Everflourish Electrical EF301T Remote Control Transmitter User Manual
Everflourish Electrical Co., Ltd. Remote Control Transmitter
User Manual
TRANSMITTER – EMW301T
USER INSTRUCTION
A. Features
1. Easy and simple to use.
2. Controls up to 5 channels ((1ON，1OFF… …5ON，5OFF); and each channel can command more than one
receiver.
3. The “ALL OFF” and “ALL ON” buttons command all connected appliances with one single operation.
4. Blinking blue LED indicates signal transmission status.
B. Diagram & Descriptions
No.
Description
Function
i
Blue indicator
The blue indicator blinks to indicate signal transmission status.
ii
1OFF，1ON
Switch on and off the appliances connected to channel 1 receiver EMW300R
iii
2OFF，2ON
Switch on and off the appliances connected to channel 2 receiver EMW300R
iv
3OFF，3ON
Switch on and off the appliances connected to channel 3 receiver EMW300R
v
4OFF，4ON
Switch on and off the appliances connected to channel 4 receiver EMW300R
vi
5OFF，5ON
Switch on and off the appliances connected to channel 5 receiver EMW300R
vii
ALL OFF
ALL ON
Switches off all connected appliances.
Switches on all connected appliances.
C. Operation
1. Configure
1
2
3
4
5
6
7
Hold the“ON/OFF Learning Code ”button on the receiver until the blue LED “Indicator” blinks. Then press any one
of the five “OFF” buttons until the blue LED “Indicator” goes off. The receiver is trained to respond to the
corresponding channel.
Remark: Each transmitter EMW301T controls up to 5 channels. Each channel can command as many receivers as
desired.
2. Control
Press the “ON” or “OFF” button to switch on or off the appliance connected to the receiver trained to the
corresponding channel.
3. Group Control
Press the “ALL OFF” or “ALL ON” button to switch off or on all appliances irrespective of the individual channel.
D. Caution:
Federal Communications Commission (FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Industry Canada (IC)
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la norme RSS d'Industrie Canada. Son fonctionnementestsujet aux deux conditions suivantes:
(1) ledispositif ne doit pas produire de brouillagepréjudiciable, et
(2) cedispositifdoit accepter tout brouillagereçu, y compris un brouillage susceptible de provoquer un
fonctionnementindésirable.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. Déclarationd'exposition
aux radiations:
Cetéquipementestconforme aux limitesd'exposition aux rayonnements IC établies pour un environnement non contrôlé.
Warning:
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Avertissement :
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but
de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire à l'établissement d'une communication satisfaisante
E. Specifications
1. Battery : CR2032L
2. Frequency : 433.92 MHz
3. Distance : 50 meters max. (in the open air)
F. Holder
Manufactory: Everflourish Electrical Co., Ltd.
Adress:Renjiu Village, Wuxiang Town, Yinzhou Ningbo 315111 P.R. China