FEIBIT ELECTRONIC TECHNOLOGY FZB57A3PF ZigBee module User Manual

SHENZHEN FEIBIT ELECTRONIC TECHNOLOGY Co., LTD ZigBee module

Users manual

UserGuideFZB57A3+modulebelongstoTImodulethatusuallyusedingateway’sdevelopment.Ashieldingcaseonitistoinsulatefromexternalsignals.IthasanIPEXantennatoconnectionexternalantenna,whichisusedtoenhancethesendingandreceivingsignalsofthemodule;FZB57A3+module,atotalof20pin,asforgatewaydevelopment,onlyeightofpinareused,functionofotherpinforthedevelopers.Inaddition,modulealsoretainedtheDEBUGinterfaceandUARTinterface.PinAssignments:Pin number  Name  I/O  Description 1 GND - Ground 2 VDD I Power(+3.3V) 3  P2.2 O The simulator debugs clock line 4  P2.1  I  The simulator debugs data line 5 P2.0 I/O  6 P1.7 I/O  7 P1.6 I/O  8 P1.5 I/O  9 P1.3 I/O  10 P1.2 I/O  11 P1.0 I/O  12 P0.6 I/O  13 P0.5 I/O  14 P0.4 I/O  15  P0.3 O UART TX Signal 16  P0.2  I  UART RX Signal 17 P0.1 I/O  18  P0.0 I/O  19  Z_RESETn  I  System RESET signal, low level effective 20 GND - Ground
Features:  Follow IEEE802.15.4 Standard  8-KB RAM   ZigBee Systems(256-KB Flash)  Home/Building Automation   Industrial Control and Monitoring   Low-Power Wireless Sensor Networks  Consumer Electronics  Health Care  Supply Voltage 2.0V-3.6V   Operation frequency: 2405-2480MHz   Conform to ZigBee Standard,support ZLL and ZHA.  Support IPEX Antenna   Use UART communication,and support to upgrade software by UART  Integrate with 2.4G low power consumption of transceiver
FCC compliance This device complies with Part 15 of the FCC Rules. Part Number  FCC ID FZB57A3+ 2AE8BFZB57A3PF      Operation is subject to the following two conditions: (1)this device may not cause harmful interface,and (2)this device must accept any interface received,including interface that may cause undesired operation.      Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device must be installed and used in strict accordance with the manufacturer’s instructions as described in the user documentation that comes with the product.         Warning for FZB57A3+:This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. The final end product must be labeled in a visible area with the following:Contains FCC ID: 2AE8BFZB57A3PF.         The OEM integrator is responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emission, PC peripheral requirements, etc.). 
FCCWarningStatementChangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidtheuser’sauthoritytooperatetheequipment.ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.Thisequipmentgeneratesusesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstructions,maycauseharmfulinterferencetoradiocommunications.However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipmentoffandon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:‐‐ Reorientorrelocatethereceivingantenna.‐‐ Increasetheseparationbetweentheequipmentandreceiver.‐‐ Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.‐‐ Consultthedealeroranexperiencedradio/TVtechnicianforhelp.FCCCaution:Anychangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidtheuser’sauthoritytooperatethisequipment.Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:(1)Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.FCCRadiationExposureStatement:This2.4GModulecomplieswithFCCradio‐frequencyexposureguidelinessetforthforanuncontrolledenvironment.ThisdeviceisintendedonlyforOEMintegratorsunderthefollowingconditions:(1)AccordingtoFCCPart15SubpartCSection15.212,theradioelementsofthemodulartransmittermusthavetheirownshielding.ThismoduleisgrantedasaSingleModularApproval.(2)ThisdevicehasbeendesignedtooperatewithaExternalantennahavingamaximumgainof2dBi(max.).Onlythistypeofantennamaybeused.(3)IntegrationistypicallystrictlyrestrictedtoGranteehimselfordedicatedOEMintegratorsundercontroloftheGrantee.Aslongas3conditionsabovearemet,furthertransmittertestwillnotberequired.However,theOEMintegratorisstillresponsiblefortestingtheirend‐productforanyadditionalcompliancerequirementsrequiredwiththismoduleinstalled(forexample,digitaldeviceemissions,PCperipheralrequirements,etc.).
USERMANUALOFTHEENDPRODUCT:Intheusermanualoftheendproduct,theenduserhastobeinformedthattheequipmentcomplieswithFCCradio‐frequencyexposureguidelinessetforthforanuncontrolledenvironment.Theenduserhastoalsobeinformedthatanychangesormodificationsnotexpresslyapprovedbythemanufacturercouldvoidtheuser'sauthoritytooperatethisequipment.Ifthesizeoftheendproductissmallerthan8x10cm,thenadditionalFCCpart15.19statementisrequiredtobeavailableintheusermanual:ThisdevicecomplieswithPart15ofFCCrules.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmfulinterferenceand(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.LABELOFTHEENDPRODUCT:Thefinalendproductmustbelabeledinavisibleareawiththefollowing"ContainsTXFCCID:2AE8BFZB57A3PF".Ifthesizeoftheendproductislargerthan8x10cm,thenthefollowingFCCpart15.19statementhastoalsobeavailableonthelabel:ThisdevicecomplieswithPart15ofFCCrules.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmfulinterferenceand(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.

Navigation menu