FENERGY TECHNOLOGY AT1230 Exec Connect User Manual

SHENZHEN FENERGY TECHNOLOGY CO.,LTD Exec Connect

User Manual

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
The equipment complies with FCC radiation exposure limits setforth for an uncontrolled environment.This device has been tested
for human exposure limits and found compliant at a minimum distance of 10cm during operation. Thus during the operation of
device a distance of 10cm must be respected in every direction.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit differ ent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Note: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 and part
18of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged totry to correct the interferen
ce by one or more of the following measures:
FCC Statement
This device complies with part 15 and part18 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this devicemust accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not explicitly approved by the partyresponsible for compliance could void the user's authority tooperate
this equipment.

Navigation menu