Fender Passport P10 Users Manual

Passport_P10_manual Fender® Audio Owner's Manuals (Current) – Fender

Passport P10 OM_leg_audio_Passport_P10 Fender® Audio Owner's Manuals (Archive) – Fender

P10 to the manual a00c86df-398a-4e01-95dc-c81528d352a2

: Fender Fender-Passport-P10-Users-Manual-367143 fender-passport-p10-users-manual-367143 fender pdf

Open the PDF directly: View PDF .
Page Count: 5

Download
Open PDF In Browser	View PDF

G u i d e

U s e r s

P10 Personal Portable Sound System

Thank you for selecting the Fender Passport P10 Personal Sound System.
Fender’s Passport brand of products are known for their portability, ease
of use, innovative design, exceptional quality and value. We think you
will find the same qualities in your new P10. Before operating the P10,
please read this instruction manual thoroughly and familiarize yourself
with the features and operation of your new sound system.

Overview of Features

Your P10 was carefully packed at the factory. The carton should contain:
1 - P10 Main unit
1 - AC to DC power adapter
1 - AC cord (appropriate for country where P10 was purchased)
1 - Dynamic cardioid microphone
1 - 3’ coil microphone cable

(4) Power Switch/ Volume Control.
A click-off position is located at the fully counter-clockwise
position. Rotating the control clockwise increases the output
volume.

If any items are missing, please contact the authorized Fender retailer
where you purchased the P10.

(1) Molded Carry Handle
(2) 5” Full-Range Loudspeaker
(3) 1/4” (6.3mm) Input Jack (plug the male-end of the mic cable in
here). This input is a mic level input.

(5) Power Indicator Light (glows red when power is on).
(6) Battery Charge Indicator.
- Red light indicates battery is low and needs charging.
- Green, blinking indicates charging in progress.
- Solid green indicates battery is fully charged.
(7) 1/8” (3.5mm) Auxiliary Input (for connecting CD, Cassette, or
audio line output from another device like a computer sound
card).
(8) DC Power Input Jack (plug in the battery charger here).
(9) Shoulder Strap.
(10) Battery Compartment (shoulder strap can be stored in here).
(11) Mic Stand Adapter.

The P10 is a battery powered personal portable sound system. It is ideal
for any situation where you need to raise the level of your voice (or other
audio source) to effectively communicate with a group of people. The
P10 is perfect for teachers, tour guides, auctioneers, presentations, crowd
control situations, emergency personnel, coaches, zoos, museums... anyone, anywhere.

Operation
Very Important! - Before you use your P10, you must charge the
battery for at least four hours (or until the Battery Charge Indicator
indicates the battery is fully charged)
Using the microphone
- Plug the microphone into the XLR (3 pin) connector of the coiled
microphone cable.
- Plug the 1/4” end of the coiled microphone cable into the 1/4”
Input Jack on the P10 (#3 in drawing).
- Turn the Volume Control (#4) clockwise to turn on the P10, and
adjust to desired volume.
Connecting another audio source to the P10
- The 1/8” Auxiliary input jack (#7) is available to connect a CD or
Cassette player to the P10.
- Connect the device’s audio output to the 1/8” Auxiliary Input on
the P10.
- Turn the Volume Control (#4) clockwise to turn on the P10, and
adjust to desired volume.

Charging the Battery
Very Important! - Before you use your P10, you must charge the battery for at least four hours (or until the Battery Charge Indicator indicates the battery is fully charged). A single four hour charge will power
the P10 for up to eight hours of continuous use.
The P10 has an auto turn-off protection circuit. When the battery charge
is weak, the unit will automatically turn off to prevent damaging the battery. If this happens, turn off the unit and recharge the battery.
AC to DC power adapter
A power adapter is supplied with your P10. This adapter is used to
recharge the battery. It is not designed to power the P10 from an AC
source. Make sure the P10 is turned off when recharging the battery.
The power adapter converts AC power to DC power. The output of the
power adapter is 18V DC. (The inner section of the connector is positive).

