User manual
Model: A7Model: A7
Wi-Fi Connecon
Choose one you want to connect, and follow up step by step.
BT Connecon
Bluetooth
Choose a device and paring.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interferenceto radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐Consult the dealer or an experienced radio/TV technician for help important announcement
FCC RF Exposure Information and Statement:
The SAR limit of FCC is 1.6 W/kg averaged over one gram of tissue. Device (FCC ID: 2AIKX-
AIOPCA7) has also been tested against this SAR limit. This device was tested for typical body-worn
operations with the back of the device kept 0mm from the body. To maintain compliance with FCC RF
exposure requirements, use accessories that maintain a 0mm separation distance between the user's
body and the back of the device. The use of belt clips, holsters and similar accessories should not
contain metallic components in its assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements, and should be avoided.