Eurosun 1B143BT Bluetooth Karaoke Speaker User Manual HY PKRK ASST Manual SS2
Eurosun International Limited Bluetooth Karaoke Speaker HY PKRK ASST Manual SS2
Eurosun >
Users Manual
Wireless Karaoke
Mic & Speaker
Operation Manual 1B143BT
MADE IN CHINA
Thank you for purchasing the Wireless Karaoke Mic
& Speaker. Please read all instructions carefully before
using and retain this manual for future use and reference.
PACKAGE CONTENTS
• Wireless Karaoke Mic
• Micro USB Charging Cable
• Operation Manual
KEY FEATURES
• Compatible with Bluetooth®-enabled devices
• Built-in rechargeable battery
• Built-in speaker
• Volume and echo control
SAFETY INSTRUCTIONS
Keep the unit away from heat sources, direct sunlight,
humidity, water and any other liquids.
Do not operate the unit of it has been exposed to water,
moisture or any other liquids to prevent against electric shock,
explosion and/or injury to yourself and damage to the unit.
Do not use the unit if it has been dropped or damaged in any
way.
Repairs to electrical equipment should only be performed by
the manufacturer. Improper repairs may place the user at
serious risk.
Do not puncture or harm the exterior surface of the product in
any way.
Keep the unit free from dust, lint, etc.
Do not use this unit for anything other than its intended use or
purpose. Doing so may damage the device.
This product is not a toy. Keep out of reach of children.
Do not expose batteries, battery pack, or batteries to installed
to excessive heat, such as direct sunlight, or open flame.
CHARGING THE KARAOKE MIC
The karaoke mic comes with a built-in rechargeable battery.
Before using it for the first time, we recommend you charge
the battery fully. Only use the supplied charge cable to
charge the speaker.
Connect the USB end to a computer USB port or a USB wall
charger and the micro USB to the charge port on the karaoke
mic. The red LED indicator will illuminate while the karaoke mic
is charging.
A full charge of the battery takes around 2.5 hours. When the
battery is fully charged, the LED indicator will turn off.
Disconnect the karaoke mic at this point. The karaoke mic will
then be ready for use.
When the battery is low, the LED indicator will flash red and
emit three tones every 20 seconds. When this occurs, please
recharge the karaoke mic. When using your karaoke mic with
an iPhone, the top right corner will indicate your karaoke
mic’s battery life.
PROMPT NOTIFICATION
• The karaoke mic will notify you during “Power On” with the
sound of a beep.
• The Karaoke mic will notify you during "Power off" with a
prompt tone.
• The karaoke mic will notify you when “Pairing Successful”
with the sound of a beep.
PAIRING THE KARAOKE MIC
1. Ensure the karaoke mic is turned off. If it is not, please turn off
the karaoke mic first before pairing.
2. Press and hold the multifunction button for 3 seconds until
the blue LED indicator flashes. This will indicate your karaoke
mic is now in pairing mode.
3. Place the karaoke mic and the Bluetooth® device to which
you would like to pair it within the operating distance. We
recommend keeping the two devices no further than 3 feet
apart.
4. Ensure Bluetooth is enabled on your device. Refer to the
manufacturer’s instructions for how to enable Bluetooth on
your device.
5. Once you have activated Bluetooth on your device, select
the karaoke mic “HY-PKRK” from the list of available Bluetooth
devices.
6. If required, enter the PIN code "0000" and confirm the entry.
Note: If pairing is unsuccessful, turn off the karaoke mic first
and re-pair following the aforementioned steps. Once you
have paired the karaoke mic with a device, the karaoke mic
will remember this device and will pair automatically when
the device’s Bluetooth is activated and in range. You do not
need to re-pair any previously connected devices.
OPERATING THE KARAOKE MIC
Playing music wirelessly
Once the karaoke mic is paired to your device, you can
stream music wirelessly to the built-in speaker. Select the track
you wish to listen to on your device to play through the
speaker. Should you encounter any problems while
streaming, please refer to your device’s user manual.
Adjust Voice Echo
Push the echo switch up or down to adjust voice echo.
Adjust Voice Volume
Push the volume switch up or down to adjust voice volume.
SPECIFICATIONS
Bluetooth® Version: V2.1+++EDR
Operating Distance: Up to 33ft (10m)
Pick Up: Capacitive
Speaker Output: 3W
Frequency Range: 2402-2480MHz
Sensitivity: 80db-115db
Play Time: Up to 3 hours
Battery Type: Lithium Battery
Battery Capacity: 1000mAh
Charging Voltage: DC 5V
Charging Time: Up to 2.5 Hours
Charging Interface: Micro USB
Weight: 0.529 lb / 0.24 kg
CARE AND MAINTENANCE
• Do not expose the unit to excessive heat or humidity to
avoid damage to the product's internal circuitry.
