Everex Electronics CMP821 7 INCH HIGH DEFINITION TOUCH SCREEN TABLET User Manual

Everex Electronics Ltd 7 INCH HIGH DEFINITION TOUCH SCREEN TABLET

User manual

1 Please setup Gmail account during initial device setup. If you are going to use a password or a pattern unlock you must have a valid Gmail account setup in the event you forget either. Forgot lock pattern? Here's a way to reset it.  With wrong pattern lock continues for 3 consecutive times ( first time is 5 consecutive times ) then wrong pattern reminder screen will appear “User name” and “password”  Enter your Gmail account user name and password.  Make sure you use the same account that was used to activate the device and double check the password by logging in to that Google ™ account in a browser on laptop or PC.  If you don't have access to the original Gmail account, you will need to do a hard reset and lose your settings and apps on the device. Data on the memory card will not be erased.
2 This device complies with part 15 ofthe FCC Rules. Operation is subject tothe following two conditions: (1)Thisdevice may not cause harmfulinterference, and (2) this device mustaccept any interference received,including interference that may causeundesired operation.changes or modifications not expresslyapproved by the party responsible forcompliance could void the user'sauthority to operate the equipment.This equipment complies with FCCradiation exposure limits set forth foran uncontrolled environment .The devicehas been evaluated to meet general RFexposure requirement. The device can beused in portable exposure conditionwithout restriction.
3
4
5 This manual contains important safety precautions and information for correct usage. Please be sure to read this manual carefully before use to avoid any damage to the device.  Do not place the product in hot, wet or dusty environments.  Do not place the product in hot environments. Especially in summer, do not place it in a car with all the windows closed or in the sun.  Avoid dropping or smashing the product and do not shake the TFT screen excessively as it may cause damage or abnormal display screen.  Select a suitable volume and avoid loud sound while using headphone/earphones. Turn down the volume or stop using the product if your ears start hurting or ringing.  In the following situations, please charge the product: A. The device shows on the top of the screen. B. System automatically shuts down, and it turns off soon after restart. C. Operation buttons do not work properly. D. The unit will not turn on. Note: Chargers of other models cannot be used for this device because they may cause damage to the device that will void the warranty. Please contact our customer service department if you need a replacement charger.  Do not disconnect the device while formatting, downloading and/or uploading; otherwise, application errors may occur.  We are not responsible for any memory erasure or loss caused by damage or product maintenance, or other personal reasons.  Do not disassemble the product, and avoid cleaning the product with ethyl alcohol, thinner, or benzene.  Do not use this product in areas which prohibit the use of electronic devices, for example, in an airplane.  Do not use this product while driving or walking in the street, as it may cause a car accident. Notes:  This device is not waterproof.  All images in this manual are for reference only. Specifications and appearance of the product and the screens are subject to change without prior notice.