Charging the Battery
Plug the barrel end of the cord into the DC power input jack (#) and plug
the AC end into your AC power source.
Charging will begin immediately and the Battery Charge Indicator (#6)
will show a blinking green light.
Battery Charge Indicator.
- Red light indicates battery is low and needs charging.
- Green, blinking indicates charging in progress.
- Solid green indicates battery is fully charged.
If the indicator does not immediately start to blink green, it may be due to
excessive power drain of the battery. This is normal. The indicator should
begin to blink after 10 to 15 minutes. If the battery charge indicator
fails to light, it may be due to a faulty battery.
Replacing, or using a second Battery
With proper care and charging, it is unlikely that it will be necessary to
replace the battery in the P10. If you plan on using the P10 for
extended periods of time, you may want to purchase a second battery.
The battery is a standard 12 volt 2.7 amp gel cell and is available from
Fender directly, or from Authorized Fender Audio dealers. (Part number
005-7535-000).
To replace the battery:
- Open the battery compartment by pressing down on the two tabs at
the top of the battery compartment. The door will hinge down.
- The battery is “spring loaded” behind an interior rear panel. Remove
this panel by sliding it upwards.
- Remove the battery by pulling it out of the compartment. Replace the
battery with another. The terminals on the battery should be on
the “top” as you slide it into the compartment.
- Press the battery into the unit and replace the interior rear panel.
- Close the compartment door. Lift up the two tabs until they “click”
into place.

Tips on correctly using the microphone
Getting good results with a microphone is largely due to proper microphone technique. When speaking, hold the microphone directly in front
of your mouth. Picture yourself eating a lollipop. The lollipop stick is
the “body” of the microphone. This is the proper angle you should be
holding the microphone in relation to your mouth.
The distance the microphone is held away from your mouth is largely
dependent on how loud you speak. It is common for performers or presenters to “eat the mic”. This is term used for someone who keeps the
microphone grill in contact with their lips at all times. You will find that
if you use the microphone this way, you can speak in a normal voice and
be heard clearly. Speaking loudly can cause your voice to distort.
Experiment with what is most comfortable for you. Keep these few
items in mind.
- The closer the mic is to your mouth, the louder you will be.
- The closer the mic is to your mouth, the “fuller” your voice will be
(this is called “proximity effect” where bass frequencies
increase when you move closer to a microphone).
- The closer your mouth is to the microphone, the lower you can set the
overall output. This lessens the opportunity for feedback to
occur (that awful squealing that occurs when a microphone gets
too close to a speaker).

Product Specifications
Model

Passport P10
Euro
Aust
UK

Power Output
Speaker type
Power Supply

Battery
Charging Time
Operating Time
Dimensions (In)
(mm)
Weight

120v part number 069-1110-000
230v part number 069-1110-060
240v part number 069-1110-030
230v part number 069-1110-040
100v part number 069-1110-070
(only difference in product is AC line cord)
27 watts (RMS)
5” full-range, 4 ohm
Intelligent charger 90-260v AC input
18VDC +2.5A output (inner contact is posi
tive)
12v/ 2.7amp hour rechargeable gel cell
4 hours
Up to eight hours talk time
11.2 L x 6.3 W x 7.0 H
285 L x 160 W x 178 H
6.5 lbs. / 2.95 Kgs (with battery)

Replacement parts
Replacement parts are available through your Authorized Fender Audio
dealer, Service Center or from Fender Musical Instruments directly.
Microphone
3’ mic cable (coiled)
Shoulder Strap
Universal Power Adapter
AC Power Cord
120v
230v Euro
230v UK
100v
Rechargeable Battery

069-9000-000
005-7529-000
005-7527-000
005-7530-000
005-7531-000
005-7532-060
005-7533-040
005-7534-070
005-7535-000

Be sure to register your purchase at www.fender.com

A Product of

Fender Musical Instruments Corporation
Corona, CA USA
Crafted in Taiwan

www.fender.com

www.fenderaudio.com
Pt # 005-7536-000



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : Yes
Create Date                     : 2001:04:19 10:16:06
Producer                        : Acrobat Distiller 4.05 for Windows
Modify Date                     : 2001:04:19 10:17:15-07:00
Page Count                      : 5

EXIF Metadata provided by EXIF.tools