Fujitsu DP050M33111Z1 Serial interface board User Manual

Download:
Mirror Download [FCC.gov]
Document ID	36479
Application ID	4/cMgxRfYhoSnGQeiGr3Ag==
Document Description	Exhibit E Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	23.74kB (296786 bits)
Date Submitted	1999-05-10 00:00:00
Date Available	1999-06-10 00:00:00
Creation Date	1999-04-27 17:01:05
Producing Software	Acrobat PDFWriter 3.0J Windows
Document Lastmod	1999-04-27 17:04:41
Document Title	Users Manual
Document Creator	橡原稿がｽｷｬﾝされました。
Document Author:	橡三井 泉

Serial Interface Board
Thank you for purchasing the Serial interface Board,
Before use. read the User‘s Manual for installation and printer set up and the Page
Printer Reference Manual for protocols.
The RS-2320/422A serial interface connects through a male 0825 connector.
No special setup is needed to use the R82320 or RS422A except cable connection
including the following signal:
The RS422A interface is effective up to 1200m.
The table below shows the connector pin assignments
Description
Frame Ground
Transmitted Data. This pin carries information from the primer
to the computer.
Received Data, This pin carries mfotmntion from the computer
to the primer.
Received Date A. This pin and R08 (pin 18) carries
inlurmalion irom the cum to the "mar.
Request to Send Enters the space state when the printer is
ready to transmit data.
Clear to sand. Enters the space state when the host is ready to
receive data.
Data Set Ready, Enters the space state to indicate the printer
can receive or transmit data. Connection or me pin is optional.
Signal Ground.
5 (CD) (CD) Carrier Detect Enters the space state to indicate the printer
can receive data.
9 Transmitted Data A. This pin and TDB (pin 10) carries
information from the rinter to the com .
Transnitted Dan 5. This pin and TDA (pin 9) carries
inimmtion from the printer to the wmwr,
Reverse Channel. Available as a printer-ready signal, Not
used in the standam lnlenace,
-’°"
(ROB) RDB In Received Dan E. This pin and RDA (pin 3) carries infon'natlori
from the com ter In the printer.
DTR (DTR) Out Data Terminal Ready. Enters the space state to indicate the
printer is ready to receive or transmit data. Conneuton of this
pin is optional.
Direction "In" denotes a signal irom the computer to the printer. ""0ut denotes a
signal from the printer to the computer.
Federal Commmloations Commission
Radio Frequency Interference Statement
for United States Users
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates. uses and can radiate radio
frequency energy and. if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception‘ which
can be determined by turning the equipment off and on. the user is encouraged to
try to correct the interference by one or more of the following measurements:
— Reon’ent or relocate the receiving antenna
—- increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
— Consult the dealer or an experienced radio I TV technician for help.
FCC WARNING: Changes or modifications not expressly approved by the party
responsible for compliance could V0ld the user‘s authority to operate the
equipment
(This equipment has been tested as CA04339-0801 of the model number‘)
Notice for Canadian Users
This Class B digital apparatus meets all requirements of the Canadian
Interference—Causing Equipment Reguations,
Cet appareil numérique de la Ciasse B respecte toutes les exigenoes 0.1
Réglement sur le materiel broutlleur du Canda,

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : .橡.原稿がｽｷｬﾝされました。
Create Date                     : 1999:04:27 17:01:05
Title                           : .橡.原稿がｽｷｬﾝされました。
Author                          : .橡.三井 泉
Producer                        : Acrobat PDFWriter 3.0J Windows
Modify Date                     : 1999:04:27 17:04:41
Page Count                      : 2

EXIF Metadata provided by EXIF.tools