6 POWER SOURCE U Battery Recharge The device has Recharging a built-in DC 3.7V rechargeable Lithium-ion batteries. Recharge as follows:  Insert the micro USB plug from the supplied USB connection cable to the Micro USB jack on the device. Plug the full-size USB jack of connection cable to supplied AC/USB Adaptor to wall outlet having AC 100-240V~, 50/60 Hz.  During charging, the on screen charging icon will turn on. When finished, it will show fully charged icon. This power unit is intended to be in a vertical or floor mount position. Notes: Your battery will last longer if you follow these simple guidelines for caring for and storing it. 1. Using the supplied AC/USB Adaptor for charging only. Other models charger may damage the device. 2. For charging first time, charge it approximately 10 hours. For normal charging, it needs approximately 4 hours. 3. Recharge and store the device within the temperature range of 5°C~35°C (40°F~95°F). 4. Do not overcharge (longer than 24 hours). Excessive charging or running the unit until battery goes empty will damage battery. Battery life will be extended if you keep the battery fully charged. 5. Battery life naturally shortens slowly over time. 6. The rechargeable battery incorporated in this product is not user replaceable. Using the touch screen  Touch the corresponding button on the touch screen with your finger.  Touch the screen and swipe from Right to Left; Left to Right to scroll the pages. Notes: A: Do not use force when touching the touch screen, as it may damage to the screen. B: To avoid damaging the touch screen, do not use any object other than your fingers. C: Do not touch on the touch screen if your fingers are not clean. D: Do not touch on the touch screen with gloves on. E: The touch screen may not function if you use a fingernail or other instruments Micro SD card This device supports a Micro SD Memory Card (Card not included). To increase memory size, insert a Micro SD card into the card slot on the side of unit as the figure below:
7 Notes: A. Insert the card (Up to 32GB, not included) into the card slot on right side , The card metal chip for your face B. To take out the card, press the card until a “click” is heard then pulls out the card. C. Before replacing the storage card, make sure the unit has been powered off. D. When inserting the storage card, make sure the direction you select is correct. Never insert violently to avoid damaging the card or the unit. If the storage card doesn’t work, please check if the direction is correct. E. When the card is used for the first time, or it has been used in another device, please format it first through the Computer. You also need to download the desired music, photos and/or movie onto the card before installing into the unit Important: Formatting the Micro SD Card will delete all the data on the card. Download the data to your computer before formatting the card. Micro USB Port (USB OTG) This device supports USB device for extending the memory size, or USB Thumb Drive, inserts the supplied USB cable (micro USB plug to Full size USB female jack) into the micro USB port on the side of unit. Insert USB device into Full size USB female jack, like in the PC. Notes:  Before replacing a USB drive, make sure the unit has been powered off.  When inserting the USB driver, make sure the direction you selected is correct. Never insert violently to avoid damaging the USB driver or the unit. If it doesn’t work, please make sure if the direction is correct. Power on/off the Device A. Press and hold the button on the right cabinet approximately 5 seconds to power on the unit. Touch and slide the key bar shown on the screen to from below to above unlock B. In power on mode, press the button to turn off the screen for saving battery power. Press again to turn it on. C. To power off the device, press and hold the button until the “Power off” window pop up, touch the “Power off” and show ” shut down” message, the device will to power off Reset: If the device becomes abnormal, halts, freezes. Press the RESET Button in the reset hole on the rear of device (see figure as below) with a small screwdriver (not included) to reset the device.
8 Location of Controls 1) Power 2) Headphone Jack 3) Micro USB Port (For battery charging & OTG) 4) Mini HDMI Port 5) Micro SD Card Slot 6) RESET button (Inside the hole) 7) Front camera 8) Rear camera 9) Speaker
9 Connections: Connect to PC A. Connect the Device to the PC via the Micro USB port on the side of cabinet to the USB port on your PC by the supplied connection cable. B. Then the screen appear “Allow USB debugging”, Touch “OK”, the name “CMP821” disk will display on your computer. Earphone / Headphone jack: For private listening, connect an Earphone/Headphone to the Headphone jack on the right side of cabinet. The speaker will cut off automatically (Earphone/Headphone not included) Connect to HDMI TV A: Connect the device to a TV (with HDMI port) via the Mini HDMI jack on the side of the unit to the HDMI port on the TV. (Connection cable not included). B: The device will activate the HDMI connection automatically. C: The tablets display content will show on TV.
11 Getting Started On home page, touch the" " button on the bottom middle, the following picture will appear on the screen:  Touch the Settings ( ) button on the screen, the setting menu will appear on the screen, then:  Touch on the screen and move Up or down to show more selections.  Choose the corresponding button you need to set. The sub-setting menu will appear on the screen, follow on screen instructions. WIRELESS & NETWORKS To browse the web; connecting to apps store, use E-mail, Facebook™, Twitter™…you must connect this unit to internet by Wi-Fi as below: 1. Touch on the Wi-Fi “OFF” button then slide it to the right to turn Wi-Fi ON, wait a few seconds, the available Wi-Fi networks will appear. 2. Touch on the desired network to start connection as on screen instructions. (Maybe ask for password). NB: After setting, you can turn it ON or OFF by touching the ( ) widget on the screen. ☆The device automatically scans and lists all local Wi-Fi Network found. ☆Touch the top-right corner “ ” and choose “Add network” follow the prompts to add your network.
