Download: | |
Mirror Download [FCC.gov] | |
Document ID | 2229272 |
Application ID | tQ1YDR6xaONtt/RmFqv7zQ== |
Document Description | User Manual |
Short Term Confidential | No |
Permanent Confidential | No |
Supercede | No |
Document Type | User Manual |
Display Format | Adobe Acrobat PDF - pdf |
Filesize | 163.19kB (2039913 bits) |
Date Submitted | 2014-03-31 00:00:00 |
Date Available | 2014-04-01 00:00:00 |
Creation Date | 2013-12-10 16:25:56 |
Producing Software | Adobe PDF library 9.90 |
Document Lastmod | 2014-03-17 15:43:33 |
Document Title | Low Energy Bike Cadence Speed Sensor 說明書-1021210_p2 |
Document Creator | Adobe Illustrator CS5 |
ACCESSORIES
1.cadence sensor
2.Speed sensor
3.cadence magnet case
4.EVA sponge for cadence‘z
5.Speed magnet
6.Rubber pad for cadence sensor
7.Rubber pad for speed sensor
s.Battery cover & O-ring
9.CR2032 3V iittiium battery
10.irrever5ibie cabie tie‘S
i Mounl cadencelspeed sensor on left chainstay(non drive sideiand put
rubber pad between sensor and charnstay
2 Make sure the fiat sidetnon battery side) of cadence sensor is facing you.
Upper triangle mark oi cadence sensor is sensing area
Do not taslen cable ties to allow sensor position adjustment
IMPORTANT:
To prevent water from enlenng the cadence sensor, ensure the battery
cover is closed tightly,
MOUNTING CADENCE I SPEED MAGNET
i Mount cadence magnet on lell crank near pedals as strewn Do not lasten
cable ties to allow magnet position adiustment
2 Mount speed magnet on ieil spoke or wheel as shown no not lasten cable
ties to allow magnet positron adiustment.
3 Afler checking the proper distance between magnets and sensors ,lhen
fasten the cable ties tightly.
4 Cut on the surplus part and trim the edge to avoid being injured.
NOTICE:
* Properdistanoe fol cadence sensor and magnet (mount on end of crank )' 10mm
* Proper distance ior speed sensor and magnet (mount on spoke ) 5mm J
CADENCE SENSOR BATTERY INSTALLMENT
install the sensor battery as back side illustrated berore first use and change
battery
Stepi Slide the battery tcnzoaz) at an angle as illustrated and make sure
during battery installation that the battery is first pressed against the
side contact (posnive electrode) and then press into the battery
compartment.
Place the battery rubber pad (O-nitg i ensures water prool protection
ot the battery compartment
step 2 Futon the battery cover and turn right to close it wrtn a coin
(turn lert to open It)
IMPORTANT:
1 Make sure the metal plate is a little stick up. not liat
2 Check tile wirecl installation OI battery side Positive eiectmde (+) facing up
TURN ON CADENCE I SPEED SENSORS
The Eiuetootn SMARI Cadence 1 Speed sensor is compatible with il=none 4s
iPod Touch (5th generation)‘ iFad (3rd and Min generation)
compatible with Android 4.3 or above with Biuetootil SMART suppon
it is also
Please loiiow the ioliowing steps to wirelessiy connect to your ios device,
stepi Go to Device settings. cenerai _ Eluetoolh
Step2 Turn on aiuetooth SMARY. Don't iook tor the sensor to pair automatically
Step3 Select an application For exampie. Wanoo Utility, Cycle , oyciemeier,
MapMleDE+.Strava Cycling nuniastic Road. Bike Pro etc.
s Pick a compatible bike riiness appitcaton tom the “app store“ and download
it to the phone.
Step4 Pail the Bidetooth swar sensor with the bike ritness applications settings,
TROUBLE SHOOTING:
i, No pairing wrth Eiuetooth sMAm
- First turn 0" Eluetooll’i‘ tnen tum on again,
- To iorget or disconnect previous device then connect again.
2, No Cadence] Speed value or “ZERO" Dispiay
- Make sure the Eluetooth system in yoursmartpnone has been turned on
- Recneck tile collect sense distance between sensors and magnets,
3, Avoid using the sensors outside the range or temperature. Beiow we (WFi
wiil cause dispiay siow.
