FENERGY TECHNOLOGY AT1204 Wireless Charge Stand User Manual AT Wireless Charge Stand Manual

User Manual

This device complies with part 15 and 18 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

Changes or modifications not exlicitly approved by the party

responsible for compliance could void the user's authority to

operate this equipment.

Note: this equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

·Reorient or relocate the receiving antenna.

·Increase the separation between the equipment and

receiver.

·Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

·Consult the dealer or an experienced radio/TV technician

for help.

The equipment complies with FCC radiation exposure limits

set forth for an uncontrolled environment. During the

operation of device a distance of 15 cm surrounding the

device and 20 cm above the top surface of the device must be

respected.