12 DISPLAY Brightness level: To adjust the screen brightness by moving the scaling bar. Wallpaper: To choose and set the wallpaper screen. Sleep: To enable sleep mode and select time to sleep while not in operation. Font size: To adjust the display Font Size. DESKTOP
13 Status Bar  • The Status Bar lies at the bottom of the screen. Operation．R Below are some advises on how to operate the operation zone:  • By touching the icon, you can get back to the previous screen.  • By touching the icon, you can get back to the homepage wherever interface you are in.  • By touching the icon, a window popup which shows the all apps in operation.  • By touching the icon, you can decrease the sound volume.  • By touching the icon, you can increase the sound volume.  • The Status Bar lies at the top of the screen  • The icon for WIFI signal  • The icon for Show battery status  • The icon for Time • In the main menu interface, you can open and operate any app by touching on the icons to run applications such as Explorer, Browser, Music,Video, as well as during web browsing or PDF viewing, you can drag the menu, by sliding the screen to scrolling up and down the page as well as to enable the page to move different directions respectively. Application Management  Downloading AndroidTM Applications: ☆ Pre-loaded App stores such as Google PlayTM is providing many interesting and free applications for downloads. Individual app store may ask for credit card information and personal details. Please be caution that some application may require to pay.  Downloading Android Applications direct from a Website You can download Android applications directly from websites, and then quickly and easily install them on your device.  Touch the Browser application icon to launch the internet browser.  Enter the desired website URL, and touch the download link for the application you want to install on your device.  After the download is complete, touch on the download file (in the Apps under setting screen), Touch Open → Install.
16 A: Touch the “Explorer” icon on the apps page, will be shown in above picture. B: Select the file or folder you want to do action as below, touch and hold the file about 2 seconds, Pop-up menu will display different options File operation as Delete File, Rename File, Copy File, Move File, Email File and send by Bluetooth and Property etc. C; Touch the “Copy ” and touch “ ” skip to main directory.select “Internal Memory，SD card and USB storage ; Then touch “”.will be shown in above picture.
17 D: Touch the “Paste”, the file will copy and display on the screen. Google Play Music Using the pre-loaded “Play Music” Player to play audio files: ☆ Audio file formats supported: MP3 The “Play Music” player will automatically load the music files from the SD/USB/Local Disk to the playlist after turning on the “Play Music” player. Video ☆ Video file formats supported: H.264, VC-1, AVI and RMVB. In the main menu, touch the icon to enter “Video”. It will list all the video files Choose video files from Local Disk or External storage card in the video player playlist. The system will automatically load the video file form external storage or local disk to the playlist after turning on the Video. The playlist as shown in the below figure:
18 Frequently Asked Questions  Android Q: What Android OS version is on my Device? A: Android 6.0, Marshmallow  Basic Device Functionary Q: Do I have to charge the battery before use? A: You should charge the battery for at least 4 hours, but you can use the device while it’s charging. Use the included power adapter to charge; this device charge via USB cable.  Email Q: Can I use any of my personal email addresses to send/receive email? A: The device supports POP3 and SMTP accounts. Some free email accounts are not supported on mobile devices. Check with your email provider to see if your account is supported.  Media Cards Q: Which media cards are compatible with my Device? A: Micro SD card.  Music Q: How do I add music files to my device? A: Copy the music files from your computer onto a micro SD card or USB storage device, and then use the “Explorer” application to copy the files into the device.  Photos Q: How do I add photo files to my device? A: Copy the photo files from your computer onto a micro SD card or USB storage device, and then use the” Explorer “application to copy the files into the device.

Navigation menu