• Do not use abrasive cleaning solvents to clean the unit.
• Do not expose the unit to extremely high or low
temperatures as this will shorten the life of the electronic
device, destroy the battery, and/or distort certain plastic
parts.
• Do not dispose of the unit in fire as they may explode or
combust.
• Do not expose the unit to contact with sharp objects as this
will cause scratches and damage.
• Do not let the unit fall from high places, as doing so may
damage the internal circuitry.
• Do not attempt to disassemble the unit.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference
that may cause undesired operation.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR
PERIPHERAL
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARRANTY INFORMATION
The condition of this warranty and our responsibilities
under this warranty are as follows:
Supplier’s warranty is non-transferable. And this warranty is
limited to the original purchaser only.
* You must be able to prove the date of original purchase
of the unit with a dated receipt.
* The warranty is not applicable if the product has been
subject to physical abuse, improper installation,
modification or repair by unauthorized third party.
* The responsibility of supplier’s products shall be limited to
the repair of replacement of the product as its sole
discretion.
* Specifically exempt from any warranty are limited-life
consumable components subject to normal wear and
tear such as batteries, decorates and other accessories.
* A supplier will not take any responsibility if the failure of the
unit has resulted from accident, abuse, misuse, or any
unauthorized repair, modification or disassemble.
* Modification and repair of the unit should be done by
authorized and qualified service personnel, Center or
returned to the manufacturer.
* This warranty gives you specific legal rights, and you may
also have other rights which vary under local laws.
The following conditions comprise the requirements and
scope of our warranty conditions and do not affect our
legal and contractual warranty obligations.
We offer a warranty on our products in accordance with
the following conditions:
1) The products are covered by a 3 month warranty.
We will resolve damages or defects on our products
free of charge within 3 months of the purchase date
under the following warranty conditions. For any damage
or defect determined later than 3 months after the
purchase date, proof of a manufacturing fault must be
submitted for repair under warranty.
2) The warranty does not cover batteries and other parts,
which are considered consumables, parts that break easily
such as glass or plastic or defects based on normal wear
and tear. There is no warranty obligation in the event of
marginal differences compared to the target appearance
and workmanship provided these have a negligible effect
on the product’s fitness for use, in the event of damage
caused by chemical or electrochemical effects, by water
or generally from abnormal conditions.
3) The warranty will be performed in such a way that we
shall decide whether to repair the defective parts or to
replace them with working parts free of charge. We
reserves the right to exchange the product for a
replacement product of equal value if the product sent in
cannot be repaired within a reasonable time or at a
reasonable cost. Requests cannot be made for repairs to
be carried out on site. Parts that have been replaced or
exchanged become our property.
4) The warranty claim does not apply if repairs or other
work is carried out by unauthorized persons or if our
products are equipped with additional parts or
accessories that are not approved for our product.
5) Warranties that have been activated do not cause the
warranty period to be extended, nor do they trigger a
new warranty period. The warranty period for any
replacement parts installed ends with the warranty period
for the entire product.
6) Any other further claims are excluded, especially those
for replacement due to damage caused to the outside of
the product, provided there is no obligatory legal liability.
We therefore accept no liability for accidental, indirect or
other consequential damage of any kind, which leads to
usage restrictions, data loss, and loss of earnings or
interruption to business.
Asserting a warranty claim:
1) To make use of the warranty service for hardware issues,
you must contact the our Service Center by email at
support@dglusa.com
2) We will try to diagnose and solve your problem. If it is
determined that a warranty claim exists, you will be given
an RMA number (Return Material Authorization) and will
be asked to send the product to US
.
IMPORTANT: We will only accept parcels that have an
RMA number.
Please observe the following when sending the product:
1) Send the product suitably packaged with carriage and
insurance paid. Do not enclose any accessories with the
product (cables, chargers, manuals, etc.) unless the
Service Center specifies otherwise.
2) Mark the RMA number on the outside of the package in
such a way that it is visible and clearly legible.
3) You must enclose a copy of the sales slip as proof of
purchase.
4) Once we has received the product, it will meet its
warranty obligations in accordance with the warranty
conditions and will return the product to the sender with
carriage and insurance paid.
Service outside of warranty
We can refuse any service claim made that is not
covered by the warranty.
If we agrees to provide a service outside the warranty,
the customer will be invoiced for all repair and transport
costs. We will not accept any packages that have not
first been approved by means of an RMA (Return
Material Authorization).
Contact us with questions at:
Support@dglusa.com
1 3 4 5 6 7 8
This equipment complies with FCC radiation exposure
conjunction with any other antenna or transmitter.
limits set forth for an uncontrolled environment .
This transmitter must not be co-located or operating in
Any Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.