Farpointe Data PYRAMID Proximity RFID Reader User Manual Manual

Download:
Mirror Download [FCC.gov]
Document ID	4100707
Application ID	UZAnS3ILltIU++o0gKAM/w==
Document Description	Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	20.8kB (259963 bits)
Date Submitted	2018-12-10 00:00:00
Date Available	2018-12-10 00:00:00
Creation Date	2018-12-07 16:12:45
Producing Software	Adobe PDF Library 15.0
Document Lastmod	2018-12-07 16:12:47
Document Title	Manual
Document Creator	Adobe InDesign CC 13.1 (Macintosh)

QUICK START GUIDE
125-kHz PROXIMITY CARD READERS
This Quick Start Guide is intended for experienced installing technicians. It is a basic reference to ensure all connections are properly made.
Installation and wiring of systems must be in accordance with the National Electrical Code, ANSI/NFPA 70.
1.0 Introduction
A key component of a physical security electronic access control system, a proximity card reader is based on RFID technology. In operation it is
capable of reading data stored on a proximity credential via radio frequency and without physical contact, and then passing the data obtained to
the physical access control system. Access control systems typically manage and record the movement of individuals through a protected area,
such as a locked door.
2.0 Mounting Provisions
Each reader may be installed either indoors or outdoors. Mounting options shown in the table below. Use supplied #6 mounting screws, or
equivalent security screws, for installation. P-400 Series readers are supplied with #6 tamperproof screws. P-900 also comes with #10 screws
for mounting on parking bollards and non-metallic flat surfaces.
Mullion Mount
P-300
P-403
•
•
P-405
P-410
P-453
•
Single-gang Wall Mount*
P-455
P-500
P-530
P-620
•
P-640
P-710
P-900
•
•
•
•
•
•
•
•
•
Double-gang Wall Mount*
Parking Bollard X-Mount*
•
European/Asian Wall Mount*
*Plastic or metal
3.0 Reader Wiring
Conductor
Red
Black
Green
White
Brown
Orange
Yellow
Blue
Violet
Drain
Wiegand
Function
DC (5-16 VDC)
Ground
Data 0
Data 1
Red LEDa
Green LEDb
Card Present
Beeper
fleaPower
Shield Ground
Conductor
Red
Black
Green
White
Brown
Orange
Yellow
Blue
Violet
Drain
Magstripe
Function
DC (5-16 VDC)
Ground
Data
Clock
Red LED
Green LED
Card Present
Beeper
fleaPower
Shield Ground
NOTES:
Single Line LED: This is the standard operating mode and does not
make use of the Orange conductor. The LED is Red when the reader is
idle and flashes when a card is presented. The LED turns Green when
the Brown Conductor is pulled low by the access control panel.
Dual Line LED: This mode makes use of both the Brown and Orange
conductors. The Brown conductor controls the Red LED and the Orange
conductor controls the Green LED. LED states are determined by the
access control system option and capability.
4.0 Cable Requirements
24 AWG minimum, multi-conductor stranded with an overall foil shield, for example Belden 9535 or similar, supporting the five conductors
comprising the physical layer of the Wiegand interface (power, ground, data 0, data 1, and/or beeper and LED). Alternatively, Belden 9539 or
similar, for all reader functions. Contact your access control system manufacturer for their specific requirements. Per the SIA’s Wiegand
specification, maximum cable length is 500 feet (152 m).
5.0 Output Formats
Wiegand (industry standard 26-bit Wiegand and custom Wiegand formats).
6.0 Grounding
Shield (drain) continuity must run from the reader to the access panel. Shield (drain) and reader ground must be tied together at the access panel
and connect to an earth ground at one point.
7.0 Power
Reader may be powered by the access panel. A linear power supply is recommended for best operation.
8.0 Voltage
5 to 16 VDC. 12 VDC at the reader is recommended for best operation.
Model
P-300
Current
Draw
30 - 75
mA
P-403
30 - 75
mA
P-405
30 - 75
mA
P-410
35 - 75
mA
P-453
30 - 75
mA
P-455
30 - 75
mA
P-500
P-530
P-620
35 - 75
mA
30 - 75
mA
70 - 110
mA
P-640
P-710
P-900
70 - 110 215 - 600 290 - 500
mA
mA
mA
QUICK START GUIDE
125-kHz PROXIMITY CARD READERS
9.0 fleaPower™ Control Line
To reduce the average current required by the reader, pull the purple conductor low.
10.0 Connection
Connection must be done in accordance with NFPA 70. Do not connect to a receptacle controlled by a switch. Connect to a power limited DC
voltage source.
11.0 Troubleshooting
1. When the reader is first powered on it will beep 4-times, and the LED will shine red.