CAUTION:
1 Do not use chemicais to clean the sensors
2 Check sensors and magnets in proper distance periodically.
a The sensor and hardware can be used in the rain, but cannot be used underwater
4 Do not disassemble the sensors.
FCC INFORMATION
This device compIIes wrth Part I5 ot the FCC Rules Operatton IS subrect
to the Ioilowmg (we ccndItIcns:
IVThIs devIce may not cause narmtui Interlerencer and 2. Tnis device must
accept any interlerence recetved, IncIudIng Interference that may cause
undesIred cperatIcn.
NOTE:
ThIs equtpment has been tested and Ieunci to compIy wIth the limits tora CIass a
dtgrtaI device‘ pursuant to part t5 oi the FCC RuIes,
These IirrrIts are designed to provtoe reasonatrIe protectton agatnst harquI
Interference in a resIdentIaI Instaliatton
This eqqument generates uses and can radiate radio frequency energy and, It
not Instailed and used In accordance Witn the Instructtonsrmay cause harmM
Interference to radio commumcations
However, there Is no guarantee that Interference WIII not occur In a partIcuIar
Instaliation,
IIthIs equtpment does cause harmful Interterence to radio orteievrsrert reception
which can be determined by turrttng the equipment on and on the user Is
encouraged to try to correct the Interterence by one or mere at the toIIowtng
measures
- ReorIent or retucate (he receivIng antenna,
- Increase the separattert between the equtprrrent and receiver,
- Connect the eqqument Into an cutie! on a circutt dinerent from that to whtch
the recerer Is connected
- Consuittne deaier or an experIenced radIc/TV tecnnlcian {or heIp.
CAUTION:
Any changes or mudIfIcations not expresst approved by the party
responsIbIe tor oomphance couId void the user's authority to operate
this equipment.
RELEVANT PRODUCTS
«4 ‘7 [fl
uEIuelooth'sum Heait Rate Chest Bell
TECHNICAL I SPECIFICATIONS
tzau hours 13-5 yrs with t hmiay usage)
CR2032 x Ipc (included)
Source Exif Data:
File Type : PDF
File Type Extension : pdf
MIME Type : application/pdf
PDF Version : 1.5
Linearized : No
XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Format : application/pdf
Title : Low Energy Bike Cadence Speed Sensor 說明書-1021210_p2
Metadata Date : 2014:03:17 15:43:33+08:00
Modify Date : 2014:03:17 15:43:33+08:00
Create Date : 2013:12:10 16:25:56+09:00
Creator Tool : Adobe Illustrator CS5
Thumbnail Width : 184
Thumbnail Height : 256
Thumbnail Format : JPEG
Thumbnail Image : (Binary data 7874 bytes, use -b option to extract)
Instance ID : uuid:c3a994ea-fe9b-4b92-ac9c-a713ea72e3b8
Document ID : xmp.did:2C60F0077361E311B423A7C445E23DE5
Original Document ID : uuid:5B20892493BFDB11914A8590D31508C8
Rendition Class : proof:pdf
Derived From Instance ID : xmp.iid:2A60F0077361E311B423A7C445E23DE5
Derived From Document ID : xmp.did:2A60F0077361E311B423A7C445E23DE5
Derived From Original Document ID: uuid:5B20892493BFDB11914A8590D31508C8
Derived From Rendition Class : proof:pdf
History Action : saved, saved
History Instance ID : xmp.iid:2A60F0077361E311B423A7C445E23DE5, xmp.iid:2C60F0077361E311B423A7C445E23DE5
History When : 2013:12:10 16:24:51+08:00, 2013:12:10 16:25:53+08:00
History Software Agent : Adobe Illustrator CS5, Adobe Illustrator CS5
History Changed : /, /
Manifest Link Form : EmbedByReference
Manifest Reference File Path : D:\lin\吉普士\Low Energy Bike Cadence Speed Sensor 說明書(PE-MSBMBLE40010)\JPG\Low Energy Bike Cadence Speed Sensor 說明書-1021210_p2.jpg
Startup Profile : Basic CMYK
Producer : Adobe PDF library 9.90
N Pages : 1
Has Visible Transparency : False
Has Visible Overprint : False
Max Page Size W : 210.001652
Max Page Size H : 297.000132
Max Page Size Unit : Millimeters
Plate Names : Cyan, Magenta, Yellow, Black
Swatch Groups Group Name : 預設色票群組
Swatch Groups Group Type : 0
Page Count : 2
Creator : Adobe Illustrator CS5
EXIF Metadata provided by EXIF.tools