Futaba PK-PLL75 75MHz Synthesized Module User Manual PK FSM manual
Futaba Corporation 75MHz Synthesized Module PK FSM manual
Futaba >
Contents
- 1. User Manual Part 1
- 2. User Manual Part 2
User Manual Part 2
Futaba PK-FSM 75 Synthesized RF Module Instructions
l To install the PK-FSM 75 into your T3PK, make sure the power switch is in the
“off” position. Next, Plug the PK-FSM 75 in place of the crystal type module. Push it
all the way in until you hear it “Click” to ensure all contacts are in place.
l On the top of the PK-FSM 75,you will find two rotary dials marked X10 and X1.
With the supplied plastic screwdriver, carefully turn the slots in each dial
corresponding to the channel number you wish to transmit on.
l Next, change or select the channel of the receiver to match the channel you have
selected.
l Turn on the transmitter first and then turn on the receiver. ( approx. 1 second later)
To make sure everything is working properly it is advised that you perform a range
test with the transmitter antenna shortest position.
l If you confirmed everything working properly, you could play your r/c model with
the transmitter antenna extended.
l Note: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
l Always use only genuine Futaba receivers.
Futaba will not be responsible for problems caused by the use of other than Futaba
genuine parts. Use the parts specified in the instruction manual and catalog.
l This RF module has been exclusively designed for use in transmitter model T3PK.
Operation in any other transmitter is not authorized and could void the user's
authority to operate the equipment.
Only OEM integrators are authorized to install this RF module.