2. Presenting a supported access credential will result in the reader beeping and the LED flashing once.
NOTE: The access panel controls LED functionality, such as switching the LED to green.
If the reader does not recognize the card or tag (no beep, no LED flash) or exhibits short read range, please see the table below for possible
causes and solutions.
Possible Cause
Corrective Action
Incorrect cabling
Verify gauge, connections and cabling length
Not enough power
12 VDC recommended, 5 VDC at reader is minimum
Incorrect card used
Verify if card technology is supported
Reader/access panel not properly grounded
Earth ground needed—verify shield and reader ground are tied at access panel and connect
to ground at one point
Supply generating interference
Linear power supply recommended, verify switching power supply before use
Should any of the corrective actions mentioned above not improve performance, disconnect the reader from the access panel and power it with a
separate power supply or 9VDC battery, and re-test card functionality. By powering the readers separately, most variables that may lead to
reduced performance can be eliminated. Should the problem persist, please contact Farpointe directly.
Many Farpointe Data Readers carry the following certifications:
Caution: Changes or modifications not expressly approved by Farpointe Data could
void the user's authority to operate the equipment.
Product can be used without license conditions or restrictions in all European Union
coun-tries, including Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark,
Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania,
Luxem-bourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Spain,
Sweden, United Kingdom, as well as other non-EU countries, including Iceland,
Norway, and Switzerland.
Cet appareil est conforme à Industrie Canada exempts de licence standard RSS (s).
Le fonctionnement est soumis aux deux conditions suivantes : (1) ce dispositif ne
peut pas provoquer d’interférences et (2) ce dispositif doit accepter toute
interférence, y compris les interférences qui peuvent causer un mauvais
fonctionnement du dispositif.
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause unde-sired operation of the device.
Farpointe Data reserves the right to
© 2012-2018 Farpointe Data, Inc. All rights reserved. Farpointe Data®,
change specifications without notice.
Pyramid Series Proximity ®, Delta®, and Ranger ® are the registered U.S.
trademarks of Farpointe Data, Inc. Conekt is a trademark of Farpointe Data,
Inc. All other trademarks are the property of their respective owners.
www.farpointedata.com
Farpointe Data, Inc.
1376 Borregas Avenue
Sunnyvale, CA 94089-1004 USA
Office: +1-408-731-8700
Fax: +1-408-731-8705
support@farpointedata.com
P/N: 01100-001 ∙ Rev. 12.18
FCC Compliance Statement: This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interfer-ence, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.6-c143 79.161424, 2017/09/22-11:52:47
Create Date                     : 2018:12:07 16:12:45-05:00
Metadata Date                   : 2018:12:07 16:12:47-05:00
Modify Date                     : 2018:12:07 16:12:47-05:00
Creator Tool                    : Adobe InDesign CC 13.1 (Macintosh)
Instance ID                     : uuid:8af42f94-da51-ab4e-9742-2f5dfffa95ce
Original Document ID            : xmp.did:9E587CBF27206811B4F2B5FD0894FCA5
Document ID                     : xmp.id:3496b1e5-b3f4-4c3f-b5e0-b58277dadc45
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:fc7d1f60-e4d1-42e4-ac67-2bd627a21f61
Derived From Document ID        : xmp.did:e36ab6f4-c7f6-438a-852b-3f1a595f88cd
Derived From Original Document ID: xmp.did:9E587CBF27206811B4F2B5FD0894FCA5
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 13.1 (Macintosh)
History Changed                 : /
History When                    : 2018:12:07 16:12:46-05:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Slug Family                     : Trade Gothic LT Std
Slug Version                    : 1.029
Slug Outline File Size          : 0
Slug Kerning Checksum           : 0
Slug Foundry                    : Adobe Systems
Slug Font Kind                  : OpenType - PS
Slug Checksum                   : 3312614889
Slug Post Script Name           : TradeGothicLTStd
Slug Font Sense 12 Checksum     : 3312614889
Page Count                      : 2
Creator                         : Adobe InDesign CC 13.1 (Macintosh)

EXIF Metadata provided by EXIF.tools