G4S Technology S821 Contactless smart card reader User Manual manual

G4S Technology Limited Contactless smart card reader manual

manual

Installation and User Instructions for S821 Readers1Mount the BackplateTo mount the backplate:1) Detach the main body of the reader from thebackplate by releasing the two securing screwsalong the bottom edge of the reader.2) Mount the backplate adjacent to the opening edgeof the door and at a convenient height. Feed thecable to the reader through the backplate.The backplate has suitable holes for connection to most standard electrical backboxes.The S821 is a contactless smart-card reader, which usesp . TheS821 is able to read Texas Instruments (ISO 15693) andPhilips MIFARE smart cards.For either type of card, the S821 supports the use ofunencoded cards (where only the unique card serialnumber is read). In the case of Texas Instruments (TI)cards, an encoded card number can be read. Encodingformats supported include TI's own formats and the"smartMAX TI" format.The reader can simultaneously support two different cardtypes/formats (e.g. "smartMAX TI" and MIFARE). Thereader is automatically configured to accept the first twocard types/formats presented.TM20mA current loop seudo-random communications®®
9600-0304. Installation and User Instructions for S821Readers, Issue 1.0x8 8th October 2003. AMAG Technology,2003.FCC Notice: This device complies with Part 15 of the FCCRules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) thisdevice must accept any interference received, includinginterference that may cause undesired operation.Any unauthorized modification to this device may void theauthority of the user to operate it.All trademarks acknowledged. Texas Instruments is atrademark of Texas Instruments Incorporated. Philips andMIFARE are registered trademarks of Philips Electronics, NV.©SpecificationsInput voltage: 9-14V.Input current: 110mA @ nominal 12Vdc supply.Operating temperature: -13 to 158 F (-25 to 70 C).Operating humidity: 15 to 90%, non-condensing.Maximum read range: 3" (80mm).Approvals: EN50133, R&TTE, IP656.°°4Using the ReaderPresent the card face-on to the reader until you hear a "bleep". If the green indicator is lit, the cardhas been accepted and the door is unlocked. If the red indicator is lit, either the card has not beenaccepted, or you do not have access through the door. If the read and green indicators flashalternatively, please wait.cards can be presented in rapid succession - there is no need to wait for the green or redLED to extinguish before presenting another card.Note:2Reader Connections20mA Current Loop Reader Connections0VConnect shield atcontroller end only(connect to case)Tx-Tx+Rx-Rx+12VController connections(20mA reader port)RedBlackWhiteBlueGreenOrangeNote: the brownwire is not usedReaderThe reader supports the first two different card types/formats presented after power-up. Forexample, unencoded MIFARE and encoded TI cards (in this example, unencoded TI cards wouldnot be recognized). The reader enters this configuration mode whenever power is re-applied.3Reader Configuration

Navigation menu