Exhibit D Users Manual per 2 1033 b3
SDIO Network Adapter Installation and Operating Instructions
The SDIO part number 710-00020-01 is a device that interfaces a Palm Tungsten
Personal Digital Assistant (PDA) to the FitSense Bodylan RF Network.
Installation of the SDIO card is as follows:
1. Install SDIO Software into the Palm
2. Unpack the SDIO/eSense Hub
3. With the eSense Hub lettering facing toward the front of the PDA, place the SDIO
gold fingers into the SD port of the PDA.
4. Ensure the SDIO is locked into the port
5. Start up the Application
6. Follow the instruction in the Palm Tungsten Manual to reset the device due to any
error conditions that may occur in normal use.
Any changes or modification not expressly approved by the party responsible for
compliance could void the users authority to operate the device.
FCC ID: O9DSD
SDIO Network Adapter
PHT eSense Hub
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this
device must accept any interference received, including
interference that may cause undesired operation.