Fluke 712B Rtd Users Manual

2015-09-09

• 712B/714B Calibration Manual
  • Warranty
  • Table of Contents
  • List of Tables
  • List of Figures
• Introduction
• Contact Fluke
• Safety Information
• Symbols
• 712B Specifications
  • DC mA Measurement
  • Ohms Measurement
  • Ohms Source
  • RTD Input and Output
  • General Specifications
• 714B Specifications
  • Thermocouple mV Input
  • Thermocouple mV Output
  • Thermocouple mA Input
  • Thermocouple Input and Output
  • General Specifications
• Maintenance
  • Replace the Batteries
  • Clean the Product
• Required Equipment
• 712B Performance Verification
  • Verify Ohms Source
  • Verify 4-Wire Ohms Measure
  • Verify 3-Wire Ohms Measure
  • Verify mA Measure
• 714B Performance Verification
  • Verify mV Source
  • Verify mV Measure
  • Verify TC Measure (Type K)
  • Verify TC K Source
  • Verify mA Measure
• 712B Calibration Adjustment
  • Enter Manual Calibration Mode
  • Adjust Ohms Source
    • Adjust 50 Ω Source
    • Adjust 350 Ω Source
    • Adjust 500 Ω Source
    • Adjust 3500 Ω Source
  • Adjust Trigger Current for Ohms Measure
    • Adjust 0.1 mA Trigger Current
    • Adjust 0.25 mA Trigger Current
    • Adjust 0.5 mA Trigger Current
    • Adjust 1 mA Trigger Current
  • Adjust Ohms Measure
    • Adjust 50 Ω Input
    • Adjust 350 Ω Input
    • Adjust 500 Ω Input
    • Adjust 3500 Ω Input
  • Adjust mA Measure
    • Adjust 0.1 mA Input
    • Adjust 24 mA Input
  • Adjust External Trigger for Ohms Source
    • Adjust 0.1 mA External Trigger
    • Adjust 1 mA External Trigger
  • Save Data and Reset the 712B System
• 714B Calibration Adjustment
  • Enter Calibration Mode
  • Use 8508A to Adjust the 5522A Output
  • Adjust mV Source
  • Adjust mV Measure
  • Adjust Internal Cold Junction Temperature
    • Use the Fluke 9101-256
    • Use a Lag Bath
  • Adjust mA Measure
  • Save Data and Reset the 714B System
• User-Replaceable Parts and Accessories