G4S Technology S711 Model S710/711 Contactless Smart Card Reader User Manual User Instructions

G4S Technology Limited Model S710/711 Contactless Smart Card Reader User Instructions

User Instructions

Download: G4S Technology S711 Model S710/711 Contactless Smart Card Reader User Manual User Instructions
Mirror Download [FCC.gov]G4S Technology S711 Model S710/711 Contactless Smart Card Reader User Manual User Instructions
Document ID102684
Application IDDe0TBSCH7zMrmEFwTxXBtw==
Document DescriptionUser Instructions
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize10kB (124978 bits)
Date Submitted2000-06-01 00:00:00
Date Available2000-06-21 00:00:00
Creation Date2000-06-01 09:44:26
Producing SoftwareAcrobat 4.0 Scan Plug-in for Windows
Document Lastmod2000-06-01 09:45:11
Document TitleUser Instructions
Document CreatorAcrobat 4.0 Scan Plug-in for Windows

1 - Fit the Gasket Kit (optional)
The optional two-part gasket kit weatherproofs the reader for outside use. To fit the gaskets:
a) Remove the backplate from
the reader by releasing the two
reader securing screws.
b) Remove the cutouts and / lnncr
backing paper from the two gasket
gaskets, then stick them to the
backplate as shown here:
Reader securing
screws
2 - Fit the Heater Kit (optional)
The optional heater kit maintains the reader at the correct temperature when positioned outside. With
the backplate off, remove the backing paper from the two elements, then stick them to the inner sides
of the reader. The heaters must be connected to a 24V AC supply (min ZSVA).
3 - Mount the Baekplate
You should find that the
With the backplate off (see above). up backplate has suitable
to three cables need to be fed through: holes for connection at
0 The cable from the controller. most standard electrical
backboxes.
cable).
- A cable from a Remote Interface '<
Module (RIM) A RIM can reduce
cable lengths to door furniture. See
the RIM instructions for comrection
details.
0 The heater cable (must be a separate /
You an use any of the
backplate holes when
fixing to a wall.
Mount the backplate adjacent to the
opening edge of the door and at a
convenient height.
4 - Check the Reader Link
LKZ (Test) - Ensure that this link has been removed.
5 - Connect the Reader to the Controller
Controller 12V L +V S710f71 11712
connections OV 8 0V Readerconnections
RX+ j— — “rxo
RX- ' rt Tx-
TX+ RX+
TX- 3— RX-
"— ”misled pairs (use
mfl— Belden 9503 cable).
Connect screen at controller
end only (attach to case).
On completion. re-secure the reader to the hackplnte.
6 - Using the Reader
Present the card face-on to the reader until you hear a "bleep". The typical read range is 10-30 mm.
Note: cards can be presented in rapid succession - there is no need to wait for the UNLOCKED
message to extinguish before presenting another card.
— About the Reader Messages
‘ UNIDCKED When UNLOCKED is displayed, the lock is released and
you may open the door:
ACCESS DENIED These messages are displayed if you do not have access
Gr LOCKED rights to gain entry, or if the reader could not read your card
(in this case, move the card away. then present it again).
ENTER PIN If the ENTER PIN message is displayed, enter your PIN. If
you make a mistake, the message INCORRECT PIN is
momentarily displayed, followed by ENTER PIN. to prompt
you to try again.
a Flashing or These auxiliary indicators can be configured to operate in
® study conjunction with conditional commands.
FCC Notlce:
This device complies with Pan 15 ofllte FCC Rules. Operation is subject to the following two conditions
(1) This device my not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any unauthorised modification to this device may void the authority of the user to operate it.
Copyright 2000. erp ATechnology uh moms instillation ma User lmtruorions for 57“ Readers, Issue 10 19/7/00

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2000:06:01 09:45:11Z
Create Date                     : 2000:06:01 09:44:26Z
Creator                         : Acrobat 4.0 Scan Plug-in for Windows
Producer                        : Acrobat 4.0 Scan Plug-in for Windows
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: OE5S711

Navigation menu