Fluke 117 Users Manual
2015-09-09
: Fluke Fluke-117-Users-Manual-805621 fluke-117-users-manual-805621 fluke pdf
Open the PDF directly: View PDF 
.
Page Count: 3
Supplement
© 2011-2015 Fluke Corporation.
All rights reserved.
Title: 113 Instruction Sheet Supplement Issue: 5
Part Number: 3083192 Issue Date: 6/15
Print Date: December 2007 Page Count: 2
Revision/Date: 2, 6/11
This supplement contains information necessary to
ensure the accuracy of the above Instruction Sheet.
113 Instruction Sheet Supplement
6/15 1
Change #1, 59513, 63065, 165
In the Symbols Table, add:
Conforms to relevant South Korean EMC Standards
CAT II
Measurement Category II is applicable to test and
measuring circuits connected directly to utilization points
(socket outlets and similar points) of the low-voltage
MAINS installation.
CAT III
Measurement Category III is applicable to test and
measuring circuits connected to the distribution part of
the building’s low-voltage MAINS installation.
CAT IV
Measurement Category IV is applicable to test and
measuring circuits connected at the source of the
building’s low-voltage MAINS installation.
Consult user documentation.
Conforms to relevant Australian EMC standards.
In the Specifications, delete Shock, Safety, EMI
Regulations, and Certifications and add:
IP Rating .................... IEC 60529: IP42
Safety ......................... IEC 61010-1: 600 V CAT IV, Pollution Degree 2
Electromagnetic Compatibility (EMC)
International .............. IEC 61326-1: Portable Electromagnetic
Environment
CISPR 11: Group 1, Class A
Group 1: Equipment has intentionally
generated and/or uses conductively-
Manual Supplement 113 Instruction Sheet
2 6/15
coupled radio frequency energy that is
necessary for the internal function of the
equipment itself.
Class A: Equipment is suitable for use in
all establishments other than domestic
and those directly connected to a low-
voltage power supply network that
supplies buildings used for domestic
purposes. There may be potential
difficulties in ensuring electromagnetic
compatibility in other environments due to
conducted and radiated disturbances.
Emissions that exceed the levels required
by CISPR 11 can occur when the
equipment is connected to a test object.
Korea (KCC) .......... Class A Equipment (Industrial Broadcasting
& Communication Equipment)
Class A: Equipment meets requirements
for industrial electromagnetic wave
equipment and the seller or user should
take notice of it. This equipment is
intended for use in business environments
and not to be used in homes.
USA (FCC) ............ 47 CFR 15 subpart B. This product is
considered an exempt device per clause
15.103.
Change #2, 67402
In the Specifications table, under Function Check, add
footnote [5]:
[5] Minimum measureable input in Chek autorange is 3 V dc. For
measurements below 3 V dc, push Range button twice to get to 6 V dc
manual range.
