GE Power Electronics BLST-SPXXX Electronic Ballast for Fluorescent Lamp User Manual User s Manual

GE Power Electronics (Shanghai) Co., Ltd. Electronic Ballast for Fluorescent Lamp User s Manual

User Manual

Electronic Ballast For Electrodeless Fluorescent Lamp 1．Product code. 80W SP758-Y01A AJA-LINEAGE-WJY-QB7C 100W-120W SP759-Y01A AJA-LINEAGE-WJY-QB7C 2．Outside characteristic. The outside picture of Electronic Ballast For Electrodeless Fluorescent Lamp as below, there are three wires at input port, L line is blue，N line is gray, GND line is yellow and green. There are two white wires at output port. The input wires connect to the power grid, and the output wires connect to the Electrodeless Fluorescent Lamp. Outside picture Inside picture Size：
Size picture 3．Electrical characteristic. 1) Input Voltage 100V-277V 2）Input Rating Current 0.92/0.75/0.40/0.33A @100/120V/230V/277V--electrodeless lamp 80W 1.13/0.94/0.5/0.41A @/100/120V/230V/277V--electrodeless lamp 100W 1.36/1.13/0.59/0.49A @100/120V/230V/277V--electrodeless lamp 120W 3）Output Rating Current 0.63A (load,electrodeless lamp 80W) 0.65A (load,electrodeless lamp 100W) 0.68A (load,electrodeless lamp 120W) 4）Output Rating Voltage 134V (load,electrodeless lamp 80W) 180V (load,electrodeless lamp 100W) 185V (load,electrodeless lamp 120W) 5）Start Trigger Voltage 1500±100Vop (load,electrodeless lamp 80W) 1650±100Vop (load,electrodeless lamp 100W) 1690±100Vop (load,electrodeless lamp 120W) 6）Output Frequency 230K±30kHz(load,electrodeless lamp 80W) 230K±30kHz(load,electrodeless lamp 100W) 230K±30kHz(load,electrodeless lamp 120W) 7）Not load, removing lamp and load short protection 4．Ambient temperature. Generally the ballast is set up in the lamps and lanterns to use, the ambient temperature of ballast is -40--60℃ inininin lamps and lanterns. 5. Those devices have been evaluated to comply with the requirements of FCC Part 18, UL935, CAN/CSA C22.2 No.74-96, IEC61347-1, IEC61347-2-3, EN55015, EN61547, EN61000-3-2, EN61000-3-3, GB19510.1-2004, GB19510.4-2005, GB17743-2007, GB17625.1-2003 and ROHS. Warning: This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45–30 MHz.

Navigation menu