Fender Mustang V.2 Effects Loop
User Manual: Fender How can I configure the effects loop on my Fender® Mustang™ III-V (V.2) to match the function the Fender Mustang III-V (V.1)? – Fender
Open the PDF directly: View PDF .
Page Count: 1
USB
Recording
XLR Line
Outputs
Speaker/
Headphones
Guitar
Input
Pre Effects Post Effects
Channel
Volume
Headphones
Detected?
Cab Simulation
for Headphones
Cab Simulation for
Speaker Output
Effects Loop Position: “Looper Pedal”
(Headphones Disconnected)
Effects Loop Position: “Looper Pedal”
(Headphones Connected)
USB Gain
Line Out Boost
Master Volume
Fender® Mustang™ III-V (V.2) Audio Signal Path: Effects Loop Position
Amp Model
Effects Loop Position: “Normal”
Press the Utility button 8 times to access the Fx Loop
Position menu item. “Normal” mode is best for typical
usage: rack mounted delays reverbs, multi-effects,
etc. Not ideal for using a looper pedal because cab
simulation can change when switching presets. A
looper pedal can be used here without problems if
the preset doesn’t change, or if presets are chosen
that have the same cab simulation setting.
Effects Loop Position: “Looper Pedal”
Press the Utility button 8 times to access the Fx Loop
Position menu item. “Looper Pedal” mode is best for usage
with looper pedals and phrase samplers. Looper playback
tonality will not be affected with preset change. Actual
internal insertion point changes based on whether or not the
headphones are inserted. Note that the looper pedal signal
will appear in the Line Outs and USB Recording path only
when the headphones are connected.