoing phone call.
Reject incoming call:
Long Press MFB for 2sec. to reject incoming call.
Voice dial:
Long Press MFB for 2sec. to activate voice dialing.
Note: If the Right (slave) TW1 is not present , after ON, the Left (Master) needs a Short Press MFB
to reconnect to Phone.
Specifications:
Bluetooth: version 4.2
Frequency range: 2.402 – 2.480GHz
Power: 8dBm EIRP
Operating temperature: 0 - 45°C
Charging temperature: 10 - 40°C
Battery type: Litium-ion rechargeable.
FCC ID: QVNTW1
WARNING: To prevent possible hearing damage, do not listen at high volume levels
for long periods.
English
FCC/IC statements :
Federal Communications Commission (FCC) Statement
Industry Canada (IC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could
void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC/IC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures :
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules and Industry Canada licence-exempt RSS standard(s)
Operation is subject to the following two conditions :
1)This device may not cause interference and
2)This device must accept any interference, including interference that may cause undesired operation of the device.
FCC/IC RF Radiation Exposure Statement :
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. End users
must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Euro-CB is under license. Other trademarks and trade names are those of their respective owners.
English
Hereby, EURO COMMUNICATION EQUIPEMENTS declares that the radio equipment type TW1 is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.SuperTooth.net/download
Euro Communication Equipements sas
sas
Route de Foix D117
11 500 NEBIAS
FRANCE
French
Déclarations FCC / IC :
Commission Federale des Communications (FCC)
Déclaration Industrie Canada (IC)
15,21
Vous êtes averti que les changements modications non expressément approuvés par la partie responsable de la
conformité pourraient annuler l'autorité de l'utilisateur d'exploiter cet équipement.
15.105 (b)
Cet équipement a été testé et jugé conforme aux limites pour un appareil numérique de classe B, conformément à la
partie 15 des règles de la FCC / IC. Ces limites sont conçues pour fournir une protection raisonnable contre les
interférences nuisibles dans une installation résidentielle. Cet équipement génère, utilise et peut émettre des
fréquences radio et, s'il n'est pas installé et utilisé conformément aux instructions, peut causer des interférences
nuisibles aux communications radio. Cependant, il n'existe aucune garantie que ces interférences ne se produiront pas
dans une installation particulière. Si cet équipement provoque des interférences nuisibles à la réception radio ou
télévision, ce qui peut être déterminé en éteignant et rallumant l'équipement, l'utilisateur est encouragé à essayer de
corriger l'interférence par une ou plusieurs des mesures suivantes:
- Réorienter ou déplacer l'antenne réceptrice.
- Augmenter distance entre l'équipement et le récepteur.
- Brancher l'équipement dans une sortie sur un circuit différents-de celui sur lequel est branché le récepteur.
Consulter le revendeur ou un technicien radio / TV qualifié.
Cet appareil est conforme a la partie 15 des regles FCC et aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence.
L'opération est soumise aux deux conditions suivantes:
1) Cet appareil ne peut causer d'interférences et
2) Cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais
fonctionnement de l'appareil.
FCC / IC Déclaration d'exposition aux radiations RF:
Cet équipement est conforme aux normes FCC / IC limites d'exposition aux radiations dans un environnement non
contrôlé. Les utilisateurs doivent suivre les instructions de fonctionnement spéciques de la conformité d'exposition aux
RF. Cet émetteur ne doit pas être co-localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Euro-CB is under license. Other trademarks and trade names are those of their respective owners.
French
Le soussigné, EURO COMMUNICATION EQUIPEMENTS,
EQUIPEMENTS déclare que l'équipement radioélectrique du type TW1 est
conforme à la directive 2014/53/UE. Le texte complet de la déclaration UE de conformité est disponible à l'adresse
internet suivante:
http://www.SuperTooth.net/download
Euro Communication Equipements Sas
Route de Foix D117
11 500 NEBIAS
FRANCE

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Print high-res
Language                        : en-US
XMP Toolkit                     : Adobe XMP Core 5.6-c015 84.159810, 2016/09/10-02:41:30
Format                          : application/pdf
Creator                         : Nova
Title                           : POWER ON:
Create Date                     : 2018:03:16 14:38:55+08:00
Creator Tool                    : Writer
Modify Date                     : 2018:03:16 15:26:29+08:00
Metadata Date                   : 2018:03:16 15:26:29+08:00
Producer                        : LibreOffice 6.0
Document ID                     : uuid:e429322d-91a3-4d1a-9d1a-d8f842038d45
Instance ID                     : uuid:c2320901-ae7e-4f8e-9c24-528356309570
Page Count                      : 4
Author                          : Nova

EXIF Metadata provided by EXIF.tools